In order to clarify the danger of water breakout in the bottom plate of extra-thick coal seam mining, 2202 working face of a mine in the west is taken as the research object, and it is proposed to use the on-site monitoring means combining borehole peeping and microseismic monitoring, combined with the theoretical analysis to analyze the danger of water breakout in the bottom plate. The results show that: 1) the theoretically calculated maximum damage depth of the bottom plate is 27.5 m, and its layer is located above the Austrian ash aquifer, which has the danger of water breakout; 2) the drill hole peeping at the bottom plate of the working face shows that the depth of the bottom plate fissure development reaches 26 m, and the integrity of the water barrier layer has been damaged, so there is the risk of water breakout; 3) for the microseismic monitoring of the anomalous area, the bottom plate of the return air downstream channel occurs in the field with a one-week lag, which shows that microseismic monitoring events may reflect the water breakout of the underground. This shows that the microseismic monitoring events can reflect the changes of the underground flow field, which can provide a reference basis for the early warning of water breakout. The research results can provide reference for the prediction of sudden water hazard.
References
[1]
Chai, J., Qiao, Y., Gao, S. G. et al. (2022). Roof Stability Evaluation of Large Section Open-Off Cut in Lower Slice of Slicing Mining. Journal of Mine Automation,48, 21-31.
[2]
Dai, C. (2019). Research on Deformation and Failure Characteristics of Narrow Coal Pillar Mining Roadway in Hengsheng Coal Mine and the Support Optimization Technology. Coal Engineering, 51, 70-73.
[3]
Dai, G. L., Wu, P. N., Niu, C. et al. (2023). Weighted Rank Sum Ratio Method Was Applied to Evaluate Water Inrush Risk of Floor. Coal Technology, 42, 109-113.
[4]
Fan, Z. H. (2021). Prediction of Water Inrush from Floor of Working Face. Coal Technology, 40, 142-144.
[5]
Guo, G. Q. (2022). Floor Failure Law of Extra-Thick Coal Seam in Fully Mechanized Caving Mining. Coal Geology & Exploration,50, 107-115.
[6]
Jin, D. W., Liu, J., Xu, F. et al. (2021). Method of Determining of Pre-Drainage Standard in Water-Decrease Mining of Shallow Seam in Yushen Mining Area. Journal of China Coal Society, 46, 220-229
[7]
Li, A., Mou, Q., Liu, C. Y. et al. (2020). Study on the Damage Depth of Bottom Plate Disturbance under the Influence of Multiple Factors in the North Wei Coal Field. Coal Engineering, 52, 138-143.
[8]
Liu, R. R., Liu, Y., Fang, G. et al. (2022). Law of Overburden Failure and Roof Water Damage in Yuandatan. Coal Mine. Safety in Coal Mines, 53, 82-91.
[9]
Qiu, X. G., & Li, N. (2022). Prediction Model of Water Inrush from Coal Floor Based on CNNGCN-BiLST. Coal Technology, 41, 84-87.
[10]
Shi, X. C., & Lyu, G. L. (2023). Risk Assessment of Water Inrush from over Burden High-Level Bed Separation in Extra-Thick Coal Seam Mining. Safety and Environmental Engineering, 30, 109-117.
[11]
Wang, J., Li, B. F., Jiang, Q. P. et al. (2022). Identification of Damage Depth Caused by Long-Wall Mining Using Microseismic Technique. Journal of Mining and Strata Control Engineering,4, Article ID: 053512.
[12]
Wang, S. S., Dai, G. L., & Niu, C. (2023). Study on Water Inrush Risk of Coal Seam Floor Based on Combination Weighting Method. China Energy and Environmental Protection, 45, 98-104 110.
[13]
Xie, H. P., Wu, L. X., & Zheng, D. Z. (2019). Prediction on the Energy Consumption and Coal Demand of China in 2025.Journal of China Coal Society,44, 1949-1960.
[14]
Xiong, X. B., Xie, X. G., Yang, P. J. et al. (2023). Research on Water Inrush Risk of Mine Floor Based on PCA-Logistic Regression Model. Safety in Coal Mines, 54,176-181.
[15]
Xu, Y. Y., & Wang, L. (2023). Prevention and Control Technology and Application of Hidden Danger of Coal Spontaneous Combustion in Top Slicing Fully Mechanized Caving Working Face in Thick Coal Seam. Coal Technology, 42, 160-164.
[16]
Yin, S. X., Lian, H. C., Xu, B. et al. (2021). Deep Strip Mining: Heritage and Innovation. Coalfield Geology and Exploration, 49, 170-181.
[17]
Yu, B., Kuang, T. J., Yang, J. X. et al. (2023). Analysis of Overburden Structure and Evolution Characteristics of Hard Roof Mining in Extremely Thick Coal Seam. Coal Science and Technology,51, 95-104.
[18]
Yuan, L. (2018). Strategies of High Efficiency Recovery and Energy Saving for Coal Resources in China. Journal of China University of Mining &.Technology(Social Sciences), No. 1, 3-12.
[19]
Zhang, C. B., & Zhang, P. (2023). Mine Floor Water Inrush Prediction Model and Application Based on AHP Vulnerable Index Method. Safety in Coal Mines, 54, 172-179.
[20]
Zhang, H., Yang, Y. K., & Wang, C. L. (2022). Research on Mining Technology of Interlaced Distribution of Coal Seam Group Pedal Empty Three Coal Seam. Coal Technology, 41, 53-57.
[21]
Zhang, J. C., & Liu, T. Q. (1990). On the Depth and Distribution Characteristics of Mining Fissure Zones in Coal Seams. Journal of China Coal Society, No. 2, 46-55.
[22]
Zhao, B., Wang, Y. et al. (2023). Mechanism and Prevention and Control Technology of Mine Earthquake in Fully Mechanized Top Coal Caving Face in Extra Thick Seam: Taking Longwanggou Coal Mine as an Example. Science Technology and Engineering, 23, 12451-12457.
