Population growth combined with the rising standard of living of people around the world is the reason for the ever-increasing production of waste which management is costing states a lot of money for its disposal. Among available waste treatment techniques, landfill is one of the most promoted waste management techniques with the emergence of the bioreactor concept. However, the control of biodegradation parameters in order to accelerate waste stabilization is an important issue. For environmental and economic reasons, the technique of leachate recirculation by injection into the waste is increasingly used to improve the degradation of landfilled waste. The injection of leachate is possible using vertical boreholes, horizontal pipes, infiltration ponds or a combination of these. Indeed, moisture is the main factor in waste degradation and biogas production. The migration of leachate to the bottom of the landfill creates low moisture in the upper areas of the landfill reducing the growth of microbial populations. This results in low or no biogas production. The main objective of the present work is to develop a numerical model of leachate recirculation by injection into the waste to rewet the waste and restart biological activity. The analysis of the results shows that the diffusion of the wet front increases with time and depth. The lateral widening of the wet front is slow in relation to the progression of the wet front towards the bottom of the waste cell. This indicates the predominance of gravity effects over diffusion phenomena. The results reveal that the distributed re-injection is the best mode of leachate recirculation because the moisture distribution on the whole waste mass is totally satisfactory and the biogas generation is more important. Leachate recirculation campaigns should be done periodically to rewet the waste, boost microbial activity and hope for a quicker stabilization of the landfill.
References
[1]
Farquhar, G.J. and Rovers, F.A. (1973) Gas Production during Refuse Decomposition. Water, Air, and Soil Pollution, 2, 483-495. https://doi.org/10.1007/BF00585092
[2]
Kumar, S., Chiemchaisri, C. and Mudhoo, A. (2011) Bioreactor Landfill Technology in Municipal Solid Waste Treatment: An Overview. Critical Reviews in Biotechnology, 31, 77-97. https://doi.org/10.3109/07388551.2010.492206
[3]
Sohoo, I., Ritzkowski, M. and Kuchta, K. (2021) Influence of Moisture Content and Leachate Recirculation on Oxygen Consumption and Waste Stabilization in Post Aeration Phase of Landfill Operation. Science of the Total Environment, 773, Article ID: 145584. https://doi.org/10.1016/j.scitotenv.2021.145584
[4]
Palmisano, A.C. and Barlaz, M.A. (1996) Microbiology of Solid Waste. Vol. 3, CRC Press, Boca Raton.
[5]
Buivid, M.G., Wise, D.L., Blanchet, M.J., Remedios, E.C., Jenkins, B.M., Boyd, W.F. and Pacey, J.G. (1981) Fuel Gas Enhancement by Controlled Landfilling of Municipal Solid Waste. Resources and Conservation, 6, 3-20. https://doi.org/10.1016/0166-3097(81)90003-1
[6]
Noble, J.J. and Arnold, A.E. (1991) Experimental and Mathematical Modeling of Moisture Transport in Landfills. Chemical Engineering Communications, 100, 95-111. https://doi.org/10.1080/00986449108911594
[7]
Aran, C. (2001) Modelling of Fluid Flows and Heat Transfer in Household in Household Waste. Application to the Reinjection of Leachate into a Landfill Storage Facility. PhD Thesis, Institut National Polytechnique de Toulouse, Toulouse. (In French)
[8]
Suflita, J.M., Gerba, C.P., Ham, R.K., Palmisano, A.C., Rathje, W.L. and Robinson, J.A. (1992) The World’s Largest Landfill. Environmental Science & Technology, 26, 1486-1495. https://doi.org/10.1021/es00032a002
[9]
Jokela, J.P.Y., Kettunen, R.H., Marttinen, S.K. and Rintala, J.A. (1999) Influence of Waste Moisture on Methane Production and Leachate Characteristics. Sardinia 99, Proceedings of the 9th International Landfill Symposium, Italy, 1999, 67-74.
[10]
Arigala, S.G., Tsotsis, T.T., Webster, I.A. and Yortsos, Y.C. (1995) Gas Generation, Transport, and Extraction in Landfills. Journal of Environmental Engineering, 121, 33-44. https://doi.org/10.1061/(ASCE)0733-9372(1995)121:1(33)
[11]
Findikakis, A.N. and Leckie, J.O. (1979) Numerical Simulation of Gas Flow in Sanitary Landfills. Journal of the Environmental Engineering Division, 105, 927-945. https://doi.org/10.1061/JEEGAV.0000959
[12]
El-Fadel, M., Findikakis, A.N. and Leckie, J.O. (1996) Numerical Modelling of Generation and Transport of Gas and Heat in Landfills I. Model Formulation. Waste Management & Research, 14, 483-504. https://doi.org/10.1177/0734242X9601400506
[13]
Meraz, R.L. (1997) Controlled Landfill and Biogas Production: Experimental and Modelling Study on an Industrial Site and on a Pilot Scale. PhD Thesis, INPT, Toulouse. (In French)
[14]
Aoukou, K.D.D., N’wuitcha, K., Palm, K., Banna, M. and Zeghmati, B. (2022) Modeling of Heat Transfers in Bioreactive Household Waste Storage. Journal of Sustainable Bioenergy Systems, 12, 37-56. https://doi.org/10.4236/jsbs.2022.123004
[15]
Kumar, A., Reinhart, D. and Townsend, T. (2008) Temperature inside the Landfill. Effects of Liquid Injection. Global Waste Management Symposium. Copper CO USA.
[16]
Eliassen, R. (1942) Decomposition of Landfills. American Journal of Public Health and the Nations Health, 32, 1029-1037. https://doi.org/10.2105/AJPH.32.9.1029
[17]
Rees, J.F. (1980) Optimisation of Methane Production and Refuse Decomposition in Landfills by Temperature Control. Journal of Chemical Technology and Biotechnology, 30, 458-465. https://doi.org/10.1002/jctb.503300158
[18]
Townsend, T.G., Miller, W.L., Lee, H.J. and Earle, J.F.K. (1996) Acceleration of Landfill Stabilization Using Leachate Recycle. Journal of Environmental Engineering, 122, 263-268. https://doi.org/10.1061/(ASCE)0733-9372(1996)122:4(263)
[19]
Gurijala, K.R. and Suflita, J.M. (1993) Environmental Factors Influencing Methanogenesis from Refuse in Landfill Samples. Environmental Science & Technology, 27, 1176-1181. https://doi.org/10.1021/es00043a018
[20]
McCreanor, P.T. and Reinhart, D.R. (2000) Mathematical Modeling of Leachate Routing in a Leachate Recirculating Landfill. Water Research, 34, 1285-1295. https://doi.org/10.1016/S0043-1354(99)00243-2
[21]
Robinson, H.D. and Maris, P.J. (1985) The Treatment of Leachates from Domestic Waste in Landfill Sites. Journal of Water Pollution Control Federation, 57, 30-38.
[22]
Lema, J.M., Mendez, R. and Blazquez, R. (1988) Characteristics of Landfill Leachates and Alternatives for Their Treatment: A Review. Water, Air, and Soil Pollution, 40, 223-250. https://doi.org/10.1007/BF00163730
[23]
Chen, Z., Guanren, H. and Yuanle, M. (2006) Computational Methods for Multiphase Flows in Porous Media. Society for Industrial and Applied Mathematics, Philadelphia.
[24]
Versteeg, H.K. and Malalasekera, W. (2007) An Introduction to Computational Fluid Dynamics: The Finite Volume Method. 2nd Edition, Pearson Education Ltd., Harlow.
[25]
Gholamifard, S., Eymard, R. and Duquennoi, C. (2008) Modeling Anaerobic Bioreactor Landfills in Methanogenic Phase: Long-Term and Short-Term Behaviors. Water Research, 42, 5061-5071. https://doi.org/10.1016/j.watres.2008.09.040
[26]
Chenu, D., Quintard, M., Crausse, P. and Aran, C. (2005) Modeling Reactive Transport within Landfill Bioreactors. In: Alshawabkeh, A., et al., Eds., Waste Containment and Remediation, American Society of Civil Engineers, Reston, 1-12. https://doi.org/10.1061/40789(168)53
[27]
Klink, R.E. and Ham, R.K. (1982) Effects of Moisture Movement on Methane Production in Solid Waste Landfill Samples. Resources and Conservation, 8, 29-41. https://doi.org/10.1016/0166-3097(82)90051-7
[28]
Benbelkacem, H., Bayard, R., Abdelhay, A., Zhang, Y. and Gourdon, R. (2020) Effect of Leachate Injection Modes on Municipal Solid Waste Degradation in Anaerobic Bioreactor. Bioresource Technology, 101, 5206-5212. https://doi.org/10.1016/j.biortech.2010.02.049
[29]
Lucia, U. and Grisolia, G. (2019) Exergy Inefficiency: An Indicator for Sustainable Development Analysis. Energy Reports, 5, 62-69. https://doi.org/10.1016/j.egyr.2018.12.001
