LEE W F, CHAN P K. A capacitive-based accelerometer IC using injection-nulling switch technique[J]. IEEE Transactions on circuits and systems, 2008, 55(4):980-989.
[2]
ALTONEN L, HALONEN K. Continuous-time interface for a micromachined capacitive accelerometer with NEA of 4 μg and bandwidth of 300 Hz[J]. Sensors and Actuators, 2009, 154:46-56.
[3]
LEMKIN M, BOSER B E. A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics[J]. IEEE J of Solid-State Circuits, 1999, 34(4):456-468.
[4]
KULAH H, CHAE J, YAZDI N, et al. Noise analysis and characterization of a sigma-delta capacitive microaccelerometer[J]. IEEE Solid-State Circuits, 2006, 41(2): 352-361.
[5]
OLIAEI O. Thermal noise analysis of multi-input SC-integrators for delta-sigma modulator design[C]//Proceeding of IEEE Int Symp Circuits and Systems. Geneva, Switzerland,2000: 425-428.
[6]
LIU Yunao, LIU Xiaowei, CHEN Weiping, et al. Design and noise analysis of a sigma-delta capacitive micromachined accelerometer[J].Journal of Semiconductor, 2010, 31(5): 0550061-0550066.
[7]
刘云涛, 姜一鸣, 尹亮. 四阶Sigma-Delta微加速度计系统设计与分析[J]. 哈尔滨工业大学学报, 2011, 43(7): 38-41. LIU Yuntao, JIANG Yiming, YIN Liang. System design and analysis of fourth-order sigma-delta micromachined accelerometer[J]. Journal of Harbin Institute of Technology, 2011, 43(7): 38-41.
[8]
WONG S L,SALAMA T. A switched differential Op-Amp with low offset and reduced 1/f noise[J]. IEEE Trans on Circuits and Systems, 1986, 33(11): 1119-1127.
[9]
LEE T H, CHO G, KIM H J. Analysis of 1/f noise in CMOS preamplifier with CDS circuit[J]. IEEE Trans on Nuclear Science, 2002, 49(4): 1819-1823.
[10]
HYNECEK J. CDS noise reduction of partially reset charge-detection nodes[J]. IEEE Trans on Circuits and Systems, 2002, 49(3): 276-280.
