全部 标题 作者
关键词 摘要

OALib Journal期刊
ISSN: 2333-9721
费用:99美元

查看量下载量

相关文章

更多...

积碳清洗剂对汽车动力性能提升的试验研究
Experimental Study on the Improvement of Automobile Power Performance by Carbon Deposit Cleaning Agents

DOI: 10.12677/ojtt.2024.132013, PP. 101-107

Keywords: 积碳清洗剂,汽车动力性,底盘测功机
Carbon Deposit Cleaning Agents
, Automobile Power Performance, Chassis Dynamometer

Full-Text   Cite this paper   Add to My Lib

Abstract:

发动机积碳增多将使燃烧性变差、汽车动力性下降。受燃油品质、驾驶条件、日常维护、环境与交通等因素影响,积碳随着使用时间而逐渐增加,因此降低积碳对汽车性能提升有较大意义。基于CDS-150型底盘测功机,对一台一汽威志在用汽车使用一种免拆式积碳清洗剂前后的动力性能进行测试。结果表明,积碳清洗前后最高车速分别为144.7 km/h、148.9 km/h,最高车速提升2.9%;积碳清洗前后0~100 km/h (百公里)加速时间分别为13.3 s、14.1 s,缩短0.8 s;积碳清洗前后最大爬坡度分别为65%、69%,增幅达6.2%,测试的积碳清洗剂对发动机的动力性提升明显。
The increase of engine carbon deposition will lead to a decrease in combustion performance and a decrease in vehicle power. Due to factors such as such as fuel quality, driving conditions, daily maintenance, environment and traffic, carbon deposition gradually increases over time. Therefore, reducing carbon deposition is of great significance to the improvement of vehicle performance. Based on CDS-150 chassis dynamometer, the power performance of a FAW Weizhi in-service car before and after using a non-disassembly carbon deposition cleaning agent was tested. The results show that the maximum speed before and after carbon deposition cleaning is 144.7 km/h and 148.9 km/h respectively, with a 2.9% increase in maximum speed. The acceleration time from 0 to 100 km/h (100 km) before and after carbon deposition cleaning is 13.3 s and 14.1 s respectively, which is shortened by 0.8 seconds. The maximum climbing slopes before and after carbon deposition cleaning is 65% and 69%, respectively, with an increase of 6.2%. The tested carbon deposition cleaning agents have obviously improved the engine’s power performance.

References

[1]  袁杰, 周云龙. 积碳对发动机性能的影响及处理分析[J]. 现代工业经济和信息化, 2020, 10(8): 84-86.
[2]  黄艳松. 航空发动机涡轮工作叶片表面积碳去除工艺[J]. 机械工程师, 2020(6): 125-127.
[3]  江伟, 夏兵. 积碳对燃油发动机性能影响分析[J]. 长春工业大学学报, 2020, 41(2): 180-187.
[4]  陈常青. 影响汽车性能的驾驶方式分析[J]. 湖北农机化, 2019(13): 30.
[5]  李金畅, 阳林, 钟兴华, 等. 发动机积碳分析及处理方法[J]. 汽车零部件, 2019(2): 60-62.
[6]  潘文磊. 氢氧除碳的机理及实验研究[D]: [硕士学位论文]. 哈尔滨: 哈尔滨工业大学, 2014.
[7]  王学鹏. 气道喷射式汽油机进气门积碳机理实验研究及其预防[D]: [硕士学位论文]. 广州: 华南理工大学, 2018.
[8]  徐林. 航空发动机叶片表层除碳技术的研究[J]. 科技创新与应用, 2020(36): 83-84.
[9]  李义才. 发动机再制造中铝合金活塞表面积碳清洗工艺的研究[D]: [硕士学位论文]. 西安: 长安大学, 2020.
[10]  霍金禄, 李晓华, 张铎, 等. 汽油添加剂对发动机燃烧和排放特性的影响[J]. 能源环境保护, 2023, 37(2): 178-186.
[11]  肖雪萍, 韩云利. 某型发动机高压涡轮叶片进排气边积炭去除工艺研究[J]. 航空维修与工程, 2018(8): 57-59.
[12]  朱明宇. 退役车用发动机缸体再制造工艺与关键设备研究[D]: [硕士学位论文]. 上海: 上海交通大学, 2011.
[13]  张琦, 潘玉, 赵鑫. 工况驾驶规范性及客观评价指标相关性的试验研究[J]. 汽车工程学报, 2023, 13(4): 548-555.
[14]  刘斌, 卢志美, 丁雨青, 等. 基于快速积碳的汽油清净增效剂评价方法研究[J]. 小型内燃机与车辆技术, 2022, 51(2): 45-49.

Full-Text

Contact Us

service@oalib.com

QQ:3279437679

WhatsApp +8615387084133