This study investigates the flow and heat transfer of dusty Williamson (MHD) Nanofluid flow over a stretching permeable cylinder in a porous medium. Dusty Williamson Nanofluid was considered due to its thermal properties and potential benefits of increasing the heat transfer rate. Firstly, partial differential equations are transformed into coupled non-linear ordinary differential equations through a similarity variables transformation. The resulting set of dimensionless equations is solved analytically by using the Homogony Perturbation Method (HPM). The effects of the emerging parameters on the velocity and temperature profiles as well as skin-friction coefficient and Nusselt number are publicized through tables and graphs with appropriate discussions. The present result has been compared with published papers and found to be in agreement. To the best of author’s knowledge, there has been sparse research work in the literature that considers the effect of dust with Williamson Nanofluid and also solving the problem analytically. Therefore to the best of author’s knowledge, this is the first time analytical solution has been established for the problem. The results revealed that the fluid velocity of both the fluid and dust phases decreases as the Williamson parameter increases. Motivated by the above limitations and the gaps in past works, therefore, it is hoped that the present work will assist in providing accurate solutions to many practical problems in science, industry and engineering.
References
[1]
Malik, M.Y. and Salahuddin, T. (2015) Numerical Solution of MHD Stagnation Point Flow of Williamson Fluid Model over a Stretching Cylinder. International Journal of Nonlinear Sciences and Numerical Simulation, 16, 161-164. https://doi.org/10.1515/ijnsns-2014-0035
[2]
Amjad, M., Ahmed, I., Ahmed, K., Alqarni, M.S., Akbar, T. and Muhammad, T. (2022) Numerical Solution of Magnetized Williamson Nanofluid Flow over an Exponentially Stretching Permeable Surface with Temperature Dependent Viscosity and Thermal Conductivity. Nanomaterials, 12, Article 3661. https://doi.org/10.3390/nano12203661
[3]
Williamson, R.V. (1929) The Flow of Pseudoplastic Materials. Industrial & Engineering Chemistry, 21, 1108-1111. https://doi.org/10.1021/ie50239a035
[4]
Ramesh, G.K., Gireesha, B.J. and Bagewadi, C.S. (2012) Heat Transfer in MHD Dusty Boundary Layer Flow over an Inclined Stretching Sheet with Non-Uniform Heat Source/Sink. Advances in Mathematical Physics, 2012, Article 657805. https://doi.org/10.1155/2012/657805
[5]
Nadeem, S., Hussain, S.T. and Lee, C. (2013) Flow of a Williamson Fluid over a Stretching Sheet. Brazilian Journal of Chemical Engineering, 30, 619-625. https://doi.org/10.1590/s0104-66322013000300019
[6]
Khan, N.A. and Khan, H. (2014) A Boundary Layer Flows of Non-Newtonian Williamson Fluid. Nonlinear Engineering, 3, 107-115. https://doi.org/10.1515/nleng-2014-0002
[7]
Hussain, F., Hussain, A. and Nadeem, S. (2020) Thermophoresis and Brownian Model of Pseudo-Plastic Nanofluid Flow over a Vertical Slender Cylinder. Mathematical Problems in Engineering, 2020, Article 8428762. https://doi.org/10.1155/2020/8428762
[8]
Bilal, M., Siddique, I., Borawski, A., Raza, A., Nadeem, M. and Sallah, M. (2022) Williamson Magneto Nanofluid Flow over Partially Slip and Convective Cylinder with Thermal Radiation and Variable Conductivity. Scientific Reports, 12, Article No. 12727. https://doi.org/10.1038/s41598-022-16268-2
[9]
Choi, S.U. and Eastman, J.A. (1995) Enhancing Thermal Conductivity of Fluids with Nanoparticles. ASME International Mechanical Engineering Congress & Exposition, San Francisco, 12-17 November 1995, 99-106.
[10]
Bouslimi, J., Omri, M., Mohamed, R.A., Mahmoud, K.H., Abo-Dahab, S.M. and Soliman, M.S. (2021) MHD Williamson Nanofluid Flow over a Stretching Sheet through a Porous Medium under Effects of Joule Heating, Nonlinear Thermal Radiation, Heat Generation/Absorption, and Chemical Reaction. Advances in Mathematical Physics, 2021, Article 9950993. https://doi.org/10.1155/2021/9950993
[11]
Yasmin, A., Ali, K. and Ashraf, M. (2020) Study of Heat and Mass Transfer in MHD Flow of Micropolar Fluid over a Curved Stretching Sheet. Scientific Reports, 10, Article No. 4581. https://doi.org/10.1038/s41598-020-61439-8
[12]
Tiwari, R.K. and Das, M.K. (2007) Heat Transfer Augmentation in a Two-Sided Lid-Driven Differentially Heated Square Cavity Utilizing Nanofluids. International Journal of Heat and Mass Transfer, 50, 2002-2018. https://doi.org/10.1016/j.ijheatmasstransfer.2006.09.034
[13]
Nazir, S., Kashif, M., Zeeshan, A., Alsulami, H. and Ghamkhar, M. (2022) A Study of Heat and Mass Transfer of Non-Newtonian Fluid with Surface Chemical Reaction. Journal of the Indian Chemical Society, 99, Article 100434. https://doi.org/10.1016/j.jics.2022.100434
[14]
Muzara, H. and Shateyi, S. (2023) Magnetohydrodynamics Williamson Nanofluid Flow over an Exponentially Stretching Surface with a Chemical Reaction and Thermal Radiation. Mathematics, 11, Article 2740. https://doi.org/10.3390/math11122740
[15]
Ibrahim, W. and Negera, M. (2020) The Investigation of MHD Williamson Nanofluid over Stretching Cylinder with the Effect of Activation Energy. Advances in Mathematical Physics, 2020, Article 9523630. https://doi.org/10.1155/2020/9523630
[16]
Kumar, K.G., Rudraswamy, N.G., Gireesha, B.J. and Manjunatha, S. (2017) Non Linear Thermal Radiation Effect on Williamson Fluid with Particle-Liquid Suspension Past a Stretching Surface. Results in Physics, 7, 3196-3202. https://doi.org/10.1016/j.rinp.2017.08.027
[17]
Rashid, M., Ansar, K. and Nadeem, S. (2020) Effects of Induced Magnetic Field for Peristaltic Flow of Williamson Fluid in a Curved Channel. Physica A: Statistical Mechanics and Its Applications, 553, Article 123979. https://doi.org/10.1016/j.physa.2019.123979
[18]
Malik, M.Y., Bibi, M., Khan, F. and Salahuddin, T. (2016) Numerical Solution of Williamson Fluid Flow Past a Stretching Cylinder and Heat Transfer with Variable Thermal Conductivity and Heat Generation/absorption. AIP Advances, 6, Article 035101. https://doi.org/10.1063/1.4943398
[19]
Malik, M.Y. and Salahuddin, T. (2015) Numerical Solution of MHD Stagnation Point Flow of Williamson Fluid Model over a Stretching Cylinder. International Journal of Nonlinear Sciences and Numerical Simulation, 16, 161-164. https://doi.org/10.1515/ijnsns-2014-0035
[20]
Umeshaiah, M., Madhukesh, J., Khan, U., Rana, S., Zaib, A., Raizah, Z., et al. (2022) Dusty Nanoliquid Flow through a Stretching Cylinder in a Porous Medium with the Influence of the Melting Effect. Processes, 10, Article 1065. https://doi.org/10.3390/pr10061065
[21]
Kothandapani, M. and Srinivas, S. (2008) On the Influence of Wall Properties in the MHD Peristaltic Transport with Heat Transfer and Porous Medium. Physics Letters A, 372, 4586-4591. https://doi.org/10.1016/j.physleta.2008.04.050
[22]
Gireesha, B.J., Roopa, G.S. and Bagewadi, C.S. (2012) Effect of Viscous Dissipation and Heat Source on Flow and Heat Transfer of Dusty Fluid over Unsteady Stretching Sheet. Applied Mathematics and Mechanics, 33, 1001-1014. https://doi.org/10.1007/s10483-012-1601-9
[23]
Alfvén, H. (1942) Existence of Electromagnetic-Hydrodynamic Waves. Nature, 150, 405-406. https://doi.org/10.1038/150405d0
[24]
Wakif, A., Boulahia, Z., Amine, A., Animasaun, I.L., Afridi, M.I., Qasimd, M., et al. (2018) Magneto-Convection of Alumina-Water Nanofluid within Thin Horizontal Layers Using the Revised Generalized Buongiorno’s Model. Frontiers in Heat and Mass Transfer, 12, 1-15. https://doi.org/10.5098/hmt.12.3
[25]
Manjunatha, P.T., Gireesha, B.J. and Prasannakumara, B.C. (2014) Thermal Analysis of Conducting Dusty Fluid Flow in a Porous Medium over a Stretching Cylinder in the Presence of Non-Uniform Source/Sink. International Journal of Mechanical and Materials Engineering, 9, Article No. 13. https://doi.org/10.1186/s40712-014-0013-8
[26]
Chen, C. (2009) Magneto-Hydrodynamic Mixed Convection of a Power-Law Fluid Past a Stretching Surface in the Presence of Thermal Radiation and Internal Heat Generation/Absorption. International Journal of Non-Linear Mechanics, 44, 596-603. https://doi.org/10.1016/j.ijnonlinmec.2009.02.004
