Eminent depletion of fossil fuels and environmental pollution are the key forces driving the implementation cofiring of fossil fuels and biomass. Cogasification as a technology is known to have advantages of low cost, high energy recovery, and environmental friendliness. The performance/efficiency of this energy recovery process substantially depends on thermal properties of the fuel. This paper presents experimental study of thermal behavior of Kiwira coal waste/rice husks blends. Compositions of 0, 20, 40, 60, 80, and 100% weight percentage rice husk were studied using thermogravimetric analyzer at the heating rate of 10？K/min to 1273？K. Specifically, degradation rate, conversion rate, and kinetic parameters have been studied. Thermal stability of coal waste was found to be higher than that of rice husks. In addition, thermal stability of coal waste/rice husk blend was found to decrease with an increase of rice husks. In contrast, both the degradation and devolatilization rates increased with the amount of rice husk. On the other hand, the activation energy dramatically reduced from 131？kJ/mol at 0% rice husks to 75？kJ/mol at 100% rice husks. The reduction of activation energy is advantageous as it can be used to design efficient performance and cost effective cogasification process. 1. Introduction The ever increasing need for clean energy, environmental protection, and alternative use of fossil fuel has necessitated the recovery of energy from waste fossil energy resources. Efficient ways to recover damped coal waste are on record and range from circulating fluidized bed combustor to gasification and pyrolysis [1]. Tanzania has approximately 1.5 billion metric tons of proven coal [2] with Kiwira coal mine having a proven deposit of 4 million metric tons [3]. It has an annual coal waste production of 17,374 tons [4] and has damped over 500,000 metric tons of waste for the 2 million metric tons of coal already mined. Although Tanzania has reasonably enough unutilized fresh coal, effective use of coal waste can provide sustainable profile of fossil fuel use. Tanzania has a wide range of biomass including forestry and agricultural residue. Rice husk in Tanzania is not used efficiently and as such most of it is wasted. For example, Mhilu estimated 326,220 tons of rice husks are wasted annually compared to 10,400 tons of coffee husks [5]. Direct combustion of coal waste has a wide range of constraints from environmental pollution, low energy recovery, and high cost [1]. Proven, cheap, and environmental friendly technologies such as
References
[1]
S. Su, Y. G. Jin, X. X. Yu, and R. Worrall, “Preliminary experimental studies of waste coal gasification,” in Cleaner Combustion and Sustainable World, pp. 719–723, Springer, 2013.
[2]
TMAA, “Minerals Found in Tanzania-Coal,” 2014, http://www.tmaa.go.tz/minerals/view/coal.
[3]
Ministry of Energy and Minerals, Power System Master Plan 2012 Update, Ministry of Energy and Minerals, Dar es Salaam, Tanzania, 2012.
[4]
D. A. Mwakipesile, P. L. Mtui, I. S. N. Mkilaha, and M. H. Mkumbwa, “Behaviour of trace metals in gasification of Kiwira coal wastes,” in Proceedings of the International Conference Mechanical and Industrial Engineering, pp. 269–273, Arusha, Tanzania, 2012.
[5]
C. F. Mhilu, “Analysis of energy characteristics of rice and coffee husks blends,” ISRN Chemical Engineering, vol. 2014, Article ID 196103, 6 pages, 2014.
[6]
M. H. Lapuerta, J. J. Hernández, A. Pazo, and J. López, “Gasification and co-gasification of biomass wastes: effect of the biomass origin and the gasifier operating conditions,” Fuel Processing Technology, vol. 89, no. 9, pp. 828–837, 2008.
[7]
Y. G. Pan, E. Velo, X. Roca, J. J. Manya, and L. Puigjaner, “Fluidized-bed co-gasification of residual biomass/poor coal blends for fuel gas production,” Fuel, vol. 79, no. 11, pp. 1317–1326, 2000.
[8]
J. J. Hernández, G. Aranda-Almansa, and C. Serrano, “Co-gasification of biomass wastes and coal-coke blends in an entrained flow gasifier: an experimental study,” Energy and Fuels, vol. 24, no. 4, pp. 2479–2488, 2010.
[9]
M. W. Seo, J. H. Goo, S. D. Kim, S. H. Lee, and Y. C. Choi, “Gasification characteristics of coal/biomass blend in a dual circulating fluidized bed reactor,” Energy and Fuels, vol. 24, no. 5, pp. 3108–3118, 2010.
[10]
G. Gordillo, K. Annamalai, and N. Carlin, “Adiabatic fixed-bed gasification of coal, dairy biomass, and feedlot biomass using an air-steam mixture as an oxidizing agent,” Renewable Energy, vol. 34, no. 12, pp. 2789–2797, 2009.
[11]
N. Koukouzas, A. Katsiadakis, E. Karlopoulos, and E. Kakaras, “Co-gasification of solid waste and lignite—a case study for Western Macedonia,” Waste Management, vol. 28, no. 7, pp. 1263–1275, 2008.
[12]
C. B. Field, J. E. Campbell, and D. B. Lobell, “Biomass energy: the scale of the potential resource,” Trends in Ecology and Evolution, vol. 23, no. 2, pp. 65–72, 2008.
[13]
K. Stecher, A. Brosowski, and D. Thr？n, Biomass Potential in Africa, IRENA-DBFZ, Abu Dhabi, United Arab Emirates, 2013.
[14]
P. Molcan, G. Lu, T. L. Bris, Y. Yan, B. Taupin, and S. Caillat, “Characterisation of biomass and coal co-firing on a 3 MWth Combustion Test Facility using flame imaging and gas/ash sampling techniques,” Fuel, vol. 88, no. 12, pp. 2328–2334, 2009.
[15]
A. Kumar, D. D. Jones, and M. A. Hanna, “Thermochemical biomass gasification: a review of the current status of the technology,” Energies, vol. 2, no. 3, pp. 556–581, 2009.
[16]
A. Bhagavatula, G. Huffman, N. Shah, and R. Honaker, “Evaluation of thermal evolution profiles and estimation of kinetic parameters for pyrolysis of coal/corn stover blends using thermogravimetric analysis,” Journal of Fuels, vol. 2014, Article ID 914856, 12 pages, 2014.
[17]
A. Magdziarz and M. Wilk, “Thermal characteristics of the combustion process of biomass and sewage sludge,” Journal of Thermal Analysis and Calorimetry, vol. 114, no. 2, pp. 519–529, 2013.
[18]
P. Wang, S. Hedges, K. Casleton, and C. Guenther, “Thermal behavior of coal and biomass blends in inert and oxidizing gaseous environments,” International Journal of Clean Coal and Energy, vol. 1, pp. 35–42, 2012.
[19]
L. Wilson and H. Iddi, Scientific and Technical Cooperation between Tanzania Industrial Research and Development Organization (TIRDO) of Tanzania and the Council of Science and Industrial Research (CSIR) of India, TIRDO, 2014.
[20]
E. Biagini, A. Fantei, and L. Tognotti, “Effect of the heating rate on the devolatilization of biomass residues,” Thermochimica Acta, vol. 472, no. 1-2, pp. 55–63, 2008.
[21]
A. Volborth, G. E. Miller, C. K. Garner, and P. A. Jerabek, “Oxygen determination and stoichiometry of some coals,” in Proceedings of the American Chemical Society Meeting, Division of Fuel Chemistry, Chicago, Ill, USA, 1977.
[22]
S. C. Turmanova, S. D. Genieva, A. S. Dimitrova, and L. T. Vlaev, “Non-isothermal degradation kinetics of filled with rise husk ash polypropene composites,” Express Polymer Letters, vol. 2, no. 2, pp. 133–146, 2008.
[23]
P. J. Haines, Principles of Thermal Analysis and Calorimetry, vol. 30, Royal Society of Chemistry, 2002.
[24]
M. Menzinger and R. Wolfgang, “The meaning and use of the Arrhenius activation energy,” Angewandte Chemie International Edition, vol. 8, no. 6, pp. 438–444, 1969.
[25]
G. Raj, Chemical Kinetics, Krishna Prakashan Media, Uttar Pradesh, India, 8th edition, 2010.
[26]
L. Zhou, Y. Wang, Q. Huang, and J. Cai, “Thermogravimetric characteristics and kinetic of plastic and biomass blends co-pyrolysis,” Fuel Processing Technology, vol. 87, no. 11, pp. 963–969, 2006.
[27]
A. W. Coats and J. P. Redfern, “Kinetic parameters from thermogravimetric data,” Nature, vol. 201, no. 4914, pp. 68–69, 1964.
[28]
C. Di Blasi, “Modeling chemical and physical processes of wood and biomass pyrolysis,” Progress in Energy and Combustion Science, vol. 34, no. 1, pp. 47–90, 2008.
[29]
A. K. Sadhukhan, P. Gupta, and R. K. Saha, “Modelling and experimental studies on pyrolysis of biomass particles,” Journal of Analytical and Applied Pyrolysis, vol. 81, no. 2, pp. 183–192, 2008.
[30]
Y. G. Pan, E. Velo, and L. Puigjaner, “Pyrolysis of blends of biomass with poor coals,” Fuel, vol. 75, no. 4, pp. 412–418, 1996.
[31]
E. Sima-Ella, G. Yuan, and T. Mays, “A simple kinetic analysis to determine the intrinsic reactivity of coal chars,” Fuel, vol. 84, no. 14-15, pp. 1920–1925, 2005.
[32]
J. Fermoso, B. Arias, M. V. Gil et al., “Co-gasification of different rank coals with biomass and petroleum coke in a high-pressure reactor for H2-rich gas production,” Bioresource Technology, vol. 101, no. 9, pp. 3230–3235, 2010.
[33]
Z. M. Zakaria, M. A. Mohd Ishak, M. F. Abdullah, and K. Ismail, “Thermal decomposition study of coals, rice husk, rice husk char and their blends during pyrolysis and combustion via thermogravimetric analysis,” International Journal of Chemical Technology, vol. 2, no. 3, pp. 78–87, 2010.
[34]
A. K. Sadhukhan, P. Gupta, T. Goyal, and R. K. Saha, “Modelling of pyrolysis of coal-biomass blends using thermogravimetric analysis,” Bioresource Technology, vol. 99, no. 17, pp. 8022–8026, 2008.
[35]
C. Higman and M. van der Burgt, Gasification, Elsevier Science, New York, NY, USA, 2003.
[36]
P. T. Williams and S. Besler, “The pyrolysis of rice husks in a thermogravimetric analyser and static batch reactor,” Fuel, vol. 72, no. 2, pp. 151–159, 1993.
[37]
K. Raveendran, A. Ganesh, and K. C. Khilar, “Pyrolysis characteristics of biomass and biomass components,” Fuel, vol. 75, no. 8, pp. 987–998, 1996.
[38]
S. S. Idris, N. A. Rahman, K. Ismail, A. B. Alias, Z. A. Rashid, and M. J. Aris, “Investigation on thermochemical behaviour of low rank Malaysian coal, oil palm biomass and their blends during pyrolysis via thermogravimetric analysis (TGA),” Bioresource Technology, vol. 101, no. 12, pp. 4584–4592, 2010.
[39]
M. V. Gil, D. Casal, C. Pevida, J. J. Pis, and F. Rubiera, “Thermal behaviour and kinetics of coal/biomass blends during co-combustion,” Bioresource Technology, vol. 101, no. 14, pp. 5601–5608, 2010.
[40]
T. Sonobe, P. Suneerat, and N. Worasuwannarak, “Pyrolysis characteristics of Thai-agricultural residues of rice straw, rice husk, and corncob by TG-MS technique and kinetic analysis,” in Proceedings of the 2nd Joint International Conference on “Sustainable Energy and Environment (SEE '06)”, Bangkok, Thailand, November 2006.
[41]
H. Haykiri-Acma and S. Yaman, “Interaction between biomass and different rank coals during co-pyrolysis,” Renewable Energy, vol. 35, no. 1, pp. 288–292, 2010.
[42]
J. Cai, Y. Wang, L. Zhou, and Q. Huang, “Thermogravimetric analysis and kinetics of coal/plastic blends during co-pyrolysis in nitrogen atmosphere,” Fuel Processing Technology, vol. 89, no. 1, pp. 21–27, 2008.
[43]
H. B. Vuthaluru, “Investigations into the pyrolytic behaviour of coal/biomass blends using thermogravimetric analysis,” Bioresource Technology, vol. 92, no. 2, pp. 187–195, 2004.
[44]
M. Zhang and F. Min, “Pyrolysis characteristics and kinetics of fresh biomass with different initial moisture,” in Proceedings of the 41st Annual Conference, Bowling Green, Ky, USA, August 2013.
[45]
E. A. Evans and K. Ritchie, “Strength of a weak bond connecting flexible polymer chains,” Biophysical Journal, vol. 76, no. 5, pp. 2439–2447, 1999.
