|
|
- 2017
变轴压比预制高强混凝土混合配筋管柱抗震性能研究
|
Abstract:
通过对3根预制高强混凝土混合配筋管柱试件在不同轴压比下的拟静力试验, 研究了轴压比对其抗震性能的影响．其中管柱试件中预应力钢棒和HRB400级钢筋各配置6根, 两者间隔布置．详细记录试件的破坏过程, 得到试件的滞回曲线、骨架曲线、承载力、变形能力、承载力退化曲线和耗能能力等．试验结果表明：各试件均为受弯破坏, 延性系数为2.50～2.93, 极限位移角为1/33～1/27; 配置预应力筋的混合配筋管柱试件残余位移较小, 自复位能力较强; 轴压比是影响试件延性和耗能能力的重要因素, 随着轴压比增大, 试件延性降低, 耗能能力减弱．
Quasi-static tests were conducted on three specimens to study the influence of axial-compression ratio on the seismic behavior of prefabricated pipe columns with high-strength concrete，which were reinforced with six prestressed steel bars and six 400 MPa grade steel bars. The failure process of specimens was recorded in detail，and several indexes such as the hysteretic curve，skeleton curve，bearing capacity，deformation capacity，stiffness degradation and energy dissipation capacity of specimens were obtained. The test results indicated that all the specimens fail in flexural mode. The ductility coefficient of the specimens is 2.50―2.93，and the ultimate drift ratio is 1/33―1/27. Pipe columns with mixed reinforcement have smaller residual displacement and better performance of automatic resilience. Axial-compression ratio is an important factor affecting the ductility and energy dissipation capacity of pipe columns. The ductility is reduced and the energy dissipation capacity is decreased with the increase of axial-compression ratio
| [1] | 周毅雷, 陈忠范, 张建中. 环形截面大偏心受压构件截面延性系数计算[J]. 特种结构, 2002, 19(2):32-35. |
| [2] | Tong Yuesheng, Tong Yanhua, Tong Runjia. Calculation of eccentric compression R. C. members with ring section[J]. <i>Building Structure</i>, 1997, 27(3):14-17(in Chinese). |
| [3] | 霍锦锋, 刘西拉. 钢筋混凝土环形截面构件破坏的统一表达[J]. 上海交通大学学报, 2005, 39(11):1866-1869. |
| [4] | Huo Jinfeng, Liu Xila. The general failure expression on reinforced concrete members with annular section[J]. <i>Journal of Shanghai Jiaotong University</i>, 2005, 39(11):1866-1869(in Chinese). |
| [5] | 李增志. 预制混凝土管柱结构研究[D]. 天津:天津大学建筑工程学院, 2012. |
| [6] | GB 50011―2010 Code for Seismic Design of Building Structures[S]. Beijing:China Architecture and Building Press, 2010(in Chinese). |
| [7] | 聂建国, 卜凡民, 樊健生. 低剪跨比双钢板-混凝土组合剪力墙抗震性能试验研究[J]. 建筑结构学报, 2011, 32(11):74-81. |
| [8] | Nie Jianguo, Bu Fanmin, Fan Jiansheng. Experimental research on seismic behavior of low shear-span ratio composite shear wall with double steel plates and infill concrete[J]. <i>Journal of Building Structures</i>, 2011, 32(11):74-81(in Chinese). |
| [9] | Li Zengzhi. Precast Concrete Pipe Column Structure Research[D]. Tianjin:School of Civil Engineering, Tianjin University, 2012(in Chinese). |
| [10] | Zhou Yilei, Chen Zhongfan, Zhang Jianzhong. The calculation of ductility coefficient about eccentric call loaded reinforced concrete column of ring section[J] <i>Special Structures</i>, 2002, 19(2):32-35(in Chinese). |
| [11] | 童岳生, 童燕华, 童润家. 钢筋混凝土环形截面偏压构件计算[J]. 建筑结构, 1997, 27(3):14-17. |
| [12] | Tayem A, Najmi A. Design of round reinforced-concrete columns[J]. <i>Engineering Structures</i>, 1996, 122(9):1062-1071. |
| [13] | Zhu Lihua, Bai Guoliang, Li Xiaowen, et al. Experimental study on seismic behavior of reinforced concrete pipe columns with a large cross section size and thinned wall[J]. <i>Engineering Mechanics</i>, 2009, 26(3):134-139(in Chinese). |
| [14] | Zhang Xizhi, Han Peng, Li Yilong, et al. Seismic behavior of prefabricated alveolar type RC shear walls with cast-in-place embedded columns[J]. <i>Journal of Building Structures</i>, 2014, 35(8):88-94(in Chinese). |
| [15] | Clark J L, Birjandi F K. The behavior of reinforced concrete circular section in shear[J]. <i>The Structural Engineer</i>, 1993, 71(5):73-78. |
| [16] | Wong Y L, Paulay T, Priestley M J N. Response of circular reinforced concrete columns to multi-directional seismic attack[J]. <i>ACI Structure Journal</i>, 1993, 90 (2):180-191. |
| [17] | 吕志涛, 石平府, 周燕勤. 圆形、环形截面钢筋混凝土构件抗剪承载力的试验研究[J]. 建筑结构学报, 1995, 16(3):13-20. |
| [18] | Lü Zhitao, Shi Pingfu, Zhou Yanqin. Experimental study of shear bearing capacity of reinforced concrete members with a circular cross section[J]. <i>Journal of Building Structure</i>, 1995, 16(3):13-20(in Chinese). |
| [19] | 朱丽华, 白国良, 李晓文, 等. 大尺寸薄壁钢筋混凝土管柱抗震性能试验研究[J]. 工程力学, 2009, 26(3):134-139. |
| [20] | GB 50011―2010 建筑抗震设计规范[S]. 北京:中国建筑工业出版社, 2010. |
| [21] | 张锡治, 韩鹏, 李义龙, 等. 带现浇暗柱齿槽式预制钢筋混凝土剪力墙抗震性能试验[J]. 建筑结构学报, 2014, 35(8):88-94. |
