|
|
- 2016
碳源组成对化学气相渗透C/C复合材料致密化及热解炭结构的影响
|
Abstract:
为分析碳源在化学气相渗透过程中的沉积机制，以碳纤维针刺整体毡为预制体，添加丙烯（C3H6）的天然气混合气体为碳源，研究了碳源组成对C/C复合材料致密化及热解炭结构的影响。结果表明：相比于以天然气为碳源，以添加了适当比例C3H6的天然气为碳源，可有效提高C/C复合材料的致密化速率及密度分布均匀性；同时，有利于生成高织构的热解炭。最优条件（9vol% C3H6）下沉积100 h后，C/C复合材料的密度和径向密度偏差分别为1.40 g/cm3和0.04 g/cm3，热解炭为均一的粗糙层结构，石墨化度高；而以天然气作碳源时，密度和径向密度偏差分别为1.17 g/cm3和0.07 g/cm3，热解炭为二元带状结构，石墨化度较低；当C3H6比例增加到17vol%时，其密度和径向密度偏差分别为1.28 g/cm3和0.10 g/cm3，密度及密度分布均匀性较最优条件下制备的复合材料明显降低。 In order to analyze the deposition mechanism of carbon source during the chemical vapor infiltration process, using carbon fiber neddled flet as preform, propylene (C3H6) added natural gas mixture gas as carbon source, the effects of carbon source composition on densification of C/C composites and microstructure of pyrolytic carbon were investigated. The results show that compared with using natural gas as carbon source, using a moderate ratio of C3H6 added natural gas as carbon source can improve the densification efficiency and density distribution uniformity of C/C composites effectively. At the same time, it is beneficial to form high texture pyrolytic carbon. After deposition for 100 h under the optimal condition (9vol% C3H6), the density and density deviation at radial direction of C/C composites are 1.40 g/cm3 and 0.04 g/cm3 respectively, the pyrolytic carbon is homogeneous rough laminar structure, and the graphitization degree is high. While when using natural gas as carbon source, the density and density deviation at radial direction are 1.17 g/cm3 and 0.07 g/cm3 respectively, the pyrolytic carbon is binary banded structure, and the graphitization degree is lower. When the ratio of C3H6 is improved to 17vol%, the density and density deviation at radial direction of it are 1.28 g/cm3 and 0.10 g/cm3 respectively. Compared to the composite prepared under the optimal condition, the density and density distribution uniformity decrease obviously. 国家自然科学基金（51202295）；中国博士后科学基金（2014M562129）；一院高校联合创新基金（CALT201507）
| [1] | 黄玉东, 朱惠光, 孙文训, 等. 细编穿刺C/C复合材料不同层次界面特性研究[J]. 复合材料学报, 2000, 17(1):56-59. HUANG Y D, ZHU H G, SUN W X, et al. Investigation on the interfacial characteristics in different gradation for fine weave pierced C/C composites[J]. Acta Materiae Compositae Sinica, 2000, 17(1):56-59(in Chinese). |
| [2] | 梁军, 卢琦, 阚晋, 等. C/C复合材料液相浸渍制备工艺及其力学性能模拟[J]. 复合材料学报, 2011, 28(3):159-166. LIANG J, LU Q, KAN J, et al. Simutations of manufacturing process and mechanical properties of C/C composites during liquid-phase impregnation manufacturing process[J]. Acta Materiae Compositae Sinica, 2011, 28(3):159-166(in Chinese). |
| [3] | 韩帅, 段跃新, 李超, 等. 不同针织结构经编碳纤维复合材料弯曲性能[J]. 复合材料学报, 2011, 28(5):52-57. HAN S, DUAN Y X, LI C, et al. Bending properties of non-crimp stitched carbon fabric reinforced composites of different knit patterns[J]. Acta Materiae Compositae Sinica, 2011, 28(5):52-57(in Chinese). |
| [4] | 廖寄乔. 热解炭微观结构对C/C复合材料性能影响的研究[D]. 长沙:中南大学, 2003. LIAO J Q. A study of influence of microstructure of pyrocarbon on the properties of C/C composites[D]. Changsha:Central South University, 2003(in Chinese). |
| [5] | PAUW V D, KALHOFER S, GERTHSEN D. Influence of the deposition parameters on the texture of pyrolytic carbon layers deposited on planar substrates[J]. Carbon, 2004, 42(2):279-286. |
| [6] | 熊杰, 邹志强, 汤中华, 等. 载气对C/C复合材料CVI热解炭显微结构的影响[J]. 复合材料学报, 2004, 21(6):87-92. XIONG J, ZOU Z Q, TANG Z H, et al. Effect of carrier gas on the microstructure of CVI pyrocarbon in C/C composite[J]. Acta Materiae Compositae Sinica, 2004, 21(6):87-92(in Chinese). |
| [7] | HU Z J, ZHANG W G, HUTTINGER K J, et al. Influence of pressure, temperature and surface area/volume ratio on the texture of pyrolytic carbon deposited from methane[J]. Carbon, 2003, 41(4):749-758. |
| [8] | LI H J, LI A J, BAI R C, et al. Numerical simulation of chemical vapor infiltration of propylene into C/C composites with reduced multi-step kinetic models[J]. Carbon, 2005, 43(14):2937-2950. |
| [9] | LACROIX R, FOURNET R, ZIEGLER-DEVIN I, et al. Kinetic modeling of surface reactions involved in CVI of pyrocarbon obtained by propane pyrolysis[J]. Carbon, 2010, 48(1):132-144. |
| [10] | MEADOWS P J, LOPEZ-HONORATO E, XIAO P. Fluidized bed chemical vapor deposition of pyrolytic carbon-II. Effect of deposition conditions on anisotropy[J]. Carbon, 2009, 47(1):251-262. |
| [11] | BECKER A, HUTTINGER K J. Chemistry and kinetics of chemical vapor deposition of pyrocarbon-IV Pyrocarbon deposition from methane in the low temperature regime[J]. Carbon, 1998, 36(3):213-224. |
| [12] | 汤中华, 周桂芝, 熊杰, 等. 炭/炭复合材料石墨化度的XRD均峰位法测定[J]. 中国有色金属学报, 2003, 13(6):1435-1440. TANG Z H, ZHOU G Z, XIONG J, et al. Measurement of graphitization degree of carbon-carbon composites by average X-ray diffraction angle method[J]. The Chinese Journal of Nonferrous Metals, 2003, 13(6):1435-1440(in Chinese). |
| [13] | HU Z J, HUTTINGER K J. Mechanisms of carbon deposition-A kinetic approach[J]. Carbon, 2002, 40(4):617-636. |
| [14] | 张伟刚. 化学气相沉积-从烃类气体到固体热解碳[M]. 北京:科学出版社, 2007:206-207. ZHANG W G. CVD-from hydrocarbon gas to solid pyrocarbon[M]. Beijing:Science Press, 2007:206-207(in Chinese). |
| [15] | TANG Z H, XIONG X, ZHANG H B. Effect of carrier gas on bulk density and microstructure distribution of carbon/carbon composites fabricated by thermal gradient chemical vapor infiltration[J]. Carbon, 2012, 50(3):1243-1252. |
| [16] | DONG G L, HUTTINGER K J. Consideration of reaction mechanisms leading to pyrolytic carbon of different textures[J]. Carbon, 2002, 40(14):2515-2528. |
| [17] | NORINAGA K, DEUTSCHMANN O, HUTTINGER K J. Analysis of gas phase compounds in chemical vapor deposition of carbon from lighthydrocarbons[J]. Carbon, 2006, 44(9):1790-1800. |
| [18] | 李贺军. 炭/炭复合材料[J]. 新型炭材料, 2001, 16(2):79-80. LI H J. C/C composites[J]. New Carbon Materials, 2001, 16(2):79-80(in Chinese). |
| [19] | 黄伯云, 熊翔. 高性能炭/炭航空制动材料的制备技术[M]. 长沙:湖南科学技术出版社, 2007:5-23. HUANG B Y, XIONG X. The preparation technology of high performance C/C aircraft brake materials[M]. Changsha:Hunan Science & Technology Press, 2007:5-23(in Chinese). |
| [20] | 马立敏, 张嘉振, 岳广全, 等. 复合材料在新一代大型民用飞机中的应用[J]. 复合材料学报, 2015, 32(2):317-322. MA L M, ZHANG J Z, YUE G Q, et al. Application of composites in new generation of large civil aircraft[J]. Acta Materiae Compositae Sinica, 2015, 32(2):317-322(in Chinese). |
| [21] | 刘立洵, 刘文训, 黄玉东, 等. 炭/炭复合材料中的界面现象[J]. 炭素, 1999(4):37-40. LIU L X, LIU W X, HUANG Y D, et al. Interfacial phenomena in carbon/carbon composite materials[J]. Carbon Techniques, 1999(4):37-40(in Chinese). |
