Rising damp is one of the most severe phenomena that leads to decay and deterioration of both old and modern types of buildings. This study employed a holistic approach to dampness investigation and sought to examine the problem of rising damp in the walls of two residential apartments in Kumasi, Ghana. The study sought to determine the types of soluble salts and their concentrations in the soils and accumulated percentages in the walls over time and whether there exists any linkage between the salts in the walls and those in the ground. Results from the geotechnical survey of the building sites found that the soils on site 1 consisted of silty sandy gravel with some clay particles and those on site 2 consisted of silty sandy soil with some clay and traces of gravel. The study identified several groups of salts in the walls of the buildings, with the most damaging and dangerous being magnesium sulphate, magnesium chloride, and sodium sulphate salts. Similar salts were identified in the soil samples from the trial pits. The results therefore indicate a linkage between the salts found in the ground and those found in the walls and therefore confirm the presence of rising dampness. 1. Introduction All buildings are expected to be constructed with materials which have the tendency to resist the effects of water throughout their service lives [1]. For buildings to perform this function, there is the need for correct design and maintenance throughout their service lives [1]. Moisture that should not be present in buildings is known as dampness [2]. Buildings are said to have dampness problems when the materials in the buildings become sufficiently damp, leading to materials damage or visible mold growth [2]. Ghana, a country with hotter and drier climate, has experienced dampness for several years [3]. In a study to identify the most dominant type(s) of dampness in residential buildings in Ghana, all the surveyed buildings were identified to have symptoms related to either rising dampness, condensation, or water penetration (including leakages) [3]. However, the most dominant type of dampness was found to be rising dampness as it was identified with many of the buildings surveyed [3]. Hygroscopic salts that led to surface efflorescence, decayed skirting, dampness below 1.5？m, and mold growth on walls up to 1？m high were among the symptoms identified with rising dampness in the surveyed buildings. The study recommended a more detailed investigation on selected buildings to identify the root cause of the problem. This paper involves a laboratory study to
References
[1]
U. S. Yilmaz, M. Dereli, S. Korur, and Z. Korkmaz, “Water based damages on building faces and solution proposals,” BALWOIS 2010, Ohrid, Republic of Macedonia, pp. 1–7, May 2010.
[2]
R. Burkinshaw and M. Parrett, Diagnosing Damp, Rics—Royal Institution of Chartered Surveyors Books, Coventry, UK, 2004.
[3]
K. Agyekum, J. Ayarkwa, C. Koranteng, and E. Adinyira, “Preliminary assessment of dampness in walls of residential buildings in four climatic zones in Ghana,” Journal of Sustainable Development, vol. 6, no. 9, pp. 51–61, 2013.
[4]
C. Gentilini, E. Franzoni, S. Bandini, and L. Nobile, “Effect of salt crystallisation on the shear behaviour of masonry walls: an experimental study,” Construction and Building Materials, vol. 37, pp. 181–189, 2012.
[5]
P. B. Louren？o, E. Luso, and M. G. Almeida, “Defects and moisture problems in buildings from historical city centres: a case study in Portugal,” Building and Environment, vol. 41, no. 2, pp. 223–234, 2006.
[6]
E. Rirsch and Z. Zhang, “Rising damp in masonry walls and the importance of mortar properties,” Construction and Building Materials, vol. 24, no. 10, pp. 1815–1820, 2010.
[7]
G. Alfano, C. Chiancarella, E. Cirillo, I. Fato, and F. Martellotta, “Long-term performance of chemical damp-proof courses: twelve years of laboratory testing,” Building and Environment, vol. 41, no. 8, pp. 1060–1069, 2006.
[8]
R. Burkinshaw, “Rising damp: part 1. Case study examples and the Lambeth Pier Test: how to isolate ground-sourced rising damp by the “Burkinshaw Test Method”,” Journal of Building Survey, Appraisal & Valuation, vol. 1, no. 1, pp. 1–15, 2012.
[9]
D. Young, Salt Attack and Rising Damp: A Guide to Salt Damp in Historic and Older Buildings, Heritage Council of NSW-Heritage, Victoria, Australia, 2008.
[10]
D. Young, “The need to get the salt out: dealing with rising damp and salt attack,” http://filesdown.esecure.co.uk/Lectros/Get_The_Salt_Out_David_Young_OAM_BAppSc.pdf_01122008-1110-45.pdf.
[11]
Y. Hamid and S. Ngah, “Assessment of dampness problems in the higher education institution building,” in Proceedings of the 12th International Surveyor's Congress (Reaching 50 and Surveying Ahead), Kuala Lumpur, Malaysia, June 2010.
[12]
A. G. Ahmed and F. Abdul Rahman, “Treatment of salt attack and rising damp in heritage buildings in Penang, Malaysia,” Journal of Construction in Developing Countries, vol. 15, pp. 93–113, 2010.
[13]
British Research Establishment (BRE), Good Repair Guide 6, Treating Rising Damp in Houses, BRE Press, 1997.
[14]
J. Hetreed, The Damp House: A Guide to the Causes and Treatment of Dampness, 2008.
[15]
Z. Zhang, A review of rising damp in masonry building.
[16]
H. W. Harrison and P. Trotman, Foundations, Basements and External Works, BRE Building Elements, London, UK, 2002.
[17]
P. Trotman, C. Sanders, and H. Harrison, Understanding Dampness, BRE Bookshop, 2004.
[18]
P. Maravelaki-Kalaitzaki, A. Bakolas, I. Karatasios, and V. Kilikoglou, “Hydraulic lime mortars for the restoration of historic masonry in Crete,” Cement and Concrete Research, vol. 35, no. 8, pp. 1577–1586, 2005.
[19]
F. Moreno, S. A. G. Vilela, ？. S. G. Antunes, and C. A. S. Alves, “Capillary-rising salt pollution and granitic stone erosive decay in the parish church of Torre de Moncorvo (NE Portugal)-implications for conservation strategy,” Journal of Cultural Heritage, vol. 7, no. 1, pp. 56–66, 2006.
[20]
World Health Organisation, Guidelines for Indoor Air Quality: Dampness and Mould, WHO, 2009.
[21]
B. H. Abu Bakar, M. H. Wan Ibrahim, and M. A. Megat Johari, “A review: durability of fired clay brick masonry wall due to salt attack,” International Journal of Integrated Engineering, vol. 1, no. 2, pp. 111–127, 2011.
[22]
J. W. Jordan, “Factors in the selection of mortar for conservation of histroric masonry,” in Proceedings of the 6th Australasian Masonry Conference, Adelaide, Australia, 2001.
[23]
A. E. Charola, “Salts in the deterioration of porous materials: an overview,” Journal of the American Institute for Conservation, vol. 39, pp. 327–343, 2000.
[24]
A. Arnold and K. Zehnder, “Crystallization and habits of salt efflorescences on walls II. Conditions of crystallization,” in Proceedings of the 5th International Congress on the Deterioration and Conservation of Stone, G. Felix, Ed., pp. 269–277, Presses Polytechniques Romandes, 1985.
[25]
A. Arnold, “Rising damp and saline minerals,” in Proceedings of the 4th International Congress on the Deterioration and Preservation of Stone Objects, K. L. Gauri and J. A. Gwinn, Eds., pp. 11–28, University of Louisville, Loiusville, Ky, USA, 1982.
[26]
M. Steiger, A. Behlen, H. Neumann, U. Willers, and C. Wittenberg, “Sea salts in historic buildings: deposition, transport and accumulation,” in Proceedings of the 4th International Symposium on the 4th InternationalSymposium on the Conservation of Monuments in the Mediterranean Basin, Rhodes, Greece, May 1997.
[27]
S. H. Perry and A. P. Duffy, “The short-term effects of mortar joints on salt movement in stone,” Atmospheric Environment, vol. 31, no. 9, pp. 1297–1305, 1997.
[28]
City of Adelaide, Department of Environment and Natural Resources, 1997, http://www.buildingconservation.com/.
[29]
R. M. Espinosa, L. Franke, and G. Deckelmann, “Phase changes of salts in porous materials: crystallization, hydration and deliquescence,” Construction and Building Materials, vol. 22, no. 8, pp. 1758–1773, 2008.
[30]
L. A. Rijniers, L. Pel, H. P. Huinink, and K. Kopinga, “Salt crystallization as damage mechanism in porous building materials—a nuclear magnetic resonance study,” Magnetic Resonance Imaging, vol. 23, no. 2, pp. 273–276, 2005.
[31]
A. Buchwald and C. Kaps, “The ion mobility of deteriorating salts in masonry materials of different moisture content, materials for building and structures,” in Proceedings of the European Congress on Advanced Materials and Processes in conjunction with the Exhibition Materialica (Euromat '99), vol. 6, pp. 157–162.
[32]
S. Carillion, Defects in Buildings: Symptoms, Investigations, Diagnosis and Cure, The Stationary Office, London, UK, 2001.
[33]
A. A. Halim, S. N. Harun, and Y. Hamid, “Diagnosis of dampness in conservation of historic buildings,” Journal of Design + Built, vol. 5, 2012.
[34]
E. Borrelli, Conservation of Architectural Heritage, Historic Structures and Material, ARC Laboratory Handbook, ICCROM, 1999.
[35]
British Standard Code, BS 5930:1999 Code of Practice for Site Investigations, 1999.
[36]
American Society of Civil Engineers (ASCE), “Subsurface investigation for design and construction of foundations of buildings,” Manuals and Reports on Engineering Practice 56, 1976.
[37]
American Society of Civil Engineers (ASCE), Subsurface Exploration for Underground Excavation and Heavy Construction, Proceedings of a Specialty Conference, American Society of Civil Engineers, 1974.
[38]
R. Burkinshaw, “Rising damp: part 1. Case study examples and the Lambeth Pier Test: how to isolate ground-sourced rising damp by the “Burkinshaw Test Method”,” Journal of Building Survey, Appraisal & Valuation, vol. 1, no. 1, pp. 1–15, 2011.
[39]
“British Standard Code. Methods of tests for soils for civil engineering purposes,” Tech. Rep. BS 1377, 1990.
[40]
H. de Clercq, “The effect of other salts on the crystallization damage to stone caused by sodium sulphate,” in Proceedings of the Salt Weathering on Buildings and Stone Sculptures, pp. 22–24, Copenhagen, Denmark, October 2008.
[41]
S. Zsembery, Manual 2: The Properties of Clay Masonry Units, Clay Brick and Paver Institution, Baulkham Hills, Australia, 2001.
[42]
L. Bucea, V. Sirivivatnanom, and R. Khatri, “Building materials deterioration due to salt attack,” Laboratory Experimental Program, Internal Technical Report, CSIRO Manufacturing and Infrastructure Technology, 2005.
[43]
B. Lubelli, R. P. J. van Hees, and C. J. W. P. Groot, “Sodium chloride crystallization in a “salt transporting” restoration plaster,” Cement and Concrete Research, vol. 36, no. 8, pp. 1467–1474, 2006.
[44]
R. Snethlage and E. Wendler, “Moisture cycles and sandstone degradation,” in Saving Our Architectural Heritage: The Conservation of Historic Stone Structures, N. S. Baer and R. Snethlage, Eds., pp. 7–24, John Wiley & Sons, Chichester, UK, 1997.
[45]
S. Z. Lewin, “The mechanism of masonry decay through crystallization,” in Conservation of Historic Stone Buildings and Monuments, pp. 120–144, National Academy Press, Washington, DC, USA, 1978.
[46]
D. Benavente, J. Martínez-Martínez, N. Cueto, and M. A. García-del-Cura, “Salt weathering in dual-porosity building dolostones,” Engineering Geology, vol. 94, no. 3-4, pp. 215–226, 2007.
[47]
T. T. Van, K. Beck, and M. Al-Mukhtar, “Accelerated weathering tests on two highly porous limestones,” Environmental Geology, vol. 52, no. 2, pp. 283–292, 2007.
[48]
M. Steiger, “Salts in porous materials: thermodynamics of phase transitions, modelling and preventive conservation,” Restoration of Buildings and Monuments, vol. 11, no. 6, pp. 419–431, 2005.
[49]
A. La Iglesia, V. González, V. López-Acevedo, and C. Viedma, “Salt crystallization in porous construction materials I estimation of crystallization pressure,” Journal of Crystal Growth, vol. 177, no. 1-2, pp. 111–118, 1997.
[50]
L. Pel, H. Huinink, and K. Kopinga, “Salt transport and crystallization in porous building materials,” Magnetic Resonance Imaging, vol. 21, no. 3-4, pp. 317–320, 2003.
[51]
P. E. Merrigan, “Efflorescence, causes and control,” The Masonry Society Journal, vol. 5, no. 1, 1986.
[52]
M. H. W. Ibrahim, B. H. Abu Bakar, M. A. Megat Johari, R. Putra Jaya, and M. F. Ashad, “The Effect of sodium sulphate and sodium chloride solutions on the moisture movement of fired clay masonry wall,” International Journal of Sustainable Construction Engineering and Technology, vol. 2, no. 1, pp. 11–23, 2011.
