|
|
- 2018
锂离子电池正极材料LiNi0.8Co0.15Al0.05O2的制备与性能
|
Abstract:
采用共沉淀法制备粒径10 μm左右的前驱体Ni0.8Co0.15Al0.05（CO3）x（OH）y，然后采用该前驱体和LiOH·H2O成功制备了锂离子电池正极材料LiNi0.8Co0.15Al0.05O2（LiNCA），并详细研究了煅烧氛围、煅烧温度和煅烧方式等条件对LiNCA电化学性能的影响。研究表明，在O2中煅烧获得的LiNCA放电容量达到170 mAh·g-1，50次循环后容量保持率达到95%，性能明显优于空气氛围中煅烧得到的LiNCA。在O2氛围下，700~750℃温度范围煅烧得到的LiNCA性能最好，煅烧温度过高或过低，LiNCA性能均明显下降。将前驱体在O2氛围中450℃条件预煅烧，然后与LiOH·H2O在700~750℃混合煅烧的煅烧方式，得到的LiNCA放电容量明显提高，可达190 mAh·g-1。 By means of coprecipitation, the precursor Ni0.8Co0.15Al0.05(CO3)x (OH)y with about 10 μm particle size was prepared. The cathode material of lithium ion battery, LiNi0.8Co0.15Al0.05O2 (LiNCA) was fabricated successfully with the precursor and LiOH·H2O, and the effects of calcination atmosphere, calcination temperature and calcination method on electrochemical performances were studied. The results show that the discharge specific capacity of the LiNCA calcined in oxygen reaches 170 mAh·g-1, and the capacity retention ratio after 50 cycles reaches 95%, which is better than the LiNCA calcined in air. In the oxygen atmosphere, the LiNCA obtains the best performance when the calcination temperature is in range of 700 to 750℃. If the calcination temperature is too high or too low, the performance of LiNCA decreases significantly. When the precursor is precalcined at 450℃ in oxygen atmosphere, and then calcined with mixed LiOH·H2O at 700 to 750℃, the LiNCA discharge specific capacity reaches 190 mAh·g-1, which increases significantly. 国家自然科学基金（51272010；51472018）
| [1] | ARMAND M, TARASCON J M. Building better batteries[J]. Nature, 2008, 451(7179):652-657. |
| [2] | 李恒, 张丽鹏, 于先进. 锂离子电池正极材料的研究进展[J]. 硅酸盐通报, 2012, 31(6):1486-1490. LI Heng, ZHANG Lipeng, YU Xianjing. Research progress for cathode materials of lithium ion battery[J]. Bulletin of the Chinese Ceramic Society, 2012, 31(6):1486-1490(in Chinese). |
| [3] | HUANG Q, COSIMBESCU L, KOECH P, et al. Compoite organic radical-inorganic hybrid cathode for lithium-ion batteries[J]. Journal of Power Sources, 2013, 233(4):69-73. |
| [4] | HAN C J, YOON J H, CHO W I, et al. Electrochemical properties of LiNi0.8Co0.2-x Al x O2, prepared by a sol-gel method[J]. Journal of Power Sources, 2004, 136(1):132-138. |
| [5] | HAI Y T, CORINA T, MAGRET W M. Influence of the technical process parameters on structural, mechanical and electrochemical properties of LiNi0.8Co0.15Al0.05O2 based electrodes-A review[J]. Progress in Solid State Chemistry, 2014, 42:118-127. |
| [6] | HU G, LIU W, PENG Z, et al. Synthesis and electrochemical properties of LiNi0.8Co0.15Al0.05O2 prepared from the precursor Ni0.8Co0.15Al0.05OOH[J]. Journal of Power Sources, 2012, 198:258-263. |
| [7] | BIANCHI V, BACH S, BELHOMME C, et al. Electrochemical investigation of the Li insertion-extraction reaction as a function of lithium deficiency in Li1-x Ni1+ x O2[J]. Electrochimica Acta, 2001, 46(7):999-1011. |
| [8] | BIANCHI V, CAURANT D, BAFFIER N, et al. Synthesis, structural characterization and magnetic properties of quasistoichiometric LiNiO2[J]. Solid State Ionics, 2001, 140(1-2):1-17. |
| [9] | MAJUMDER S B, NIETO S, KATIYAR R S. Synthesis and electrochemical properties of LiNi0.80(Co0.20-x Al x)O2 (x=0.0 and 0.05) cathodes for Li ion rechargeable batteries[J]. Journal of Power Sources, 2006, 154(1):262-267. |
| [10] | HWANG B J, SANTHANAM R, CHEN C H. Effect of synthesis conditions on electrochemical properties of LiNi1-y Co y O2 cathode for lithium rechargeable batteries[J]. Journal of Power Sources, 2003, 114(2):244-252. |
| [11] | PERIASAMY P, KIM H S, NA S H, et al. Synthesis and characterization of LiNi0.8Co0.2O2 prepared by a combustion solution method for lithium batteries[J]. Journal of Power Sources, 2004, 132(1-2):213-218. |
| [12] | LIAO L, WANG X, LUO X, et al. Synthesis and electrochemical properties of layered Li[Ni0.333Co0.333Mn0.293Al0.04]O2-z F z cathode materials prepared by the sol-gel method[J]. Journal of Power Sources, 2006, 160(1):657-661. |
| [13] | LUO X, WANG X, LIAO L, et al. Synthesis and characterization of high tap-density layered Li[Ni1/3Co1/3Mn1/3]O2 cathode material via hydroxide coprecipitation[J]. Journal of Power Sources, 2006, 158(1):654-658. |
| [14] | XU J, LIN F, DOEFF M M, et al. A review of Ni-based layered oxides for rechargeable Li-ion batteries[J]. Journal of Materials Chemistry A, 2016, 5(3):874-901. |
| [15] | 陈宗宗, 张瑞丰. 基于Polymer-S-C/SiO2多层结构大孔电极锂硫离子电池的制备与性能[J]. 复合材料学报, 2014, 31(2):525-531. CHEN Zongzong, ZHANG Ruifeng. Preparation and performance of lithium-sulfur batteries based on multilayer structure in polymer-S-C/SiO2 macroporous electrodes[J]. Acta Materiae Compositae Sinica, 2014, 31(2):525-531(in Chinese). |
| [16] | PARK S H, YOON C S, KANG S G, et al. Synthesis and structural characterization of layered Li[Ni1/3Co1/3Mn1/3]O2 cathode materials by ultrasonic spray pyrolysis method[J]. Electrochimica Acta, 2004, 49(4):557-563. |
| [17] | 巩桂芬, 王磊, 徐阿文. 静电纺PMMA/EVOH-SO3Li锂离子电池隔膜复合材料的制备及性能[J]. 复合材料学报, 2018, 35(3):477-484. GONG Guifen, WANG Lei, XU Awen. Preparation and properties of PMMA/EVOH-SO3Li Li-ion battery separator composite by electrospinning[J]. Acta Materiae Compositae Sinica, 2018, 35(3):477-484(in Chinese). |
| [18] | 陈涨宗, 袁徐俊, 温美盛, 等. 富锂制备LiNi0.80Co0.15Al0.05O2正极材料[J]. 储能科学与技术, 2014, 3(6):620-623. CHEN Zhangzong, YUAN Xujun, WEN Meisheng, et al. Preparation of LiNi0.80Co0.15Al0.05O2 cathode material via Li-rich method[J]. Energy Storage Science and Technology, 2014, 3(6):620-623(in Chinese). |
| [19] | YOON S, JUNG K N, YEON S H, et al. Electrochemical properties of LiNi0.8Co0.15Al0.05O2-graphene composite as cathode materials for lithium-ion batteries[J]. Journal of Electroanalytical Chemistry, 2012, 683:88-93. |
| [20] | CHO Y, LEE Y S, PARK S A, et al. LiNi0.8Co0.15Al0.05O2 cathode materials prepared by TiO2 nanoparticle coatings on Ni0.8Co0.15Al0.05(OH)2 precursors[J]. Electrochimica Acta, 2010, 56(1):333-339. |
| [21] | CHUNG Y M, RYU K S. Surface coating and electrochemical properties of LiNi0.8Co0.15Al0.05O2 polyaniline composites as an electrode for Li-ion batteries[J]. Bulletin-Korean Chemical Society, 2009, 30(30):1733-1737. |
