The National Energy Technology Laboratory is investigating a new process for CO2 capture from large sources such as utility power generation facilities as an alternative to liquid amine based adsorption processes. Many of these advanced dry processes are based upon sorbents composed of supported polyamines. In this analysis, experiments have been conducted in a laboratory-scale fluidized bed reactor and compared to CFD reactor predictions using kinetics obtained from TGA tests. Batch experiments were conducted by flowing a mixture of CO2, H2O, and N2 (simulated flue gas) through a fluidized bed of sorbent material. The exit gas composition time series data is compared to CFD simulations using a 3-dimensional nonisothermal reacting multiphase flow model. The effects of the gas flow rate, distributor design, and particle size are explored through the CFD simulations. It is shown that the time duration for CO2 adsorption decreased for an increase in the gas flow. Fluid bed hydrodynamics indicated that there were regions in the reactor where the inert FCC particles segregated and defluidized; without adversely affecting the capacity of the sorbent to adsorb CO2. The details of the experimental facility and the model as well as the comparative analysis between the data and the simulation results are discussed. 1. Introduction Over the past two to three decades, there has been increasing concern over the importance of carbon dioxide emissions to the environment and the possible effect these emissions have on global climate shifting. Historical atmospheric CO2 levels have been greater and less than the preindustrialized values shown in Figure 1 [1]. Also shown in Figure 1 are the CO2 concentration levels over the past 30 years [2]. These values start in 1980 with a concentration of 338?ppm, already outside the normal range over the past 400,000 years, and increase to a value of 392?ppm in 2012, the last year that data exist. Based on these CO2 numbers there is little doubt that CO2 is higher now than in the recent past. Extrapolating the trend in the data taken over the past 30 years backwards (Figure 1) this trend intersects with that of the historical data in the time frame of the beginning of the industrial age. This implies with strong confidence that the increased values of CO2 are likely caused from human activity. The recent divergence between the temperature data and the CO2 concentration data refutes assertions that global warming can be attributed to increased CO2 concentration as does the trend in the temperature variation between 1940 and the late
References
[1]
J.-M. Barnola, D. Raynaud, C. Lorius, and N. I. Barkov, “Historical CO2 record from the Vostok ice core,” in Trends: A Compendium of Data on Global Change, Carbon Dioxide Information Analysis Center, Oak Ridge National Laboratory, U.S. Department of Energy, Oak Ridge, Tenn, US.A, 2003.
[2]
J. Hansen, M. Sato, and R. Ruedy, “Global Temperature Update Through 2013,” 2014, http://www.columbia.edu/~jeh1/mailings/2014/20140121_Temperature2013.pdf.
[3]
E. Dlugokencky and P. Tans, NOAA/ESRL, http://www.esrl.noaa.gov/gmd/ccgg/trends/.
[4]
J. Ciferno, J. Litynski, L. Brickett et al., DOE/NETL Advanced CO2 Capture R&D Program: Technology Update, U.S. Department of Energy, 2011.
[5]
T. F. Wall, “Combustion processes for carbon capture,” Proceedings of the Combustion Institute, vol. 31, pp. 31–47, 2007.
[6]
A. A. Olajire, “CO2 capture and separation technologies for end-of-pipe applications—a review,” Energy, vol. 35, no. 6, pp. 2610–2628, 2010.
[7]
M. B. Toftegaard, J. Brix, P. A. Jensen, P. Glarborg, and A. D. Jensen, “Oxy-fuel combustion of solid fuels,” Progress in Energy and Combustion Science, vol. 36, no. 5, pp. 581–625, 2010.
[8]
E. J. Anthony, “Solid looping cycles: a new technology for coal conversion,” Industrial and Engineering Chemistry Research, vol. 47, no. 6, pp. 1747–1754, 2008.
[9]
J. Blamey, E. J. Anthony, J. Wang, and P. S. Fennell, “The calcium looping cycle for large-scale CO2 capture,” Progress in Energy and Combustion Science, vol. 36, no. 2, pp. 260–279, 2010.
[10]
N. Rodríguez, M. Alonso, J. C. Abanades et al., “Comparison of experimental results from three dual fluidized bed test facilities capturing CO2 with CaO,” Energy Procedia, vol. 4, pp. 393–401, 2011.
[11]
A. Sayari, Y. Belmabkhout, and R. Serna-Guerrero, “Flue gas treatment via CO2 adsorption,” Chemical Engineering Journal, vol. 171, no. 3, pp. 760–774, 2011.
[12]
M. M. F. Hasan, R. C. Baliban, J. A. Elia, and C. A. Floudas, “Modeling, simulation, and optimization of postcombustion CO2 capture for variable feed concentration and flow rate. 2. Pressure swing adsorption and vacuum swing adsorption processes,” Industrial and Engineering Chemistry Research, vol. 51, no. 48, pp. 15665–15682, 2012.
[13]
A. L. Chaffee, G. P. Knowles, Z. Liang, J. Zhang, P. Xiao, and P. A. Webley, “CO2 capture by adsorption: Materials and process development,” International Journal of Greenhouse Gas Control, vol. 1, no. 1, pp. 11–18, 2007.
[14]
J. Schell, N. Casas, D. Marx, and M. Mazzotti, “Precombustion CO2 capture by pressure swing adsorption (PSA): comparison of laboratory PSA experiments and simulations,” Industrial and Engineering Chemistry Research, vol. 52, no. 24, pp. 8311–8322, 2013.
[15]
L. Wang, Y. Yang, W. Shen, et al., “CO2 capture from flue gas in an existing coal-fired power plant by two successive pilot-scale VPSA units,” Industrial & Engineering Chemistry Research, vol. 52, no. 23, pp. 7947–7955, 2013.
[16]
G. D. Pirngruber and D. Leinekugel-Le-Cocq, “Design of a pressure swing adsorption process for postcombustion CO2 capture,” Industrial and Engineering Chemistry Research, vol. 52, no. 17, pp. 5985–5996, 2013.
[17]
R. V. Siriwardane, C. Robinson, M. Shen, and T. Simonyi, “Novel regenerable sodium-based sorbents for CO2 capture at warm gas temperatures,” Energy & Fuels, vol. 21, no. 4, pp. 2088–2097, 2007.
[18]
D. J. Fauth, M. L. Gray, H. W. Pennline, H. M. Krutka, S. Sjostrom, and A. M. Ault, “Investigation of porous silica supported mixed-amine sorbents for post-combustion CO2 capture,” Energy and Fuels, vol. 26, no. 4, pp. 2483–2496, 2012.
[19]
M. L. Gray, K. J. Champagne, D. Fauth, J. P. Baltrus, and H. Pennline, “Performance of immobilized tertiary amine solid sorbents for the capture of carbon dioxide,” International Journal of Greenhouse Gas Control, vol. 2, no. 1, pp. 3–8, 2008.
[20]
M. L. Gray, J. S. Hoffman, D. C. Hreha et al., “Parametric study of solid amine sorbents for the capture of carbon dioxide,” Energy and Fuels, vol. 23, pp. 4840–4844, 2012.
[21]
A. Lee, D. Mebane, D. J. Fauth, and D. C. Miller, “A model for the adsorption kinetics of CO2 on amine-impregnated mesoporous sorbents in the presence of water,” in Proceedings of the 28th Annual International Pittsburgh Coal Conference (PCC '11), pp. 355–365, September 2011.
[22]
S. Sjostrom, H. Krutka, T. Starns, and T. Campbell, “Pilot test results of post-combustion CO2 capture using solid sorbents,” Energy Procedia, vol. 4, pp. 1584–1592, 2011.
[23]
S. Sjostrom and H. Krutka, “Evaluation of solid sorbents as a retrofit technology for CO2 capture,” Fuel, vol. 89, no. 6, pp. 1298–1306, 2010.
[24]
E. R. Monazam, J. Spenik, and L. J. Shadle, “Fluid bed adsorption of carbon dioxide on immobilized polyethylenimine (PEI): kinetic analysis and breakthrough behavior,” Chemical Engineering Journal, vol. 223, pp. 795–805, 2013.
[25]
A. Samanta, A. Zhao, G. K. H. Shimizu, P. Sarkar, and R. Gupta, “Post-combustion CO2 capture using solid sorbents: a review,” Industrial & Engineering Chemistry Research, vol. 51, no. 4, pp. 1438–1463, 2012.
[26]
S. Choi, J. H. Drese, and C. W. Jones, “Adsorbent materials for carbon dioxide capture from large anthropogenic point sources,” ChemSusChem, vol. 2, no. 9, pp. 796–854, 2009.
[27]
J. S. Hoffman, G. A. Richards, H. W. Pennline, D. Fischer, and G. Keller, “Factors in reactor design for carbon capture with solid regenerable sorbents,” in Proceedings of the 33rd International Technical Conference on Coal Utilization and Fuel Systems, Clearwater, Fla, USA, June 2008.
[28]
E. R. Monazam, J. Spenik, and L. J. Shadle, “CO2 desorption kinetics for immobilized polyethylenimine (PEI),” Energy and Fuels, vol. 28, no. 1, pp. 650–656, 2014.
[29]
E. R. Monazam, L. J. Shadle, D. C. Miller et al., “Equilibrium and kinetics analysis of carbon dioxide capture using immobilized amine on a mesoporous silica,” AIChE Journal, vol. 59, no. 3, pp. 923–935, 2013.
[30]
R. Garg, E. D. Huckaby, and M. Shahnam, “CFD simulation of CO2 capture by solid sorbent,” in Proceedings of the 7th International Conference on Multiphase Flow, vol. 30, Tampa, Fla, USA, May-June 2010.
[31]
K. K. Saha and E. D. Huckaby, “Eulerian-Eulerian simulations of dual fluidized bed reactor for CO2 capture,” in Proceedings of the AIChE Annual Meeting, October 2011.
[32]
R. W. Breault and E. D. Huckaby, “Parametric behavior of a CO2 capture process: CFD simulation of solid-sorbent CO2 absorption in a riser reactor,” Applied Energy, vol. 112, pp. 224–234, 2013.
[33]
E. M. Ryan, D. DeCroix, R. Breault et al., “Multi-phase CFD modeling of solid sorbent carbon capture system,” Powder Technology, vol. 242, pp. 117–134, 2013.
[34]
E. Abbasi and H. Arastoopour, “CFD simulation of CO2 sorption in a circulating fluidized bed using deactivation kinetic model,” in Proceedings of the 10th International Conference on Circulating Fluidized Beds and Fluidization Technology, May 2011.
M. J. Andrews and P. J. O'Rourke, “The multiphase particle-in-cell (MP-PIC) method for dense particulate flows,” International Journal of Multiphase Flow, vol. 22, no. 2, pp. 379–402, 1996.
[37]
D. M. Snider, “An incompressible three-dimensional multiphase particle-in-cell model for dense particle flows,” Journal of Computational Physics, vol. 170, no. 2, pp. 523–549, 2001.
[38]
P. J. O'Rourke and D. M. Snider, “An improved collision damping time for MP-PIC calculations of dense particle flows with applications to polydisperse sedimenting beds and colliding particle jets,” Chemical Engineering Science, vol. 65, no. 22, pp. 6014–6028, 2010.
[39]
D. M. Snider, S. M. Clark, and P. J. O'Rourke, “Eulerian-Lagrangian method for three-dimensional thermal reacting flow with application to coal gasifiers,” Chemical Engineering Science, vol. 66, no. 6, pp. 1285–1295, 2011.
[40]
D. Snider and S. Banerjee, “Heterogeneous gas chemistry in the CPFD Eulerian-Lagrangian numerical scheme (ozone decomposition),” Powder Technology, vol. 199, no. 1, pp. 100–106, 2010.
[41]
T. B. Anderson and R. Jackson, “Fluid mechanical description of fluidized beds. Equations of motion,” Industrial & Engineering Chemistry Fundamentals, vol. 6, no. 4, pp. 527–539, 1967.
[42]
R. Jackson, The Dynamics of Fluidized Particles, Cambridge University Press, Cambridge, UK, 2000.
[43]
J. Smagorinsky, “General circulation experiments with the primitive equations,” Monthly Weather Review, vol. 91, no. 3, pp. 99–164, 1963.