Optimization of Injection-Molding Process Parameters for Weight Control: Converting Optimization Problem to Classification Problem

Product weight is one of the most important properties for an injection-molded part. The determination of process parameters for obtaining an accurate weight is therefore essential. This study proposed a new optimization strategy for the injection-molding process in which the parameter optimization problem is converted to a weight classification problem. Injection-molded parts are produced under varying parameters and labeled as positive or negative compared with the standard weight, and the weight error of each sample is calculated. A support vector classifier (SVC) method is applied to construct a classification hyperplane in which the weight error is supposed to be zero. A particle swarm optimization (PSO) algorithm contributes to the tuning of the hyperparameters of the SVC model in order to minimize the error between the SVC prediction results and the experimental results. The proposed method is verified to be highly accurate, and its average weight error is 0.0212%. This method only requires a small amount of experiment samples and thus can reduce cost and time. This method has the potential to be widely promoted in the optimization of injection-molding process parameters