全部 标题 作者
关键词 摘要

OALib Journal期刊
ISSN: 2333-9721
费用:99美元

查看量下载量

相关文章

更多...
-  2018 

穿孔管消声器声学特性预测的单向耦合计算方法
One-Way Coupling Method for Acoustic Performance Predictions of Perforated Tube Silencers

DOI: 10.11784/tdxbz201706040

Keywords: 穿孔管消声器,单向耦合,有限元法,低马赫数,非均匀流
perforated tube silencer
,one-way coupling,finite element method,low Mach number,non-uniform flow

Full-Text   Cite this paper   Add to My Lib

Abstract:

基于流场与声场之间的单向耦合方法, 研究了低马赫数非均匀流对穿孔管消声器声学特性的影响.首先使用CFD方法获取速度场分布, 然后通过声学有限元计算得到声压场分布, 最后利用基于非线性最小二乘法的曲线拟合进行平面波分解计算得到消声器的传递损失.对于直通和横流穿孔管消声器, 传递损失数值计算结果和实验测量结果吻合良好.计算结果表明, 在入口马赫数低于0.2的条件下, 气流对于直通穿孔管消声器在平面波范围内的声学性能影响较小, 而在高频范围内气流的影响作用应当引起重视; 横流穿孔管消声器的声学性能对于气流速度的变化更加敏感.
Based on the one-way coupling method between flow field and acoustic field,the influence of low Mach number non-uniform flow on the acoustic performance of perforated tube silencers was investigated. The flow velocity field distribution was first obtained by using CFD,and then the sound pressure field distribution was determined from the acoustics finite element computation. Finally,a nonlinear least-square curve-fitting algorithm was used to decompose the plane sound wave for the evaluation of silencer’s transmission loss. For the straight-through and cross-flow perforated tube silencers,the good agreements between the numerical predictions and experimental measurements were observed. As the inlet Mach number is less than 0.2,the numerical results demonstrate that the influence of air flow on the acoustic performance is marginal in the plane wave dominated frequency range and is noticeable at higher frequencies for the straight-through perforated tube silencer,while the acoustic performance of cross-flow perforated tube silencer is more sensitive to the change of air flow

References

[1]  Xu Beibei, Ji Zhenlin. Finite element method for prediction of acoustic characteristics of silencers with three-dimensional potential flow[J]. <i>Chinese Internal Combustion Engine Engineering</i>, 2010, 31(5):97-102(in Chinese).
[2]  Broatch A, Margot X, Gil A, et al. A CFD approach to the computation of the acoustic response of exhaust mufflers[J]. <i>Journal of Computational Acoustics</i>, 2011, 13(2):301-316.
[3]  Ji Z L, Xu H S, Kang Z X. Influence of mean flow on acoustic attenuation performance of straight-through perforated tube reactive silencers and resonators[J]. <i>Noise Control Engineering Journal</i>, 2010, 58(1):12-17.
[4]  徐贝贝, 季振林. 有三维势流时消声器声学特性预测的有限元法[J]. 内燃机工程, 2010, 31(5):97-102.
[5]  石岩, 舒歌群, 毕凤荣, 等. 基于计算流体动力学的内燃机排气消声器声学特性仿真[J]. 振动工程学报, 2011, 24(2):205-209.
[6]  Shi Yan, Shu Gequn, Bi Fengrong, et al. Acoustic characteristics simulation of engine exhaust muffler based on CFD[J]. <i>Journal of Vibration Engineering</i>, 2011, 24(2):205-209(in Chinese).
[7]  Liu Chen, Ji Zhenlin, Xu Hangshou. Three-dimensional time-domain computation and analysis of acoustic attenuation performance of perforated tube silencers[J]. <i>Journal of Mechanical Engineering</i>, 2012, 48(10):7-13(in Chinese).
[8]  Rienstra S, Eversman W. A numerical comparison between multiple-scales and FEM solution for sound propagation in lined flow ducts[J]. <i>Journal of Fluid Mechanics</i>, 2001, 437:367-384.
[9]  Redon E, Dhia B B, Mercier J F, et al. Non-reflecting boundary conditions for acoustic propagation in ducts with acoustic treatment and mean flow[J]. <i>International Journal for Numerical Methods in Engineering</i>, 2011, 86:1360-1378.
[10]  Myers M K. On the acoustic boundary condition in the presence of flow[J]. <i>Journal of Sound<i> & <i>Vibration</i>, 1980, 71(3):429-434.
[11]  康钟绪. 消声器及穿孔元件声学特性研究[D]. 哈尔滨:哈尔滨工程大学动力与能源工程学院, 2009.
[12]  季振林. 消声器声学理论与设计[M]. 北京:科学出版社, 2015.
[13]  Ji Zhenlin. <i>Acoustic Theory and Design of Silencers<i> [M]. Beijing:Science Press, 2015(in Chinese).</i></i></i></i>
[14]  徐贝贝, 季振林, 康钟绪, 等. 均匀流直通穿孔管消声器声学特性预测的有限元法[J]. 噪声与振动控制, 2010, 30(4):100-103.
[15]  徐航手, 季振林, 康钟绪. 抗性消声器传递损失预测的三维时域计算方法[J]. 振动与冲击, 2010, 29(4):107-110.
[16]  Xu Hangshou, Ji Zhenlin, Kang Zhongxu. Three-
[17]  dimensional time-domain computational approach for predicting transmission loss of reactive silencers[J]. <i>En-gineering Journal of Vibration and Shock</i>, 2010, 29(4):107-110(in Chinese).
[18]  刘晨, 季振林, 徐航手. 穿孔管消声器声学性能三维时域计算及分析[J]. 机械工程学报, 2012, 48(10):7-13.
[19]  Lee S H, Ih J G. Empirical model of the acoustic impedance of a circular orifice in grazing mean flow[J]. <i>Journal of the Acoustical Society of America</i>, 2003, 114(1):98.
[20]  康钟绪, 季振林, 连小珉, 等. 掠过流作用下穿孔板的声阻抗[J]. 声学学报, 2011, 36(1):51-59.
[21]  Kang Zhongxu, Ji Zhenlin, Lian Xiaomin, et al. Acoustic impedance of perforated plate with grazing flow[J]. <i>Acta Acustica</i>, 2011, 36(1):51-59(in Chinese).
[22]  Xu Beibei, Ji Zhenlin, Kang Zhongxu, et al. Finite element method for prediction of acoustic attenuation characteristics of straight-through perforated tube silencer with steady air flow[J]. <i>Noise and Vibration Control</i>, 2010, 30(4):100-103(in Chinese).
[23]  Kang Zhongxu. Study on the Acoustic Characteristics of Silencers and Perforated Elements[D]. Harbin:School of Power and Energy Engineering, Harbin Engineering University, 2009(in Chinese).

Full-Text

Contact Us

service@oalib.com

QQ:3279437679

WhatsApp +8615387084133