Investigation on performance characteristics and metallographic transformation on drilling aluminium/titanium sandwich

Materials sandwiches of aluminium/titanium are widely used in structural aerospace, especially in the surface coating and skeletons of aircrafts. Due to their inhomogeneous behavior and poor machinability, drilling aluminium/titanium sandwich in one-shot operation has brought great challenges to the modern manufacturing community. In this paper, a series of experiments were conducted to understand and characterize the process of drilling aluminium/titanium sandwich. Experimental results have shown that the serrated chip is not common in drilling. Only the outer edge of the spiral chip has saw teeth because of the variable cutting speed along the cutting edge. In addition, a better understanding of the phase transformation on surface and subsurface of drilled hole has been provided. Two kinds of phase transformations on the surface of drilled hole have been observed: one is the allotropic transformation from α to β phase and the other is that from β to minor phases α′ (hexagonal martensites). All these are mainly due to the interaction of mechanical force and high temperature