Fedel M, Druart M E, Olivier M, et al. Compatibility between cataphoretic electro-coating and silane surface layer for the corrosion protection of galvanized steel [J]. Prog. Org. Coat., 2010, 69(2): 118
[2]
García S, Rodríguez M, Izquierdo R, et al. Evaluation of cure temperature effects in cataphoretic automotive primers by electrochemical techniques [J]. Prog. Org. Coat., 2007, 60(4): 303
[3]
Olivier M G, Romano A P, Vandermiers C, et al. Influence of the stress generated during an ageing cycle on the barrier properties of cataphoretic coatings [J]. Prog. Org. Coat., 2008, 63(3): 323
[4]
Sinko J. Challenges of chromate inhibitor pigments replacement in organic coatings [J]. Prog. Org. Coat., 2001, 42(3): 267
[5]
Fedrizzi L, Deflorian F, Rossi S, et al. Study of the corrosion behaviour of phosphatized and painted industrial water heaters [J]. Prog. Org. Coat., 2001, 42(1): 65
[6]
Gusmano G, Montesperelli G, Rapone M, et al. Zirconia primers for corrosion resistant coatings [J]. Surf. Coat. Technol., 2007, 201(12): 5822
[7]
Yang X, Tallman D, Gelling V, et al. Use of a sol-gel conversion coating for aluminum corrosion protection [J]. Surf. Coat. Technol., 2001, 140(1): 44
[8]
Phani A, Gammel F, Hack T. Structural, mechanical and corrosion resistance properties of Al 2 O 3 -CeO 2 nanocomposites in silica matrix on Mg alloys by a sol-gel dip coating technique [J]. Surf. Coat. Technol., 2006, 201(6): 3299
[9]
Li Q, Zhong X, Hu J, et al. Preparation and corrosion resistance studies of zirconia coating on fluorinated AZ91D magnesium alloy[J]. Prog. Org. Coat., 2008, 63(2): 222
[10]
Phani A, Gammel F, Hack T, et al. Enhanced corrosioon resistance by sol-gel-based ZrO 2 -CeO 2 coatings on magnesium alloys [J]. Mater. Corros., 2005, 56(2): 77
[11]
Zhitomirsky I, Galor L, Kohn A, et al. Electrodeposition of ceramic films from nonaqueous and mixed-solutions [J]. J. Mater. Sci., 1995, 30(20): 5307
[12]
Pang X, Zhitomirsky I, Niewczas M. Cathodic electrolytic deposition of zirconia films [J]. Surf. Coat. Technol., 2005, 195(2/3): 138
[13]
Xia X, Zhitomirsky I, McDermid J R. Electrodeposition of zinc and composite zinc-yttria stabilized zirconia coatings [J]. J. Mater. Process. Technol., 2009, 209(5): 2632
[14]
Ji W G, Hu J M, Liu L, et al. Improving the corrosion performance of epoxy coatings by chemical modification with silane monomers[J]. Surf. Coat. Technol., 2007, 201(8): 4789
[15]
Huang W, Yang J, Meng X, et al. Effect of the organic additions on crystal growth behavior of ZrO 2 nanocrystals prepared via sol-gel process [J]. Chem. Eng. J., 2011, 168(3): 1360
[16]
Agoudjil N, Kermadi S, Larbot A. Synthesis of inorganic membrane by sol-gel process [A]. Conference of the European-Desalination-Society and enter-for-Research-and-Technology- Hellas [C]. Greece, 2008, 223(1): 417
[17]
Zhang J T, Hu J M, Zhang J Q, et al. Studies of water transport behavior and impedance models of epoxy-coated metals in NaCl solution by EIS [J]. Prog. Org. Coat., 2004, 51(2): 145
[18]
Bard A J, Fan F R F, Kwak J, et al. Scanning electrochemical microscopy-Introduction and principles [J]. Anal. Chem., 1989, 61 (2): 132
[19]
Souto R M, González-García Y, Izquierdo J, et al. Examination of organic coatings on metallic substrates by scanning electrochemical microscopy in feedback mode: revealing the early stages of coating breakdown in corrosive environments [J]. Corros. Sci., 2010, 52(3): 748
[20]
Souto R, González-Garc?a Y, González S. In situ monitoring of electroactive species by using the scanning electrochemical microscope: Application to the investigation of degradation processes at defective coated metals [J]. Corros. Sci., 2005, 47(12): 3312
[21]
Bastos A, Sim?es A, González S, et al. Application of the scanning electrochemical microscope to the examination of organic coatings on metallic substrates [J]. Prog. Org. Coat., 2005, 53(3): 177
[22]
Cornut R, Lefrou C. A unified new analytical approximation for negative feedback currents with a microdisk SECM tip [J]. J. Electroanal. Chem., 2007, 608(1): 59
