Structured TiO2 nanotubes were grown on 2？mm thick titanium sheet by anodization of titanium in ethylene glycol medium containing 0.025？M NaF. The morphology of TiO2 nanotubes (TNT) was characterized using field emission scanning electron microscope. The potential of TNT as anode and also as photocatalyst for the degradation of tannic acid was studied. The mineralization of tannic acid was measured in terms Total Organic Carbon (TOC). Only 50% of TOC could be removed by exposing the tannic acid solution to UV-radiation (photolysis), whereas it was improved to 70% by electrooxidation (EO) using TNT as anode. Maximum degradation of 83% was achieved when electrooxidation was conducted under the influence of UV-radiation (photoelectrocatalytic process (PEC)). Among the electrolytes tried, Na2SO4 was observed to be very effective for the degradation of tannic acid. The kinetics of tannic acid degradation by photoelectrocatalytic process was found to follow zero-order rate expression. 1. Introduction Recent researchers have demonstrated the treatment of wastewater containing toxic and refractory organic pollutants by electrochemical and photocatalytic methods. The photocatalytic activity of TiO2 nanoparticles for the degradation of organics was found to be encouraging [1, 2]. The TiO2 nanoparticles were also tried in various applications like hydrogen sensors [3], solar cells [4], and biocompatible materials [5]. Because of superior photocatalytic activity, the TiO2 nanofilms were also attempted for the degradation of dyes, detergents, and organic acids [6]. Since the properties of the materials vary with their microstructure, the nanotubes are expected to perform much better than the commercially available TiO2 powders. Variety of techniques such as hydrothermal, template synthesis, magnetic sputtering, and sol-gel have been tried for the synthesis of nanoscaled TiO2 wires, dots, particulates, and tubes [7]. Preparation of titanium nanotubes (TNT) by chemical precursor route fails to control the thickness and shape of the nanotubes. On the other hand, precise control over the nanotube wall thickness could be achieved by template method. The potentiostatic anodization technique was found to yield highly ordered titanium nanotubes with uniform wall thickness. The shape, wall thickness, and length of the nanotubes are easily controlled by electrolyte and applied voltage. Albu et al. [8] modified the applied voltage to prepare new bamboo type titanium nanotubes and Ji et al. [9] used alternating voltage to produce double walled titanium nanotubes. Very recently,
References
[1]
S. P. Albu, A. Ghicov, J. M. Macak, R. Hahn, and P. Schmuki, “Self-organized, free-standing TiO2 nanotube membrane for flow-through photocatalytic applications,” Nano Letters, vol. 7, no. 5, pp. 1286–1289, 2007.
[2]
K. Shankar, G. K. Mor, H. E. Prakasam et al., “Highly-ordered TiO2 nanotube arrays up to 220 μm in length: use in water photoelectrolysis and dye-sensitized solar cells,” Nanotechnology, vol. 18, no. 6, Article ID 065707, 2007.
[3]
G. K. Mor, M. A. Carvalho, O. K. Varghese, M. V. Pishko, and C. A. Grimes, “A room-temperature TiO2-nanotube hydrogen sensor able to self-clean photoactively from environmental contamination,” Journal of Materials Research, vol. 19, no. 2, pp. 628–634, 2004.
[4]
M. Paulose, K. Shankar, O. K. Varghese, G. K. Mor, B. Hardin, and C. A. Grimes, “Backside illuminated dye-sensitized solar cells based on titania nanotube array electrodes,” Nanotechnology, vol. 17, no. 5, pp. 1446–1448, 2006.
[5]
D. Gong, C. A. Grimes, O. K. Varghese et al., “Titanium oxide nanotube arrays prepared by anodic oxidation,” Journal of Materials Research, vol. 16, no. 12, pp. 3331–3334, 2001.
[6]
X. Quan, S. Yang, X. Ruan, and H. Zhao, “Preparation of titania nanotubes and their environmental applications as electrode,” Environmental Science and Technology, vol. 39, no. 10, pp. 3770–3775, 2005.
[7]
Y. Liu, J. Li, B. Zhou et al., “Comparison of photoelectrochemical properties of TiO2-nanotube- array photoanode prepared by anodization in different electrolyte,” Environmental Chemistry Letters, vol. 7, no. 4, pp. 363–368, 2009.
[8]
S. P. Albu, D. Kim, and P. Schmuki, “Growth of aligned TiO2 bamboo-type nanotubes and highly ordered nanolace,” Angewandte Chemie, vol. 47, no. 10, pp. 1916–1919, 2008.
[9]
Y. Ji, K.-C. Lin, H. Zheng, J.-J. Zhu, and A. C. S. Samia, “Fabrication of double-walled TiO2 nanotubes with bamboo morphology via one-step alternating voltage anodization,” Electrochemistry Communications, vol. 13, no. 9, pp. 1013–1015, 2011.
[10]
J. Gong, C. Lin, M. Ye, and Y. Lai, “Enhanced photoelectrochemical activities of a nanocomposite film with a bamboo leaf-like structured TiO2 layer on TiO2 nanotube arrays,” Chemical Communications, vol. 47, no. 9, pp. 2598–2600, 2011.
[11]
B. Chen, K. Lu, and J. A. Geldmeier, “Highly ordered titania nanotube arrays with square, triangular, and sunflower structures,” Chemical Communications, vol. 47, no. 36, pp. 10085–10087, 2011.
[12]
M. Paulose, K. Shankar, S. Yoriya et al., “Anodic growth of highly ordered TiO2 nanotube arrays to 134 μm in length,” Journal of Physical Chemistry B, vol. 110, no. 33, pp. 16179–16184, 2006.
[13]
H. Xu, G. Vanamu, Z. Nie et al., “Photocatalytic oxidation of a volatile organic component of acetaldehyde using titanium oxide nanotubes,” Journal of Nanomaterials, vol. 2006, Article ID 78902, 8 pages, 2006.
[14]
M. Hosseini and M. Mohsen Momeni, “Preparation and characterization of TiO2 nanotubular arrays for electrooxidation of organic compounds: effect of immobilization of the noble metal particles,” International Journal of Modern Physics, vol. 5, pp. 41–48, 2012.
[15]
T. A. Egerton, M. Janus, and A. W. Morawski, “New TiO2/C sol-gel electrodes for photoelectrocatalytic degradation of sodium oxalate,” Chemosphere, vol. 63, no. 7, pp. 1203–1208, 2006.
[16]
H. Selcuk and M. Bekbolet, “Photocatalytic and photoelectrocatalytic humic acid removal and selectivity of TiO2 coated photoanode,” Chemosphere, vol. 73, no. 5, pp. 854–858, 2008.
[17]
Y. S. Sohn, Y. R. Smith, M. Misra, and V. (Ravi) Subramanian, “Electrochemically assisted photocatalytic degradation of methyl orange using anodized titanium dioxide nanotubes,” Applied Catalysis B, vol. 84, no. 3-4, pp. 372–378, 2008.
[18]
M. E. Osugi, M. V. B. Zanoni, C. R. Chenthamarakshan et al., “Toxicity assessment and degradation of disperse azo dyes by photoelectrocatalytic oxidation on ti/TiO2 nanotubular array electrodes,” Journal of Advanced Oxidation Technologies, vol. 11, no. 3, pp. 425–434, 2008.
[19]
J.-H. An and S. Dultz, “Adsorption of tannic acid on chitosan-montmorillonite as a function of pH and surface charge properties,” Applied Clay Science, vol. 36, no. 4, pp. 256–264, 2007.
[20]
J. Wang, A. Li, L. Xu, and Y. Zhou, “Adsorption of tannic and gallic acids on a new polymeric adsorbent and the effect of Cu(II) on their removal,” Journal of Hazardous Materials, vol. 169, no. 1–3, pp. 794–800, 2009.
[21]
Z. Varanka, I. Rojik, I. Varanka, J. Nemcsók, and M. ábrahám, “Biochemical and morphological changes in carp (Cyprinus carpio L.) liver following exposure to copper sulfate and tannic acid,” Comparative Biochemistry and Physiology C, vol. 128, no. 2, pp. 467–478, 2001.
[22]
B. O'Regan and M. Gr？tzel, “A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films,” Nature, vol. 353, no. 6346, pp. 737–740, 1991.
[23]
J. Wang and Z. Lin, “Freestanding TiO2 nanotube arrays with ultrahigh aspect ratio via electrochemical anodization,” Chemistry of Materials, vol. 20, no. 4, pp. 1257–1261, 2008.
[24]
M. V. B. Zanoni, J. J. Sene, H. Selcuk, and M. A. Anderson, “Photoelectrocatalytic production of active chlorine on nanocrystalline titanium dioxide thin-film electrodes,” Environmental Science and Technology, vol. 38, no. 11, pp. 3203–3208, 2004.
[25]
L. E. Fraga, M. A. Anderson, M. L. P. M. A. Beatriz, F. M. M. Paschoal, L. P. Rom？o, and M. V. B. Zanoni, “Evaluation of the photoelectrocatalytic method for oxidizing chloride and simultaneous removal of microcystin toxins in surface waters,” Electrochimica Acta, vol. 54, no. 7, pp. 2069–2076, 2009.
[26]
B. Marselli, J. Garcia-Gomez, P.-A. Michaud, M. A. Rodrigo, and C. Comninellis, “Electrogeneration of hydroxyl radicals on boron-doped diamond electrodes,” Journal of the Electrochemical Society, vol. 150, no. 3, pp. D79–D83, 2003.
[27]
M. Murugananthan, S. S. Latha, G. Bhaskar Raju, and S. Yoshihara, “Role of electrolyte on anodic mineralization of atenolol at boron doped diamond and Pt electrodes,” Separation and Purification Technology, vol. 79, no. 1, pp. 56–62, 2011.
[28]
S. Li, D. Bejan, M. S. McDowell, and N. J. Bunce, “Mixed first and zero order kinetics in the electrooxidation of sulfamethoxazole at a boron-doped diamond (BDD) anode,” Journal of Applied Electrochemistry, vol. 38, no. 2, pp. 151–159, 2008.
[29]
S. Yoshihara and M. Murugananthan, “Decomposition of various endocrine-disrupting chemicals at boron-doped diamond electrode,” Electrochimica Acta, vol. 54, no. 7, pp. 2031–2038, 2009.
[30]
L. Szpyrkowicz, C. Juzzolino, S. N. Kaul, S. Daniele, and M. D. de Faveri, “Electrochemical oxidation of dyeing baths bearing disperse dyes,” Industrial and Engineering Chemistry Research, vol. 39, no. 9, pp. 3241–3248, 2000.
[31]
S. K. Bhargava, J. Tardio, J. Prasad, K. F？ger, D. B. Akolekar, and S. C. Grocott, “Wet oxidation and catalytic wet oxidation,” Industrial and Engineering Chemistry Research, vol. 45, no. 4, pp. 1221–1258, 2006.
