|
|
- 2018
电场诱导多壁碳纳米管有序排列对多壁碳纳米管/环氧树脂复合材料性能的影响
|
Abstract:
采用交流（AC）电场诱导法制备了多壁碳纳米管（MWCNTs）均匀分散且定向有序排列的MWCNTs/环氧树脂复合材料。采用SEM、偏振拉曼光谱等研究了电场强度、MWCNTs含量、加电时间及温度（黏度）等因素对MWCNTs定向排列的影响，讨论了MWCNTs有序排列对MWCNTs/环氧树脂复合材料电学和力学性能的影响。结果表明：MWCNTs沿电场方向有序排列；MWCNTs/环氧树脂复合材料施加AC电场后的拉曼强度明显高于未施加电场的情况；当MWCNTs含量从0wt%增加到0.025wt%时，MWCNTs/环氧树脂复合材料导电率从2.3×10-12 S/cm增加到1.3×10-8 S/cm，增加了约4个数量级；MWCNTs含量为2.5wt%时，MWCNTs/环氧树脂复合材料拉伸强度提高了26.3%。 The uniformly dispersed and aligned multiwalled carbon nanotubes (MWCNTs)/epoxy resin composite was prepared by alternating current (AC) electric field induction method. The effects of electric field intensity, MWCNTs content, applying electric field time and temperature (viscosity) on the alignment of MWCNTs were studied by SEM and polarization Raman spectroscop.The influence of MWCNTs alignment on the electrical and mechanical properties of MWCNTs/epoxy resin composites was discussed. The results show that the MWCNTs are aligned in the direction of electric field, the Raman intensity of MWCNTs/epoxy resin composites after being exposed to the electric field is significantly higher than that of the unapplied electric field. When MWCNTs content increases from 0wt% to 0.025wt%, the electrical conductivity increases from 2.3×10-12 S/cm to 1.3×10-8 S/cm by about 4 orders of magnitude. The tensile-shear strength of MWCNTs/epoxy resin composites increases by 26.3%, when MWCNTs content is 2.5wt%. 国防科技创新特区项目（17-163-16-ZT-009-079-001）
| [1] | LIJIMA S. Helical microtubes of graphitic cabon[J]. Nature, 1991, 354:56-58. |
| [2] | 崔同湘, 吕瑞涛, 黄正宏, 等. 碳纳米管纸的制备研究进展[J]. 材料导报, 2010, 24(15):13-17. CUI T X, LV R T, HUANG Z H, et al. Research progress in preparation of buckypaper[J]. Materials Review, 2010, 24(15):13-17(in Chinese). |
| [3] | DOMUN N, HADAVINIA H, ZHANG T, et al. Improving the fracture toughness and the strength of epoxy using nanomaterials:A review of the current status[J]. Nanoscale, 2015, 7(23):10294-10329. |
| [4] | SHAM M L, KIM J K. Surface functionalities of multi-wall carbon nanotubes after UV/ozone and TETA treatments[J]. Carbon, 2006, 44(4):768-777. |
| [5] | MA P C, KIM J K, TANG B Z. Effects of silane functionalization on the properties of carbon nanotube/epoxy nanocomposites[J]. Composites Science & Technology, 2007, 67(14):2965-2972. |
| [6] | SPITALSKY Z, TASIS D, PAPAGELIS K, et al. Carbon nanotube polymer composites:Chemistry, processing, mechanical and electrical properties[J]. Progress in Polymer Science, 2010, 35(3):357-401. |
| [7] | GENG Y, LIU M Y, LI J, et al. Effects of surfactant treatment on mechanical and electrical properties of CNT/epoxy nanocomposites[J]. Composites Part A:Applied Science & Manufacturing, 2008, 39(12):1876-1883. |
| [8] | THOSTENSON E T, REN Z F, CHOU T W. Advances in the science and technology of carbon nanotubes and their composites:A review[J]. Composites Science & Technology, 2001, 61:1899-1912. |
| [9] | LI J, MA P C, CHOU W S, et al. Correlations between percolation threshold, dispersion state, and aspect ratio of carbon nanotubes[J]. Advanced Functional Materials, 2007, 17(16):3207-3215. |
| [10] | MONTI M, NATALI M, TORRE L, et al. The alignment of single walled carbon nanotubes in an epoxy resin by applying a DC electric field[J]. Carbon, 2012, 50(7):2453-2464. |
| [11] | 陈蔚, 张晨乾, 成理, 等. FRI用5228A环氧树脂的制备及其对5228A/CCF300复合材料力学性能的影响[J]. 玻璃钢/复合材料, 2015(5):38-41. CHEN W, ZHANG C Q, CHENG L, et al. The preparation of 5228A epoxy resin used in FRI and the impaction on mechanical property of 5228A/CCF300 composites[J]. Fiber Reinforced Plastics/Composites, 2015(5):38-41(in Chinese). |
| [12] | 陈琰, 安立宝. 粒子受介电泳作用的仿真研究[J]. 固体电子学与进展, 2015, 35(1):25-30. CHEN Y, AN L B. Simulation of particlemotion caused by dielectrophoretic force[J]. Research and Progress of SSC, 2015, 35(1):25-30(in Chinese). |
| [13] | FISCHER J E, ZHOU W, VAVRO J, et al. Magnetically aligned single wall carbon nanotube films:Preferred orientation and anisotropic transport properties[J]. Journal of Applied Physics, 2003, 93(4):2157-2163. |
| [14] | 丁义纯, 谢成宸, 朱健, 等. 静电纺丝法制备低渗流阈值聚酰亚胺/炭黑导电复合材料[J]. 高分子材料科学与工程, 2013, 29(9):160-163. DING Y C, XIE C C, ZHU J, et al. Preparation and properties of one component waterbornepolyurethane with high pencil hardness[J]. Polymer Materials Science and Engineering, 2013, 29(9):160-163(in Chinese). |
| [15] | SHAFI U K, JAYARAM R P, JANG-KYO K, et al. Effects of carbon nanotube alignment onelectrical and mechanical properties of epoxy nanocomposites[J]. Composites Part A:Applied Science and Manufacturing, 2013, 49:26-34. |
| [16] | MIRIALILI V, HUBERT P. Modelling of the carbon nanotube bridge effect on the toughening of polymers and experimental verification[J]. Composites Science & Technology, 2010, 70:1537-1543. |
| [17] | XIE X L, MAI Y W, ZHOU X P. Dispersion and alignment of carbon nanotubes in polymer matrix:A review[J]. Materials Science & Engineering, 2005, 49(4):89-112. |
| [18] | MA P C, SIDDIQUI N A, MAROOM G, et al. Dispersion and functionalization of carbon nanotubes for polymer-based nanocomposites:A review[J]. Composites Part A:Applied Science and Manufacturing, 2010, 41(10):1345-1367. |
| [19] | 张超. 优质碳纳米管的制备及其定向排列的SWNTs/PMMA复合材料研究[D]. 兰州:兰州理工大学, 2008. ZHANG C. The preparation of high quality carbon nanotubes and aligned carbon nanotubes in SWNTs/PMMA composites[D]. Lanzhou:Lanzhou University of Technology, 2008(in Chinese). |
| [20] | CHEN Z, YANG Y, WU Z, et al. Electric-field-enhanced assembly of single-walled carbon nanotubes on a solid surface[J]. Journal of Physical Chemistry B, 2005, 109(12):5473-5477. |
| [21] | HONE J, LLAGUNO M C, NEMES N M, et al. Electrical and thermal transport properties of magnetically aligned single wall carbon nanotube films[J]. Applied Physics Letters, 2000, 77(5):666-668. |
| [22] | HOBBIE E K, WANG H, KIM H, et al. Optical measurements of structure and orientation in sheared carbon-nanotube suspensions[J]. Review of Scientific Instruments, 2003, 74(3):1244-1250. |
| [23] | SCHADLER L S, GIANNARIS S C, AJAYAN P M. Load transfer in carbon nanotube epoxy composites[J]. Applied Physics Letters, 1998, 73(26):3842-3845. |
| [24] | 戴剑锋, 张超, 王青, 等. 反复拉伸法制备单壁碳纳米管定向排列的SWCNT/PMMA复合材料[J]. 新型碳材料, 2008, 23(3):201-204. DAI J F, ZHANG C, WANG Q, et al. Preparation and characterization of polymethylmethacrylate/aligned SWCNT composites with by repeated strething[J]. New Carbon Materials, 2008, 23(3):201-204(in Chinese). |
