Gu Shanmao, He Fengyou, Tan Guojun, et al. A review of sensorless control technology of permanent magnet synchronous motor[J]. Transactions of China Electrotechnical Society, 2009, 24(11): 14-20.
[3]
Foo G H B, Rahman M F. Direct torque control of an IPM-synchronous motor drive at very low speed using a sliding-mode stator flux observer[J]. IEEE Transactions on Power Electronics, 2010, 25(4): 933-942.
[4]
Lü Yisong, Li Xuchun, He Ji, et al. An efficiency optimization method for sensorless control of sinusoidal PMSM[J]. Transactions of China Electrotechnical Society, 2010, 25(6): 12-17.
Piippo A, Salomaki J, Luomi J. Signal injection in sensorless PMSM drives equipped with inverter output filter[J]. IEEE Transactions on Industry Applications, 2008, 44(5): 1614-1620.
Qin Feng, He Yikang, Liu Yi, et al. Comparative investigation of sensorless control with two high - frequency signal injection schemes[J]. Proceedings of the CSEE, 2005, 25(5): 116-121.
[9]
Reigosa D D, Garcia P, Briz F, et al. Modeling and adaptive decoupling of high-frequency rsistance and temperature effects in carrier-based sensorless control of PM synchronous machines[J]. IEEE Transactions on Industry Applications, 2010, 46(1): 139-149.
[10]
Corley M J, Lorenz R D. Rotor position and velocity estimation for a salient-pole permanent magnet synchronous machine at standstill and high speeds[J]. IEEE Transactions on Industry Applications, 1998, 34(4): 784-789.
[11]
Jang Ji Hoon, Sul Seung Ki, Ha Jung Ik, et al. Sensorless drive of surface-mounted permanent- magnet motor by high-frequency signal injection based on magnetic saliency[J]. IEEE Transactions on Industry Applications, 2003, 39(4): 1031-1039.
[12]
Foo G, Rahman M F. Sensorless direct torque and flux-controlled IPM synchronous motor drive at very low speed without signal injection[J]. IEEE Transactions on Industrial Electronics, 2010, 57(1): 395-403.
[13]
Andreescu G D, Pitic C I, Blaabjerg F, et al. Combined flux observer with signal injection enhancement for wide speed range sensorless direct torque control of IPMSM drives[J]. IEEE Transactions on Energy Conversion, 2008, 23(2): 393-402.
[14]
Nahid Mobarakeh B, Meibody Tabar F, Sargos F M. Back EMF estimation-based sensorless control of PMSM: robustness with respect to measurement errors and inverter irregularities[J]. IEEE Transactions on Industrial Electronics, 2007, 43(2): 485-494.
Lu Huacai, Xu Yuetong, Yang Weimin, et al. A novel estimation method of sensorless initial rotor position for surface-mounted PMLSM[J]. Proceedings of the CSEE, 2008, 28(15): 109-113.
[17]
Hu Jiangang, Liu Jingbo, Xu Longya. Eddy current effects on rotor position estimation and magnetic pole identification of PMSM at zero and low speeds[J]. IEEE Transactions on Power Electronics, 2008, 23(5): 2565-2575.
Wang Gao lin, Yang Rongfeng, Yu Yong, et al. Position sensorless control for interior permanent magnet synchronous motor[J]. Proceedings of the CSEE, 2010, 30(30): 93-98.
[20]
Jeong Y S, Lorenz R.D, Jahns T M, et al. Initial rotor position estimation of an interior permanent-magnet synchronous machine using carrier-frequency injection methods[J]. IEEE Transactions on Industry Applications, 2005, 41(1): 38-45.
[21]
Raca D, Garcia P, Reigosa D D, et al. Carrier signal selection for sensorless control of PM synchronous machines at zero and very low speeds[J]. IEEE Transactions on Industry Applications, 2010, 46(1): 167-178.
[22]
Ribeiro L A S, Degner M W, Briz F, et al. CComparison of carrier signal voltage and current injection for the estimation of flux angle or rotor position[C]. Porceedings of the IEEE lndustry Applications Society Annual Meeting, 1998: 452-459.
Liu Ying, Zhou Bo, Li Shuai, et al. Initial rotor position detection of surface mounted permanent magnet synchronous motor[J]. Proceedings of the CSEE, 2011, 31(18): 48-54.
