李 圣,钟铁毅,张常勇. 基于概率地震需求分析的铅芯橡胶支座抗震性能研究[J]. 振动与冲击,2013,32(7)：48-53. LI Sheng, ZHONG Tieyi, ZHANG Changyong. Aseismic performance of LRB based on probabilistic seismic demand analysis[J]. Journal of Vibration and Shock, 2013, 32(7): 48-53.
[2]
Flora L, Torben S. Verification of the effectiveness of TMDs using wind tunnel section model tests[J]. Journal of Wind Engineering and Industrial Aerodynamics, 1996, 64(2): 161-170.
[3]
Makris N, Constantinou M C. Viscous damper: testing modeling and application in vibration of seismic isolation [R]. New York, USA: The State University of New York at Buffalo, 1990.
[4]
卢智成,代泽兵,曹枚根, 等. 电气设备减震体系抗震设计方法的研究[J]. 武汉大学学报,2010,43(增刊)：187-190. LU Zhicheng, DAI Zebing, CAO Meigen, et al . Study of method for aseismic design of electrical equipments with vibration absorbing system[J]. Engineering Journal of Wuhan Univeristy, 2010, 43(Supplement): 187-190.
[5]
Wen Y K. Method for random vibration of hysteretic systems[J]. Journal of Engineering Mechanics, 1976, 102 (2): 249-263.
[6]
Song J, Der Kiureghian A. Generalized Bouc-Wen model for highly asymmetric hysteresis[J]. Journal of Engineering Mechanics, 2006, 132(6): 610-618.
[7]
程永锋,朱全军,卢智成. 变电站电力设施抗震措施研究现状与发展趋势[J]. 电网技术,2008,32(22)：84-89. CHENG Yongfeng, ZHU Quanjun, LU Zhicheng. Progress and development trend on seismic measures of electric power equipments in transformer substation[J]. Power System Technology, 2008, 32(22): 84-89.
[8]
柳春光,李光华,林均岐. 电力供应系统地震安全分析与控制对策研究[J]. 地震工程与工程振动,2010,30(3)：147-153. LIU Chunguang, LI Guanghua, LIN Junqi. Research on seismic security and control measures of power supply systems[J]. Journal of Earthquake Engineering and Engineering Vibrations, 2010, 30(3): 147-153.
[9]
李西育,党镇平. 特高压支柱瓷绝缘子弯曲强度可靠性分析[J]. 电瓷避雷器,2013(2)：17-23. LI Xiyu, DANG Zhenping. Bending strength reliability analysis of the post porcelain insulator for UHV[J]. Insulators and Surge Arresters, 2013(2):17-23.
[10]
Howard M, André；
[11]
F. Seismic qualification and requirements for transformer bushings[R]. California, USA: Pacific Earthquake Engineering Research Center, 2003: 55-70.
[12]
Dohwan K. Evaluation and protection of high voltage electrical equipments against severe shock and vibrations[D]. New York, USA: The State University of New York at Buffalo, 2010: 41-61.
[13]
Muhammad F. Seismic evaluation and qualification of transformer bushings[D]. New York, USA: The State University of New York at Buffalo, 2013: 20-48.
[14]
Computer and Structures Inc. Analysis reference manual for SAP2000, ETABS and SAFE[M]. California, USA: Computers and Structures Inc, 2009: 256-260.
Fangcheng, HUANG Hua, LIU Yunpeng, et al . Contamination depositing characteristics of insulators under natural crosswind conditions with wind tunnel simulation[J]. High Voltage Engieering, 2014, 40(5): 1281-1289.
[17]
黄新波,赵 隆,周柯宏,等. 采用惯性传感器的输电导线舞动监测系统[J]. 高电压技术,2014,40(5)：1312-1319. HUANG Xinbo, ZHAO Long, ZHOU Kehong, et al . Conductor galloping monitoring system based on inertial sensor for transmission lines [J]. High Voltage Engieering, 2014, 40(5): 1312-1319.
[18]
程永锋,邱 宁,卢智成,等. 硬管母线连接的1 000 kV避雷器和电容电压式互感器抗震性能振动台试验[J]. 高电压技术,2014,40(12)：3882-3887. CHENG Yongfeng, QIU Ning, LU Zhicheng, et al. Shake table test on seismic performance of 1 000 kV arrester and capacitor voltage transformer interconnected by tube bus[J]. High Voltage Engineering, 2014, 40(12): 3882-3887.
[19]
GB 50260—2013 电力设施抗震设计规范[S]. 北京：中国计划出版社,2013. GB 50260—2013 Code for seismic design of electrical installations[S]. Beijing, China: China Planning Press, 2013.
[20]
IEEE Std 693™—2005 IEEE recommended practice for seismic design of substations[S], 2005.
