Comparisons of the use of twist, pilot

Understanding the drilling-induced damage to carbon fiber-reinforced polymer composites remains the most active research being undertaken in the composite materials world of today. Despite the vast amounts of literature available, the relationship between drilling and damage to the composites has not been fully understood. In this research, a comparative study of different drilling methods including the use of a twist drill, the use of a pilot hole/pre-drilled hole and the use of a step drill on the influence of the hole quality has been accomplished. In order to achieve this comparison, thrust forces have been monitored during drilling experiments where four different feed rates and one spindle speed have been considered. A finite element model has also been included to study delamination damage on the laminates and validate the experimental results. Results show that thrust forces increase with increasing feed rates and that drilling by step drill is the most appropriate method as it records low forces hence minimal delamination damage