叶列平, 陆新征, 赵世春, 等. 框架结构抗地震倒塌能力的研究[J]. 建筑结构学报, 2009, 30(6): 67―76. Ye Lieping, Lu Xinzheng, Zhao Shichun, et al. Seismic collapse resistance of RC frame structures [J]. Journal of Building Structure, 2009, 30(6): 67―76. (in Chinese)
[2]
马玉虎, 陆新征, 叶列平, 等. 漩口中学典型框架结构震害模拟与分析[J]. 工程力学, 2011, 28(5): 71―77. Ma Yuhu, Lu Xinzheng, Ye Lieping, et al. Seismic damage simulation and analysis of typical RC frames of Xuankou School [J]. Engineering Mechanics, 2011, 28(5): 71―77. (in Chinese)
[3]
李英民, 刘立平. 汶川地震建筑震害与思考[M]. 重庆: 重庆大学出版社, 2008: 84―91. Li Yingmin, Liu Liping. Disaster investigation and study report of Sichuan Wenchuan Earthquake [M]. Chongqing: Chongqing University Press, 2008: 84―91. ( in Chinese)
[4]
Waters T. A study of the tensile strength of concrete across construction joints [J]. Magazine of Concrete Research, 1954, 6(18): 151―153.
[5]
Isao Ujike, Noriyoshi Yoshida, Shigekazu Morishita. Evaluation of mechanical properties of construction joint between new and old concrete under combined tensile and shear stresses [J]. Journal of the Society of Materials Science, Japan, 1998, 47(1): 73―88.
[6]
Mattock, Alan H. Cyclic shear transfer and type of interface [J]. Journal of the Structural Division, ASCE, 1981, 107(10): 1945―1964.
[7]
陈远峰, 王振波, 杨春和. 考虑施工缝影响的框架结构抗震性能试验研究[J]. 工业建筑, 2006, 36(2): 28―30. Chen Yuanfeng, Wang Zhenbo, Yang Chunhe. Experimental study on seismic performance of concrete frame considering the effect of construction joints under low cycle reversed loading [J]. Industrial Construction, 2006, 36(2): 28―30. (in Chinese)
[8]
张卫东, 王振波, 朱方之. 施工缝位置对框架结构抗震性能的影响[J]. 低温建筑技术, 2007, 118(4): 46―48. Zhang Weidong, Wang Zhenbo, Zhu Fangzhi. Influence of position of construction joint on seismic-resistance behavior of reinforced concrete frame [J]. Low Temperature Architecture Technology, 2007, 118(4): 46―48. (in Chinese)
[9]
魏春明. 现浇钢筋混凝土框架结构施工缝抗震性能[D]. 大连: 大连理工大学, 2006. Wei Chunming. Seismic behavior of cast in-situ reinforced concrete frame structure with construction joints [D]. Dalian: Dalian University of Technology, 2006. (in Chinese)
[10]
李英民, 于婧, 夏洪流. 施工缝模型及在钢筋混凝土柱非线性分析中的应用[J]. 土木建筑与环境工程, 2011, 33(5): 1―6. Li Yingmin, Yu Jing, Xia Hongliu. Construction joint modeling and its application in nonlinear analysis of RC columns [J]. Journal of Civil, Architectural & Environmental Engineering, 2011, 33(5): 1―6. (in Chinese)
[11]
于婧, 李英民, 夏洪流. 带施工缝钢筋混凝土柱剪切恢复力模型试验研究[J]. 建筑结构学报,2011, 32(9): 84―91. Yu Jing, Li Yingmin, Xia Hongliu. Hysteretic shear model for RC columns with construction joint [J]. Journal of Building Structure, 2011, 32(9): 84―91. (in Chinese)
[12]
GB 50011-2010, 建筑抗震设计规范[S]. 北京: 中国建筑工业出版社, 2010.
[13]
GB 50011-2010, Code for seismic design of buildings [S]. Beijing: China Architecture & Building Press, 2010. (in Chinese)
[14]
Mazzoni S, McKenna F, Scott M H, et al. OpenSees users manual [Z/CP]. PEER, University of California, Berkeley, 2004.
[15]
解琳琳, 叶献国, 种迅, 等. OpenSEES中混凝土框架结构节点模型关键问题的研究与验证[J]. 工程力学, 2014, 31(3): 116―121. Xie Linlin, Ye Xianguo, Chong Xun, et al. Research and verification on joint model of RC frame structure in OpenSEES [J]. Engineering Mechanics, 2014, 31(3): 116―121. (in Chinese)
[16]
Scott D B, Park R, Priestley M J N. Stress-strain behavior of concrete confined by overlapping hoops at low and high strain rates [J]. ACI Journal, 1982, 79(1): 13―27.
[17]
Zhao J, Sritharan S F. Modeling of strain penetration effects in bar-based analysis of reinforced concrete structures [J]. ACI Structural Journal, 2007, 104(2): 133―141.
[18]
韩军. 建筑结构扭转地震反应分析及抗扭设计方法研究[D]. 重庆: 重庆大学, 2009. Han Jun. Study on torsional response analysis and torsion resistance design method of building structures under earthquake action [D]. Chongqing: Chongqing University, 2009. (in Chinese)
