Seara J F, Uhia F J, Sieres J T, Gampo A. A general review of the wilson plot method and its modifications to determine convection coefficients in heat exchange devices[J]. Applied Thermal Engineering, 2007, 27: 2745-2757
[2]
Zhang Dingcai(张定才), Wang Kai(王凯), He Yaling(何雅玲), Tao Wenquan(陶文铨). Boiling heat transfer of R134a outside horizontal doubly-enhanced tubes[J]. CIESC Journal (化工学报), 2007, 58(11): 2710-2714
[3]
Yang Shiming (杨世铭), Tao Wenquan (陶文铨). Heat Transfer, 4rd ed. Beijing: Higher Education Press, 2006
[4]
Wu Peiyi(吴沛宜). A criterial equation for condensation heat transfer of R12 and R113 on single horizontal finned tubes[J]. Journal of Xi'an Jiaotong University (西安交通大学学报). 1979, 1(3): 1-10
[5]
Ma Zhixian(马志先), Zhang Jili(张吉礼), Sun Dexing(孙德兴). Theoretical development of laminar film condensation on single horizontal tube with one-dimensional and two-dimensional surfaces[J]. Journal of Harbin institute of Technology (哈尔滨工业大学学报), 2011, 43: 80-93
[6]
Seara J F, Uhia F J, Diz R, Dopozo A. Condensation of R-134a on horizontal integral-fin titanium tubes[J]. Applied Thermal Engineering, 2010, 30: 295-301
[7]
Cao Desheng, Shi Lin. Handbook for refrigerant appli- cation[M]. Beijing: Press of Metallurgy Industry(冶金工业出版社), 2003.
[8]
Gstoehl D., Thome J.R.. Film condensation of R-134a on tube array with plain and enhanced surfaces: part II—empirical prediction of inundation effects. Journal of Heat Transfer, 2006, 128: 33-43
[9]
Zhang D C, Ji W T, Tao W Q. Condensation heat transfer of HFC134a on horizontal low thermal conductivity tubes[J]. International Communications in Heat and Mass Transfer, 2007, 34: 917-923
[10]
Yun R, Heo J, Kim Y. Film condensation heat transfer characteristics of R134a on horizontal stainless steel integral-fin tubes at low heat transfer rate[J]. Int. J. Refrig., 2009, 32: 865-873
[11]
Beatty K O, Katz D L. Condensation of vapours on outside of finned tubes. Chemical Engineering Progress, 1948, 44(1): 55-70
[12]
Webb R L, Rudy T M, Keswan S T. Prediction of the condensation coefficient on horizontal integral-fin tube. Journal of Heat Transfer, 1985, 107: 369-376
[13]
Honda H, Nozu S. A prediction method for heat transfer during film condensation on horizontal low integral-fin tubes. Journal of Heat Transfer, 1987, 109: 218-225
[14]
Rose J W. An approximate equation for the vapour-side heat transfer coefficient for condensation on low-finned tubes. Int. J Heat and Mass Transfer, 1994, 37: 865-875
[15]
Briggs A, Rose J W. Effect of fin efficiency on a model for condensation heat tansfer on a horizontal integral-fin tube. Int. J Heat and Mass Transfer, 1994, 37(1): 457-463
[16]
Kumar R, Varma H K, Mohanty B. Prediction of heat transfer coefficient during condensation of water and R-134a on single horizontal integral-fin tubes[J]. Int. J. Refrig., 2002, 25: 111-126
[17]
Ma Zhixian(马志先). Experimental investigation on condensation heat transfer and its enhancement of HFC245fa outside horizontal tube bundles[D]. Harbin: Harbin Institute of Technology, 2007, 58-60
[18]
Ma Zhixian(马志先), Zhang Jili(张吉礼), Sun Dexing(孙德兴). Experimental study of condensation heat transfer coefficient of HFC245fa on bundles of horizontal smooth and enhanced tubes[J]. CIESC Journal (化工学报), 2010, 61(5): 1097-1106
[19]
Ma Zhixian(马志先), Zhang Jili(张吉礼), Sun Dexing(孙德兴). Effect of inundation on film condensation of HFC245fa and HCFC123 on horizontal tubes[J]. J. of Mech. Eng.(机械工程学报), 2012, 48 (4): 129-135
[20]
Zou Pinghua(邹平华). Design and investigation of head water tank for radiator test-bed[J]. Journal of Harbin University of Civil Engineering and Architecture(哈尔滨建筑工程学院学报), 1983, (3): 70-74
[21]
Zhao Xueduan(赵学端). Analysis of fluid dynamic of gravity water system for water flow-rate calibration device[J]. Journal of Shanghai Institute of Mechanical Engineering(上海机械学院学报),1980, (3): 5-12
[22]
Fujii T. Overlooked factors and unsolved problems in experimental research on condensation heat transfer[J]. Experimental Thermal and Fluid Science, 1992, 5: 652-663
[23]
Nusselt W. Die Oberflachenkondensation des wasserdampfes[J]. Z. vereines deutsch.Ing. 1916, 60: 541-546, 569-575
[24]
Adamek T. Bestimmung der kondensation-grossen auf fe-ingewellten oberflachen zur auslegun aptimaler wandprofile[J]. Warme-und Stoffiibertragung, 1981, 15: 255-270.
[25]
Zhang Zhengguo(张正国), Lin Peisen(林培森), Wang Shiping(王世平). Development of petal-finned tube and research on its enhancement condensation heat transfer in longitudinal flow. Petro-chemical Equipment(石油化工设备), 1996, 25(3): 3-6
[26]
Kumar R, Varma H K, Mohanty B, Agrawal K N., Augmentation of heat transfer during filmwise condensation of steam and R-134a over single horizontal finned tubes[J]. Int. J. Heat and Mass Transfer, 2002, 45: 201-211
[27]
Ali H M, Briggs A. Enhanced condensation of ethylene glycol on single pin-fin tubes—effect of pin geometry [J]. Journal of Heat Transfer, 2012, 134: 1-7.
[28]
Kumar R, Gupta A, Vishvakarma S. Condensation of R-134a vapour over single horizontal integral-fin tubes: effect of fin height[J]. Int J Refrig., 2005, 28: 428-435
[29]
Belghazi M, Bontemps A, Marvillet C. Condensation heat transfer on enhanced surface tubes: experimental results and predictive theory[J]. Journal of Heat Transfer, 2002, 124: 754-761
[30]
Honda H, Takata N, Takamatsu H, Kim J S, Usami K. Condensation of downward flowing HFC-134a in a staggered bundle of horizontal finned tubes: effect of fin geometry. Int. J Refrig., 2002, 25: 3-10
[31]
Cheng W Y, Wang C C. Condensation of R134a on Enhanced Tubes[J]. ASHRAE Trans., 1994, 100(2): 809-817
[32]
Rewert L E, Huber J B, Pate M B. The Effect of R-134a inundation on enhanced tube geometries[J]. AHSRAE Trans., 1996, 102(2): 285-296
[33]
Randall D L, Eckels S J. Effect of inundation upon condensation heat transfer performance of R-134a: part II—results. Int. J of HVAC&R Research, 2005, 11(4): 543-562
