|
|
- 2019
有机蒙脱土/聚氨酯弹性体复合材料的微观形貌及力学性能
|
Abstract:
以十八烷基三甲基氯化铵（OTAC）为改性剂，通过离子交换法改性钠基蒙脱土（MMT）制得有机蒙脱土（OMMT）；以聚丙二醇（PPG）和4，4'-二苯基甲烷二异氰酸酯（MDI）为单体，1，4-丁二醇（BDO）为扩链剂，合成聚氨酯弹性体（PUE）基体；并采用预聚体法制备了OMMT/PUE复合材料。FTIR和XRD测试结果表明：OMMT在2 921 cm-1和1 469 cm-1处出现-CH2吸收峰，表明OTAC分子链成功插入到OMMT片层，由OMMT的耐热性推算OTAC的插层量为24%，且OMMT的层间距较MMT增加了0.7 nm。OMMT/PUE复合材料的SEM和XRD结果显示：适量的OMMT在PUE基体中均匀分散，且以完全剥离的形式存在，其主要原因是：一方面由于OTAC分子与PUE软链间存在较强的作用，另一方面OMMT表面活性基团与基体间也存在一定的界面作用，两种作用均有利于提高OMMT/PUE复合材料的力学性能。力学性能测试结果表明：当OMMT的含量为3wt%时，OMMT/PUE复合材料的拉伸强度、扯断伸长率及断裂拉伸强度比PUE分别提高了37%、28%和34%，力学性能得到明显改善。 Sodium montmorillonite (MMT) was modified by octadecyl trimethyl ammonium chloride (OTAC) via cation exchange and organic montmorillonite (OMMT) was got. Polyurethane elastomer (PUE) was synthesized taking 4,4'-diphenylmethane diisocyanate (MDI) and polypropylene glycol (PPG) as the raw materials and 1,4-butanediol (BDO) as chain extender, and then OMMT/PUE composite was prepared by the prepolymer method. The results of FTIR and XRD show that the characteristic peaks of -CH2(2 921 cm-1 and 1 469 cm-1) appear and indicate that the new groups have been introduced into the layers of OMMT, the intercalation quantity of OTAC is about 24% by the heat resistance of MMT and OMMT, and the interlayer spacing of OMMT is 0.7 nm larger than that of MMT. The analytical results of SEM and XRD of OMMT/PUE composites reveal that proper OMMT disperses evenly in the PUE matrix, and OMMT is peeled completely. This phenomenon can be explained by two main reasons, i.e. one is the strong interaction between OTAC molecular and soft segments of PUE, and the other is the interface interaction amid the active groups of OMMT and PUE matrix. The test results of mechanical properties of OMMT/PUE composites display that the maximum tensile strength, elongation at break and breaking tensile strength of OMMT/PUE composite are 37%, 28% and 34% higher than that of PUE matrix, respectively, when the content of OMMT is 3wt%, and the mechanical properties of OMMT/PUE composites are significantly improved. 国家自然科学基金（21604019）；哈尔滨创新人才专项（2015RAXXJ029
| [1] | 谢友利, 张猛, 周永红. 蒙脱土的有机改性研究进展[J]. 化工进展, 2012, 31(4):844-851. XIE Y L, ZHANG M, ZHOU Y H. Progress in organic modification of montmorillonite[J]. Chemical Industry and Engineering Progress, 2012, 31(4):844-851(in Chinese). |
| [2] | BERTA M, SAIANI A, LINDSAY C, et al. Effect of clay dispersion on the rheological properties and flammability of polyurethane-clay nanocomposite elastomers[J]. Journal of Applied Polymer Science, 2009, 112(5):2847-2853. |
| [3] | CAI Y B, HU Y, SONG L, et al. Synthesis and characterization of thermoplastic polyurethane/montmorillonite nanocomposites produced by reactive extrusion[J]. Journal of Materials Science, 2007, 42(14):5785-5790. |
| [4] | HEIDARIAN M, SHISHESAZ M R. Study on effect of duration of the ultrasonication process on solvent-free polyurethane/organoclay nanocomposite coatings:Structural characteristics and barrier performance analysis[J]. Journal of Applied Polymer Science, 2012, 126(6):2035-2048. |
| [5] | GAO Y, WANG X P, LIU M J, et al. Effect of montmorillonite on carboxylated styrene butadiene rubber/hindered phenol damping material with improved extraction resistance[J]. Materials and Design, 2014, 58:316-323. |
| [6] | LEE D, CHAR K. Effect of acidity on the deintercalation of organically modified layered silicates[J]. Langmuir, 2002, 18(16):6445-6448. |
| [7] | GAURAV V, ANUPAMA K, ANUP K G. Preparation, characterization and properties of organoclay reinforced polyurethane nanocomposite coatings[J]. Journal of Plastic Film and Sheeting, 2012, 29(1):56-77. |
| [8] | 罗明艳, 蒋玉湘, 李子健, 等. 富羟基蒙脱土/聚氨酯脲纳米复合材料的结构及性能研究[J]. 橡胶工业, 2017, 64(5):285-289. LUO M Y, JIANG Y X, LI Z J, et al. Study on preparation and properties of hydroxy-rich montmorillonite/polyurethane urea nanocomposite[J]. China Rubber Industry, 2017, 64(5):285-289(in Chinese). |
| [9] | 张希旺. OMMT改性聚氨酯的制备及性能研究[D]. 哈尔滨:哈尔滨理工大学, 2015. ZHANG X W. Study on preparation and properties of polyurethane modified by OMMT[D]. Harbin:Harbin University Science and Technology, 2015(in Chinese). |
| [10] | REHAB A, AKELAH A, AGAG T, et al. Polyurethane-nanocomposite materials via in situ polymerization into organoclay interlayers[J]. Polymers for Advanced Technologies, 2007, 18(6):463-471. |
| [11] | ZHENG J R, OZISIK R, SIEGEL R W. Phase separation and mechanical responses of polyurethane nano-composites[J]. Polymer, 2006, 47(22):7786-7794. |
| [12] | 张清宇. SCE-Al2O3/PU复合材料制备及性能研究[D]. 哈尔滨:哈尔滨理工大学, 2016. ZHANG Q Y. Study on preparation and properties of SCE-Al2O3/PU composites[D]. Harbin:Harbin University Science and Technology, 2016(in Chinese). |
| [13] | TAHERI S, SADEGHI G M M. Microstructure property relationships of organo-montmorillonite/polyurethane nanocomposites:Influence of hard segment content[J]. Applied Clay Science, 2015, 114:430-439. |
| [14] | GRIGORIADI K, GIANNAKAS A, BARKOULA N M. Thermomechanical behavior of polymer/layered silicate clay nanocomposites based on unmodified low density polyethylene[J]. Polymer Engineering & Science, 2013, 53(2):301-308. |
| [15] | 陈宇飞, 楚洪月, 王波涛. 改性蒙脱土/双马来酰亚胺复合材料微观形貌及力学性能[J]. 复合材料学报, 2018, 35(6):1407-1413. CHEN Y F, CHU H Y, WANG B T. Micro-morphology and mechanical properties of modified MMT/MBAE composite[J]. Acta Materiae Compositae Sinica, 2018, 35(6):1407-1413(in Chinese). |
| [16] | ADAK B, JOSHI M, BUTOLA B S. Polyurethane/clay nanocomposites with improved helium gas barrier and mechanical properties:Direct versus master-batch melt mixing route[J]. Journal of Applied Polymer Science, 2018, 135(27):46422. |
| [17] | ZHOU J T, YAO Z J, ZHOU C, et al. Mechanical properties of PLA/PBS foamed composites reinforced by organophilic montmorillonite[J]. Journal of Applied Polymer Science, 2014, 131(18):40773. |
| [18] | 中国国家标准化管理委员会. 硫化橡胶或热塑性橡胶拉伸应力应变性能的测定:GB/T 528-1998[S]. 北京:中国标准出版社, 1998. Standardization Administration of the People's Republic of China. Rubber, vulcanized or thermoplastic determination of tensile stress-strain properties:GB/T 528-1998[S]. Beijing:China Standards Press, 1998(in Chinese). |
| [19] | RATH S K, SUDARSHAN K, BHAVSAR R S, et al. Characterizing the nanoclay induced constrained amorphous region in model segmented polyurethane-urea/clay nanocomposites and its implications on gas barrier properties[J]. Physical Chemistry Chemical Physics, 2016, 18(3):1487-1499. |
| [20] | 刘厚钧. 聚氨酯弹性体手册[M]. 北京:化学工业出版社, 2015. LIU H J. Polyurethane elastomer manual[M]. Beijing:Chemical Industry Press, 2015(in Chinese). |
| [21] | XIAO D L, ZHAO X Y, FENG Y P, et al. The structure and danamic properties of thermoplastic polyurethane elastomer/hindered phenol hybrids[J]. Journal of Applied Polymer Science, 2010, 116(4):2143-2150. |
| [22] | 孙宝全, 史振涛, 李金艳, 等. 聚氨酯/有机蒙脱土纳米复合材料的结构与性能[J]. 合成橡胶工业, 2008, 31(2):148-151. SUN B Q, SHI Z T, LI J Y, et al. The structure and properties of polyurethane/organo-montmorillonite nanocomposites[J]. China Synthetic Rubber Industry, 2008, 31(2):148-151(in Chinese). |
| [23] | 李在辉, 胡源, 王鑫. 膨胀型性阻燃聚氨酯弹性体/蒙脱土复合材料的制备与性能研究[J]. 聚氨酯, 2011(5):72-74. LI Z H, HU Y, WANG X. Preparation and properties of expansive flame retardant polyurethane elastomer/montmorillonite composites[J]. Polyurethane, 2011(5):72-74(in Chinese). |
| [24] | PENG S, IROH J O. Synthesis and characterization of crosslinked polyurethane/clay nanocomposites[J]. Journal of Applied Polymer Science, 2016, 133(17):43346. |
| [25] | BARICK A, TRIPATHY D K. Preparation and characterization of thermoplastic polyurethane/organoclay nanocomposites by melt intercalation technique:Effect of nanoclay on morphology, mechanical, thermal, and rheological properties[J]. Journal of Applied Polymer Science, 2010, 117(2):639-654. |
