|
|
Sustainable Energy 2025
掺氨对甲醇发动机燃烧性能的仿真模拟
|
Abstract:
氨气是重要的零碳替代能源之一，当前对氨气的研究限于机理和着火性质的探究，缺乏对发动机的应用研究。本文搭建了甲醇发动机模型，并通过缸内压力和放热率验证了模型的准确性。在此基础上引入不同浓度(0%，5%和10%)的氨气分析了缸内压力、放热率、滞燃期、燃烧持续期和缸内温度的变化。研究发现，添加氨气后，缸内压力和放热率增大，滞燃期和燃烧持续期减少，缸内最大温度升高。
Ammonia is one of the important zero-carbon alternative energy sources. The current research on ammonia is limited to the exploration of mechanism and ignition properties, and there is a lack of application research on engines. In this paper, a methanol engine model was built, and the accuracy of the model was verified by the pressure in the cylinder and the heat release rate. On this basis, different concentrations of ammonia (0%, 5% and 10%) were introduced to analyze the changes of cylinder pressure, heat release rate, ignition delay period, combustion duration and temperature in the cylinder. It was found that after adding ammonia gas, the pressure and heat release rate in the cylinder increased, the combustion delay period and combustion duration decreased, and the maximum temperature in the cylinder increased.
| [1] | Bilgin, A. and Sezer, İ. (2008) Effects of Methanol Addition to Gasoline on the Performance and Fuel Cost of a Spark Ignition Engine. Energy & Fuels, 22, 2782-2788. https://doi.org/10.1021/ef8001026 |
| [2] | Zhou, D.Z., Yang, W.M., An, H., Li, J. and Shu, C. (2015) A Numerical Study on RCCI Engine Fueled by Biodiesel/Methanol. Energy Conversion and Management, 89, 798-807. https://doi.org/10.1016/j.enconman.2014.10.054 |
| [3] | 高聪慧, 朱建军, 王晋, 等. 供油提前角对甲醇发动机燃烧过程及排放的影响[J]. 中国农机化学报, 2014, 22(36): 57-60. |
| [4] | Yin, G., Li, J., Zhou, M., Li, J., Wang, C., Hu, E., et al. (2022) Experimental and Kinetic Study on Laminar Flame Speeds of Ammonia/Dimethyl Ether/Air under High Temperature and Elevated Pressure. Combustion and Flame, 238, Article 111915. https://doi.org/10.1016/j.combustflame.2021.111915 |
| [5] | Li, J., Zhao, Z., Kazakov, A., Chaos, M., Dryer, F.L. and Scire, J.J. (2007) A Comprehensive Kinetic Mechanism for CO, CH2O, and CH3OH Combustion. International Journal of Chemical Kinetics, 39, 109-136. https://doi.org/10.1002/kin.20218 |
| [6] | Glarborg, P., Miller, J.A., Ruscic, B. and Klippenstein, S.J. (2018) Modeling Nitrogen Chemistry in Combustion. Progress in Energy and Combustion Science, 67, 31-68. https://doi.org/10.1016/j.pecs.2018.01.002 |
| [7] | Sun, X., Liang, X., Shu, G., Wang, Y., Wang, Y. and Yu, H. (2017) Effect of Different Combustion Models and Alternative Fuels on Two-Stroke Marine Diesel Engine Performance. Applied Thermal Engineering, 115, 597-606. https://doi.org/10.1016/j.applthermaleng.2016.12.093 |
| [8] | Anetor, L., Odetunde, C. and Osakue, E.E. (2014) Computational Analysis of the Extended Zeldovich Mechanism. Arabian Journal for Science and Engineering, 39, 8287-8305. https://doi.org/10.1007/s13369-014-1398-7 |
| [9] | Ibrahim, F., Wan Mahmood, W.M.F., Abdullah, S. and Mansor, M.R.A. (2017) Comparison of Simple and Detailed Soot Models in the Study of Soot Formation in a Compression Ignition Diesel Engine. SAE Technical Paper Series. https://doi.org/10.4271/2017-01-1006 |
| [10] | Yan, X., Mohammadian, A. and Chen, X. (2019) Three-Dimensional Numerical Simulations of Buoyant Jets Discharged from a Rosette-Type Multiport Diffuser. Journal of Marine Science and Engineering, 7, Article 409. https://doi.org/10.3390/jmse7110409 |
| [11] | Shi, X., Qian, W., Wang, Q., Luo, H., Kang, Y. and Ni, J. (2021) Effect of Water Content of Hydrous Ethanol on Chemical Kinetic Characteristics Based on the New Developed Reduced Ethanol-Toluene Reference Fuels Mechanism. Fuel, 303, Article 121201. https://doi.org/10.1016/j.fuel.2021.121201 |
| [12] | Shi, X., Qian, W., Wang, H., Pan, M., Wang, Q. and Ni, J. (2022) Development and Verification of a Reduced Dimethoxymethane/n-Heptane/Toluene Kinetic Mechanism and Modelling for CI Engines. Applied Thermal Engineering, 214, Article 118855. https://doi.org/10.1016/j.applthermaleng.2022.118855 |
| [13] | Lv, D., Chen, Y., Chen, Y., Guo, X., Chen, H. and Huang, H. (2019) Development of a Reduced Diesel/Poden Mechanism for Diesel Engine Application. Energy Conversion and Management, 199, Article 112070. https://doi.org/10.1016/j.enconman.2019.112070 |
