Concrete is the most widely used construction
material in the world. The situation in the country is not an exception as most
of the infrastructures in Kenya such as
buildings, bridges, concrete drainage among others, are constructed using
concrete. Sadly, the failure of buildings and other concrete structures is very common in Kenya. Blended Portland
cement type 32.5N/mm2is the most widely used concrete binder material and is
found in all parts of the country. Despite blended cement CEM 32.5 being the
most commonly used cement type in construction industry in Kenya and most developing
countries as a result of its low price and availability locally, its strength
gain has been proven to be lower compared to when other types of cement are
used due to quantity of pozzolanic material added to the blend. This paper
outlines findings of an experimental investigation on the use of cypress tree
extract as an accelerator to enhance rate of gain of strength on Kenyan blended
cements. Six different blended cement brands locally available were used during
the study. Cement chemical analysis was done using X-ray diffraction method
while for the cypress extract, Atomic Absorption Spectrometer machine was used.
Physical and mechanical properties were checked based on the British standards.
The generation of the concrete mix design was done using the British DOE method
and concrete was tested for the compressive strength at 7, 14, 21, 28, 56 and
90 days. It was observed that 15% dosage of the extract expressed as a mass
percentage of the cement content gives the most improved compressive strength
of concrete, 10.4% at 7 days and 9.5% at 28 days hence the
References
[1]
Kioko, J.M. (2014) Causes of Building Failures in Africa: A Case Study on Collapsing Structures in Kenya. IOSR Journal of Mechanical and Civil Engineering, 11, 9-10. https://doi.org/10.9790/1684-11370910
[2]
Adewuyi, A.P., Olaniyi, O.A., Ibrahim, K.A. and Babalola, D.D. (2017) Physical Properties and Compressive Strength of Concrete Exposed to Progressive Heat. Journal of Multidisciplinary Engineering Science Studies, 3, 2084-2090.
[3]
Oyawa, W.O., Gathimba, N.K. and Manguriu, G.N. (2016) Structural Response of Composite Concrete Filled Plastic Tubes in Compression. Steel and Composite Structures, 21, 589-604. https://doi.org/10.12989/scs.2016.21.3.589
[4]
Okumu, V.A., Shitote, S.M. and Oyawa, W.O. (2017) Influence of Constituent Materials Properties on the Compressive Strength of in Situ Concrete in Kenya. Open Journal of Civil Engineering, 7, 63-81. https://doi.org/10.4236/ojce.2017.71004
[5]
Adewole, K.K., Olutoge, F.A. and Habib, H. (2014) Effect of Nigerian Portland-Limestone Cement Grades on Concrete Compressive Strength. International Journal of Civil and Environmental Engineering, 8, 1199-1202.
[6]
Feng, Y., Zhang, Q., Chen, Q., Wang, D., Guo, H., Liu, L. and Yang, Q. (2019) Hydration and Strength Development in Blended Cement with Ultrafine Granulated Copper Slag. PLOS ONE, 14, e0215677. https://doi.org/10.1371/journal.pone.0215677
[7]
Okumu, V.A. (2018) Suitability of the Kenyan Blended Portland Cements for Structural Concrete Production. Journal of Sustainable Research in Engineering, 4, 55-68.
[8]
Fapohunda, C.A., Famodimu, B.I., Adigo, B.C. and Jeje, A.S. (2020) Effect of Changing Cement Grade on the Properties of Structural Concrete. Nigerian Journal of Technological Development, 17, 197-204. https://doi.org/10.4314/njtd.v17i3.6
[9]
Olonade, K.A., Jaji, M.B., Rasak, S.A. and Ojo, B. (2015) Comparative Quality Evaluation of Cement Brands Used in South-West Nigeria. Academy Journal of Science and Engineering, 9, 53-63.
[10]
Hiremath, P.N. (2019) Early-Strength Development of Blended Concrete under Different Curing Conditions. Emerging Materials Research, 9, 59-64. https://doi.org/10.1680/jemmr.19.00066
[11]
Bamigboye, G.O., Ede, A.N., Egwuatu, C., Jolayemi, J. and Olowu, O. (2015) Assessment of Compressive Strength of Concrete Produced from Different Brands of Portland Cement. Civil and Environmental Research, 7, 31-39.
[12]
Okumu, V.A., Oyawa, W.O. and Shitote, S.M. (2016) The Effect of the Properties of Constituent Materials on the Quality of Concrete in Kenya. Proceedings of the 2016 Annual Conference on Sustainable Research and Innovation, Nairobi, 4-6 May 2016, 225-230.
[13]
Koteng, D.O. (2013) Concrete Use for Sustainable Development Concrete Use for Sustainable Development. The 20th Engineers’ International Institution of Engineers Conference, Kisumu, 8-10 May 2013, 1-19.
[14]
Woldemariam, A.M., Oyawa, W.O. and Abuodha, S.O. (2014) International and Technology, Cypress Tree Extract as an Eco-Friendly Admixture in Concrete. International Journal of Civil Engineering and Technology (IJCIET), 5, 25-36.
[15]
Kumbhar, P.D. and Murnal, P.B. (2012) Assessment of Suitability of Existing Mix Design Methods of Normal Concrete for Designing High Performance Concrete. International Journal of Civil and Structural Engineering, 3, 158-167.
[16]
Kenya Bureau of Standards (2000) EAS 148-2: 2000 ICS 91.100.10. East African, Standards. Cements-Test Methods. Part 2. Chemical Analysis. Kenya Bureau of Standards, Nairobi.
[17]
Elmer, P. (1996) Atomic Absorption Spectroscopy: Analytical Methods. The Perkin. Elmer Corporation, Waltham.
[18]
Malagavelli, V. and Paturu, N.R. (2012) Strength and Workability Characteristics of Concrete by Using Different Super Plasticizers. International Journal of Materials Engineering, 2, 7-11. https://doi.org/10.5923/j.ijme.20120201.02
[19]
Puertas, F., Santos, H., Palacios, M. and Martínez-Ramírez, S. (2005) Polycarboxylate Superplasticiser Admixtures: Effect on Hydration, Microstructure and Rheological Behavior in Cement Pastes. Advances in Cement Research, 17, 77-89. https://doi.org/10.1680/adcr.17.2.77.65044
[20]
Lee, T., et al. (2020) Effects of Accelerators and Retarders in Early Strength Development of Concrete Based on Low-Temperature-Cured Ordinary Portland and Calcium Sulfoaluminate Cement Blends. Materials, 13, Article No. 1505.