摘要 为了解决增压内燃机中冷器和散热器布置匹配问题，研究中冷器和散热器不同布置形式的散热特点及对内燃机冷却系统性能的影响.利用风洞试验和内燃机冷却性能台架试验，结合中冷器中不同的流动介质，针对不同的布置形式进行研究.试验结果表明:布置形式不同，对各自散热效率、热分布、模块整体风阻等的影响较大；风冷式传导介质，串联式风阻较并联式大，并联式散热效率优于串联式，但串联式热分布更均匀；水冷式传导介质，两种形式各方面差异较小.在实际设计中，根据内燃机中冷器不同的冷却介质、整体空间等选择最优的布置形式.Abstract：To better combine the charge air cooler and radiator into turbo engine， a research was proposed to influence the performance of cooling system and the engine itself. The various layouts of charge air cooler with different cooling mediums and radiators were tested via wind tunnel and engine cooling system bench. The result shows that the layout is a vital factor to cooling efficiency， thermal distribution and wind resistance， etc. As for air medium， parallel arrangement has better wind resistance and cooling efficiency than that of cascade arrangement， which， however， is well-distributed. As for water medium， the effect is insignificant. The optimal layout form can be selected based on the cooling medium and installing space.
References
[1]
Savory E，Martinuzzi R J，Ryval J，et al.Evaluation of the thermo fluid performance of an automotive engine cooling-fan system motor［J］.Proceedings of the Institution of Mechanical Engineers，Part D:Journal of Automobile Engineering，2011，225(1):74-89.
[2]
Pandiyarajan V，Chinna P M，Malan E，et al.Experimental investigation on heat recovery from diesel engine exhaust using finned shell and tube heat exchanger and thermal storage system［J］.Applied Energy，2011，88(1):77-87.
[3]
张毅，俞小莉，陆国栋，等.间距对散热器模块匹配性能影响的试验研究［J］.内燃机工程，2006，27(5):46-49.(Zhang Yi，Yu Xiao-li，Lu Guo-dong，et al. Experimental study of distance between heat exchangers for cooling module match［J］.Chinese Internal Combustion Engine Engineering，2006，27(5):46-49.)
[4]
肖宝兰，俞小莉，韩松，等.翅片参数对车用中冷器流动传热性能的影响［J］.浙江大学学报:工学版，2010，44(1):2164-2168，2178.(Xiao Bao-lan，Yu Xiao-li，Han Song，et al. The study of effects of fin parameters on thermal hydraulic performance of a vehicular charged air cooler［J］.Journal of Zhejiang University:Engineering Science，2010，44(1):2164-2168，2178.)
[5]
陆国栋，俞小莉，夏立峰.中冷器位置对柴油发电机冷却组性能的影响［J］.农业机械学报，2007，38(2):69-71.(Lu Guo-dong，Yu Xiao-1i，Xia Li-feng.Wind tunnel investigation on the performance of cooling package of diesel engine generator ［J］.Transactions of the Chinese Society for Agricultural Machinery，2007，38(2):69-71.)
[6]
Wang Z W，Huang R H，Cheng X B，et al.Experiment and simulation analysis on heat load of heavy-duty vehicle diesel engine［J］.SAE Paper，2007(1):682-693.
[7]
Aoyagi Y，Yamaguchi T，Osada H，et al.Improvement of thermal efficiency of a high-boosted diesel engine with focus on peak cylinder pressure［J］.International Journal of Engine Research，2011，12(3):227-237.
[8]
Glenn B C，Upadhyay D，Utkin V L，et al.Observer design of critical states for air path flow regulation in a variable geometry turbocharger exhaust gas recirculation diesel engine［J］.International Journal of Vehicle Design，2011，12(6):501-512.
[9]
Kim K B，Choi K W，Lee K H，et al.Active coolant control strategies in automotive engines［J］.International Journal of Automotive Technology，2010，11(6):767-772.
[10]
Dasappa S，Sridhar H V.Performance of a diesel engine in a dual fuel mode using producer gas for electricity power generation［J］.International Journal of Sustainable Energy，2013，32(3):153-168.
