Extraction of Copper and Zinc from Waste Printed Circuit Boards

The recovery of valuable metals from waste printed circuit boards (WPCBs) is crucial in order to harness their economic resources, and prevents potential environmental contamination. However, selective extraction of Cu and Zn, and the co-extraction of other metals as impurities at ambient temperature using selected lixiviants such as HCl, H 2SO 4, HNO 3, trifluoromethanesulfonic acid (TFMS), NaOH, and mixtures of NaCl and CuCl 2 was studied. It is shown that the extraction efficiencies of all the metals increased with increases in lixiviant concentrations. High selectivity of Cu and Zn toward Fe were achieved in dilute H 2SO 4, HNO 3, TFMS, and 0.5 M NaCl + 0.1 M CuCl 2, and low dissolution of Pb (<5%) was observed in all H 2SO 4 lixiviants. Almost 100% Zn extraction using NaOH lixiviants without trace of other metals was achieved. Therefore, 0.5 M NaCl + 0.5 M CuCl 2, 1.0 M HNO 3, 0.5 M H 2SO 4, and 1.0 M TFMS showed high extraction selectivity toward Cu and Zn with low chemical consumption, and produced pregnant leach solution rich in Cu and Zn, as well as residue containing Fe, Ni, and other metals. View Full-Tex