A simple and high sensitive preconcentration method based on micelle-mediated extraction followed by high performance liquid chromatography (LC-UV) was developed for preconcentration and determination of trace amounts of bisphenol A (BPA) in aqueous samples. The BPA was quantitatively extracted from aqueous samples in the presence of Triton X-114 as a nonionic surfactant and preconcentrated into the small volume (about 30?μL) of the surfactant-rich phase. Taguchi method, an orthogonal array design (OA16 (45)), was utilized to optimize the various factors affecting the micellar extraction of BPA. The maximum extraction efficiency of BPA was obtained at pH 3, 0.2% (w/v) Triton X-114, and 0.25?mol?L?1 sodium acetate. For the preconcentration, the solutions were incubated in a thermostatic water bath at 50°C for 7?min. After centrifuge and separation of aqueous phase, the surfactant-rich phase was diluted with 100?μL acetone and injected in the chromatographic system. Under the optimum conditions, preconcentration factor of 34.9 was achieved for extraction from 10?mL of sample solution and the relative standard deviation (RSD%) of the method was lower than 6.6%. The calibration curve was linear in the range of 0.5–150?μg?L?1 with reasonable linearity ( ). The limit of detection (LOD) based on = 3 was 0.13?μg?L?1 for 10?mL sample volumes. The limit of quantification (LOQ) based on = 10 was 0.43?μg?L?1 for 10?mL sample volumes. Finally, the applicability of the proposed method was evaluated by the extraction and determination of BPA in the real samples, and satisfactory results were obtained. 1. Introduction The distribution and abundance of plastic particles in the environment have rapidly increased, and the adverse effects of chemicals that leach from the plastic debris on aquatic animals have been of great concern [1, 2]. It is well known that 4,4-(1-methylethylidene) bisphenol or 2,2-(4,4-dihydroxydiphenyl) propane (commonly named bisphenol A; BPA) has estrogenic activity [3, 4]. BPA is a monomer widely used in the manufacture of epoxy and phenolic resins, as stabilizing material or antioxidant for numerous types of plastics including polyvinyl chloride [5, 6]. It is also used in polycarbonates, polyacrylates, and corrosion-resistant unsaturated polyester-styrene resins. BPA has been found to be widely distributed in the environment, because of highly production of plastics [7, 8]. BPA is leached from lacquer-coated cans [4], polycarbonate flasks during autoclaving, and baby feeding bottles [9] due to the hydrolysis of the polymer during thermal treatment
References
[1]
C. S. Wong, D. R. Green, and W. J. Cretney, “Quantitative tar and plastic waste distributions in the Pacific Ocean,” Nature, vol. 247, no. 5435, pp. 30–32, 1974.
[2]
J. B. Colton, F. D. Knapp, and B. R. Burns, “Plastic particles in surface waters of the Northwestern Atlantic,” Science, vol. 185, no. 4150, pp. 491–497, 1974.
[3]
A. V. Krishnan, P. Stathis, S. F. Permuth, L. Tokes, and D. Feldman, “Bisphenol-A: an estrogenic substance is released from polycarbonate flasks during autoclaving,” Endocrinology, vol. 132, no. 6, pp. 2279–2286, 1993.
[4]
J. A. Brotons, M. F. Olea-Serrano, M. Villalobos, V. Pedraza, and N. Olea, “Xenoestrogens released from lacquer coatings in food cans,” Environmental Health Perspectives, vol. 103, no. 6, pp. 608–612, 1995.
[5]
M. Ash and I. Ash, Handbook of Plastic and Rubber Additives, Gower, Hampshire, UK, 1995.
[6]
C. M. Chang, C. C. Chou, and M. R. Lee, “Determining leaching of bisphenol A from plastic containers by solid-phase microextraction and gas chromatography-mass spectrometry,” Analytica Chimica Acta, vol. 539, no. 1-2, pp. 41–47, 2005.
[7]
Environmental agency of Japan. Chemicals in the environment, 1997.
[8]
T. Yamamoto, A. Yasuhara, H. Shiraishi, and O. Nakasugi, “Bisphenol A in hazardous waste landfill leachates,” Chemosphere, vol. 42, no. 4, pp. 415–418, 2001.
[9]
J. E. Biles, T. P. McNeal, T. H. Begley, and H. C. Hollifield, “Determination of bisphenol-A in reusable polycarbonate food-contact plastics and migration to food-simulating liquids,” Journal of Agricultural and Food Chemistry, vol. 45, no. 9, pp. 3541–3544, 1997.
[10]
P. Parez, R. Pulgar, F. Olea-Serrano et al., “The estrogenicity of bisphenol A-related diphenylalkanes with various substituents at the central carbon and the hydroxy groups,” Environmental Health Perspectives, vol. 106, no. 3, pp. 167–174, 1998.
[11]
S. C. Nagel, F. S. Vom Saal, K. A. Thayer, M. G. Dhar, M. Boechler, and W. V. Welshons, “Relative binding affinity-serum modified access (RBA-SMA) assay predicts the relative in vivo bioactivity of the xenoestrogens bisphenol A and octylphenol,” Environmental Health Perspectives, vol. 105, no. 1, pp. 70–76, 1997.
[12]
J. L. Vílchez, A. Zafra, A. González-Casado, E. Hontoria, and M. Del Olmo, “Determination of trace amounts of bisphenol F, bisphenol A and their diglycidyl ethers in wastewater by gas chromatography-mass spectrometry,” Analytica Chimica Acta, vol. 431, no. 1, pp. 31–40, 2001.
[13]
M. Rezaee, Y. Yamini, S. Shariati, A. Esrafili, and M. Shamsipur, “Dispersive liquid-liquid microextraction combined with high-performance liquid chromatography-UV detection as a very simple, rapid and sensitive method for the determination of bisphenol A in water samples,” Journal of Chromatography A, vol. 1216, no. 9, pp. 1511–1514, 2009.
[14]
U. Bolz, W. K?rner, and H. Hagenmaier, “Development and validation of a GC/MS method for determination of phenolic xenoestrogens in aquatic samples,” Chemosphere, vol. 40, no. 9–11, pp. 929–935, 2000.
[15]
S. N. Pedersen and C. Lindholst, “Quantification of the xenoestrogens 4-tert.-octylphenol and bisphenol A in water and in fish tissue based on microwave assisted extraction, solid-phase extraction and liquid chromatography-mass spectrometry,” Journal of Chromatography A, vol. 864, no. 1, pp. 17–24, 1999.
[16]
H. G. J. Mol, S. Sunarto, and O. M. Steijger, “Determination of endocrine disruptors in water after derivatization with N-methyl-N-(tert-butyldimethyltrifluoroacetamide) using gas chromatography with mass spectrometric detection,” Journal of Chromatography A, vol. 879, no. 1, pp. 97–112, 2000.
[17]
M. Kawaguchi, Y. Hayatsu, H. Nakata et al., “Molecularly imprinted solid phase extraction using stable isotope labeled compounds as template and liquid chromatography-mass spectrometry for trace analysis of bisphenol A in water sample,” Analytica Chimica Acta, vol. 539, no. 1-2, pp. 83–89, 2005.
[18]
B. San Vicente, F. Navarro Villoslada, and M. C. Moreno-Bondi, “Continuous solid-phase extraction and preconcentration of bisphenol a in aqueous samples using molecularly imprinted columns,” Analytical and Bioanalytical Chemistry, vol. 380, no. 1, pp. 115–122, 2004.
[19]
A. Eiguren Fernández, Z. Sosa Ferrera, and J. J. Santana Rodríguez, “Application of cloud-point methodology to the determination of polychlorinated dibenzofurans in sea water by high-performance liquid chromatography,” Analyst, vol. 124, no. 4, pp. 487–491, 1999.
[20]
R. Carabias-Martinez, E. Rodriguez-Gonzalo, J. Dominguez-Alvarez, and J. Hernández-Méndez, “Cloud point extraction as a preconcentration step prior to capillary electrophoresis,” Analytical Chemistry, vol. 71, no. 13, pp. 2468–2474, 1999.
[21]
A. Saleh, Y. Yamini, M. Faraji, S. Shariati, and M. Rezaee, “Hollow fiber liquid phase microextraction followed by high performance liquid chromatography for determination of ultra-trace levels of Se(IV) after derivatization in urine, plasma and natural water samples,” Journal of Chromatography B, vol. 877, no. 18-19, pp. 1758–1764, 2009.
[22]
R. K. Roy, A Primer on Taguchi Method, Van Nostrand Reinhold, New York, NY, USA, 1990.
[23]
G. Zhu and H. Ju, “Determination of naproxen with solid substrate room temperature phosphorimetry based on an orthogonal array design,” Analytica Chimica Acta, vol. 506, no. 2, pp. 177–181, 2004.
[24]
S. C. Cunha, C. Almeida, E. Mendes, and J. O. Fernandes, “Simultaneous determination of bisphenol A and bisphenol B in beverages and powdered infant formula by dispersive liquid-liquid micro-extraction and heart-cutting multidimensional gas chromatography-mass spectrometry,” Food Additives and Contaminants Part A, vol. 28, no. 4, pp. 513–526, 2011.
[25]
M. Kawaguchi, K. Inoue, M. Yoshimura et al., “Determination of bisphenol A in river water and body fluid samples by stir bar sorptive extraction with in situ derivatization and thermal desorption-gas chromatography-mass spectrometry,” Journal of Chromatography B, vol. 805, no. 1, pp. 41–48, 2004.
[26]
L. Deng, Y. X. Liu, P. Y. Chen, L. Wang, and N. S. Deng, “Determination of trace bisphenol A in leachate by solid phase microextraction coupled with high performance liquid chromatography,” Analytical Letters, vol. 39, no. 2, pp. 395–404, 2006.
[27]
H. Ohkuma, K. Abe, M. Ito, A. Kokado, A. Kambegawa, and M. Maeda, “Development of a highly sensitive enzyme-linked immunosorbent assay for bisphenol A in serum,” Analyst, vol. 127, no. 1, pp. 93–97, 2002.
[28]
M. P. Zhao, Y. Z. Li, Z. Q. Guo, X. X. Zhang, and W. B. Chang, “A new competitive enzyme-linked immunosorbent assay (ELISA) for determination of estrogenic bisphenols,” Talanta, vol. 57, no. 6, pp. 1205–1210, 2002.
[29]
B. Delgado, V. Pino, J. H. Ayala, V. González, and A. M. Afonso, “Nonionic surfactant mixtures: a new cloud-point extraction approach for the determination of PAHs in seawater using HPLC with fluorimetric detection,” Analytica Chimica Acta, vol. 518, no. 1-2, pp. 165–172, 2004.
[30]
M. Ghambarian, Y. Yamini, A. Saleh, S. Shariati, and N. Yazdanfar, “Taguchi OA16 orthogonal array design for the optimization of cloud point extraction for selenium determination in environmental and biological samples by tungsten-modified tube electrothermal atomic absorption spectrometry,” Talanta, vol. 78, no. 3, pp. 970–976, 2009.
[31]
F. Shemirani, M. Baghdadi, M. Ramezani, and M. R. Jamali, “Determination of ultra trace amounts of bismuth in biological and water samples by electrothermal atomic absorption spectrometry (ET-AAS) after cloud point extraction,” Analytica Chimica Acta, vol. 534, no. 1, pp. 163–169, 2005.
[32]
R. Carabias-Martínez, E. Rodriguez-Gonzalo, B. Moreno-Cordero, J. L. Pérez-Pavón, C. Garcia-Pinto, and E. Fernandez Laespada, “Surfactant cloud point extraction and preconcentration of organic compounds prior to chromatography and capillary electrophoresis,” Journal of Chromatography A, vol. 902, no. 1, pp. 251–265, 2000.
[33]
B. Fr?schl, G. Stangl, and R. Niessner, “Combination of micellar extraction and GC-ECD for the determination of polychlorinated biphenyls (PCBs) in water,” Fresenius' Journal of Analytical Chemistry, vol. 357, no. 6, pp. 743–746, 1997.
[34]
R. P. Frankewich and W. L. Hinze, “Evaluation and optimization of the factors affecting nonionic surfactant-mediated phase separations,” Analytical Chemistry, vol. 66, no. 7, pp. 944–954, 1994.