Surface plasmon resonance (SPR) sensors have grown in popularity owing to their sensitivity, precision, and capacity for a variety of applications, including detection, monitoring, and sensing, among others. Sensitivity and resolution are two areas where this technology has room for development. A plasmonic biosensor based on an asymmetric slotted PCF structure with extremely high sensitivity has been described and theoretically investigated. This high performance sensor is constructed and completely characterized using finite element method in COMSOL Multiphysics software environment. Sensitivity and resolution are analyzed as performance parameters for the proposed sensor. Numerical simulation exhibits the maximum wavelength-sensitivity of 1100 nm/RIU with 9.09 × 10-6 RIU resolution in the broad measurement range of refractive index from 1.30 to 1.44. A polarization controller can be used to fine-tune this extremely sensitive and wide-ranging refractive index sensor to fulfil a variety of practical needs. This is performed with the consideration of the variation in the refractive index (RI) of the analyte channels. In comparison with earlier PCF-based sensors, the fiber design structure is basic, symmetrical, simple to produce, and cost-effective. Because of the asymmetric air holes and higher sensitivities of the refractive index detector, it is possible to identify biomolecules, biochemicals and other analytes.
Gauvreau, B., Hassani, A., Fehri, M.F., Kabashin, A. and Skorobogatiy, M. (2007) Photonic Bandgap Fiber-Based Surface Plasmon Resonance Sensors. Optics Express, 15, 11413-11426. https://doi.org/10.1364/OE.15.011413
[3]
Ahmed, T., Paul, A.K., Anower, M.S. and Razzak, S.A. (2019) Surface Plasmon Resonance Biosensor Based on Hexagonal Lattice Dual-Core Photonic Crystal Fiber. Applied Optics, 58, 8416-8422. https://doi.org/10.1364/AO.58.008416
[4]
Kretschmann, E. and Raether, H. (1968) Radiative Decay of Non Radiative Surface Plasmons Excited by Light. Zeitschrift Für Naturforschung A, 23, 2135-2136. https://doi.org/10.1515/zna-1968-1247
[5]
Piliarik, M., Homola, J., Manıková, Z. and Čtyroky, J. (2003) Surface Plasmon Resonance Sensor Based on a Single-Mode Polarization-Maintaining Optical Fiber. Sensors and Actuators B: Chemical, 90, 236-242. https://doi.org/10.1016/S0925-4005(03)00034-0
[6]
Monzón-Hernández, D., Villatoro, J., Talavera, D. and Luna-Moreno, D. (2004) Optical-Fiber Surface-Plasmon Resonance Sensor with Multiple Resonance Peaks. Applied Optics, 43, 1216-1220. https://doi.org/10.1364/AO.43.001216
[7]
Gupta, B.D. and Sharma, A.K. (2005) Sensitivity Evaluation of a Multi-Layered Surface Plasmon Resonance-Based Fiber Optic Sensor: A Theoretical Study. Sensors and Actuators B: Chemical, 107, 40-46. https://doi.org/10.1016/j.snb.2004.08.030
[8]
Khaleque, A., Mironov, E.G., Osório, J.H., Li, Z., Cordeiro, C.M., Liu, L., et al. (2017) Integration of Bow-Tie Plasmonic Nano-Antennas on Tapered Fibers. Optics Express, 25, 8986-8996. https://doi.org/10.1364/OE.25.008986
[9]
Orf, N.D., Shapira, O., Sorin, F., Danto, S., Baldo, M.A., Joannopoulos, J.D. and Fink, Y. (2011) Fiber Draw Synthesis. Proceedings of the National Academy of Sciences of the United States of America, 108, 4743-4747. https://doi.org/10.1073/pnas.1101160108
[10]
Rifat, A.A., Ahmed, R., Mahdiraji, G.A. and Adikan, F.M. (2017) Highly Sensitive D-Shaped Photonic Crystal Fiber-Based Plasmonic Biosensor in Visible to Near-IR. IEEE Sensors Journal, 17, 2776-2783. https://doi.org/10.1109/JSEN.2017.2677473
[11]
Tian, M., Lu, P., Chen, L., Lv, C. and Liu, D.M. (2012) All-Solid D-Shaped Photonic Fiber Sensor Based on Surface Plasmon Resonance. Optics Communications, 285, 1550-1554. https://doi.org/10.1016/j.optcom.2011.11.104
[12]
Dash, J.N. and Jha, R. (2015) On the Performance of Graphene-Based D-Shaped Photonic Crystal Fibre Biosensor Using Surface Plasmon Resonance. Plasmonics, 10, 1123-1131. https://doi.org/10.1007/s11468-015-9912-7
[13]
Paul, A.K., Sarkar, A.K. and Khaleque, A. (2019) Dual-Core Photonic Crystal Fiber Plasmonic Refractive Index Sensor: A Numerical Analysis. Photonic Sensors, 9, 151-161. https://doi.org/10.1007/s13320-018-0524-7
[14]
Islam, M.S., Sultana, J., Rifat, A.A., Dinovitser, A., Ng, B.W.H. and Abbott, D. (2018) Terahertz Sensing in a Hollow Core Photonic Crystal Fiber. IEEE Sensors Journal, 18, 4073-4080. https://doi.org/10.1109/JSEN.2018.2819165
[15]
Luan, N., Wang, R., Lv, W. and Yao, J. (2015) Surface Plasmon Resonance Sensor Based on D-Shaped Microstructured Optical Fiber with Hollow Core. Optics Express, 23, 8576-8582. https://doi.org/10.1364/OE.23.008576
[16]
Chen, Y., Xie, Q., Li, X., Zhou, H., Hong, X. and Geng, Y. (2016) Experimental Realization of D-Shaped Photonic Crystal Fiber SPR Sensor. Journal of Physics D: Applied Physics, 50, Article ID: 025101. https://doi.org/10.1088/1361-6463/50/2/025101
[17]
Wong, W.C., Chan, C.C., Boo, J.L., Teo, Z.Y., Tou, Z.Q., Yang, H.B., et al. (2013) Photonic Crystal Fiber Surface Plasmon Resonance Biosensor Based on Protein G Immobilization. IEEE Journal of Selected Topics in Quantum Electronics, 19, Article No. 4602107. https://doi.org/10.1109/JSTQE.2013.2244560
[18]
Wang, Y., Huang, Q., Zhu, W., Yang, M. and Lewis, E. (2018) Novel Optical Fiber SPR Temperature Sensor Based on MMF-PCF-MMF Structure and Gold-PDMS Film. Optics Express, 26, 1910-1917. https://doi.org/10.1364/OE.26.001910
[19]
Sharma, P. and Sharan, P. (2014) Design of Photonic Crystal-Based Biosensor for Detection of Glucose Concentration in Urine. IEEE Sensors Journal, 15, 1035-1042. https://doi.org/10.1109/JSEN.2014.2359799
[20]
Atakaramians, S. (2011) Terahertz Waveguides: A Study of Microwires and Porous Fibres. Doctoral Dissertation, University of Adelaide, Adelaide. https://hdl.handle.net/2440/69317
[21]
Sarker, H., Faisal, M. and Mollah, M.A. (2021) Slotted Photonic Crystal Fiber-Based Plasmonic Biosensor. Applied Optics, 60, 358-366. https://doi.org/10.1364/AO.412951
[22]
Rahman, M., Rana, M., Anower, M.S., Rahman, M.S., Paul, A.K. (2020) Design and Analysis of Photonic Crystal Fiber-Based Plasmonic Microbiosensor: An External Sensing Scheme. SN Applied Sciences, 2, Article No. 1194. https://doi.org/10.1007/s42452-020-2998-3
[23]
Anower, M.S., Rahman, M.S. and Rikta, K.A. (2018) Performance Enhancement of Graphene-Coated Surface Plasmon Resonance Biosensor Using Tungsten Disulfide. Optical Engineering, 57, Article ID: 017114. https://doi.org/10.1117/1.OE.57.1.017114
[24]
Rahman, M.S., Anower, M.S., Hasan, M., Rikta, K.A. (2017) Sensitivity Enhancement of MoS2-Graphene Hybrid Structure Based Surface Plasmon Resonance Biosensor Using Air Gap. Sensor Letters, 15, 510-516. https://doi.org/10.1166/sl.2017.3842
