In this work; resistive moisture sensors were obtained by dip coating sulfonated polycarbonate (SPC) onto silver interdigitated electrodes. Commercial polycarbonate was sulfonated with acetyl sulphate at two different sulfonation degrees corresponding to 9.0 and 18.0 mole %. Impedance spectroscopy was used to investigate the humidity sensing properties at controlled relative humidity (RH%) environments generated from standard saline solutions in the range of 11–90 RH%. For the highest sulfonated sample; in the RH% range investigated (11 to 90%); the sensor impedance changed from 4.7 MΩ to 18 kΩ. Humidity sensors made from sulfonated polycarbonate showed exponential decay behavior of the impedance at constant frequency with the environmental relative humidity. Sample 9SPC presented dielectric relaxation response for environmental humidity between 58 and 90 RH% while sample 18SPC presented dielectric relaxation response for the entire measured range between 11 and 90 RH%. Sulfonated polycarbonate could be a promising material for the fabrication of simple and cheap humidity-sensing sensors for the assessment of relative humidity of the surrounding environment, as suggested by experimental results.
Lv, X.; Li, Y.; Hong, L.; Luo, D.; Yang, M. A highly water-resistive humidity sensor based on silicon containing polyelectrolytes prepared by one-pot method. Sens. Actuators B 2007, 124, 347–351.
[3]
Dessler, A.E.; Sherwood, S.C. A matter of humidity. Science 2009, 323, 1020–1021.
[4]
Lee, C.Y.; Lee, G.B. Humidity sensors: A review. Sens. Lett. 2005, 3, 1–15.
[5]
Su, P.G.; Wang, C.S. In situ synthesized composite thin films of MWCNTs/PMMA doped with KOH as a resistive humidity sensor. Sens. Actuators B 2007, 124, 303–308.
[6]
Ahmad, Z.; Sayyad, M.H.; Saleem, M.; Karimov, K.S.; Shah, M. Humidity-dependent characteristics of methyl-red thin film-based Ag/methyl-red/Ag surface-type cell. Physica E 2008, 41, 18–22.
[7]
Rittersma, Z.M. Recent achievements in miniaturised humidity sensors—A review of transduction techniques. Sens. Actuators A 2002, 96, 196–210.
[8]
Matko, V.; Donlagic, D. Sensor for high-air-humidity measurement. IEEE Trans. Instrum. Meas. 1996, 45, 561–563.
[9]
Matko, V.; Koprivnikar, J. Quartz sensor for water absorption measurement in glass-fiber resins. IEEE Trans. Instrum. Meas. 1998, 47, 1159–1162.
[10]
Su, P.G.; Cherng Chen, I.; Wu, R.J. Use of poly(2-acrylamido-2-methylpropane sulfonate) modified with tetraethyl orthosilicate as sensing material for measurement of humidity. Anal. Chim. Acta 2001, 449, 103–109.
[11]
Karimov, K.S.; Qazi, I.; Khan, T.A.; Draper, P.H.; Khalid, F.A.; Mahroof-Tahir, M. Humidity and illumination organic semiconductor copper phthalocyanine sensor for environmental monitoring. Environ. Monit. Assess. 2008, 141, 323–328.
[12]
Sakai, Y.; Sadaoka, Y.; Matsuguchi, M. Humidity sensors based on polymer thin films. Sens. Actuators B 1996, 35, 85–90.
[13]
Li, Y.; Hong, L.; Yang, M. Crosslinked and quaternized poly(4-vinylpyridine)/polypyrrole composite as a potential candidate for the detection of low humidity. Talanta 2008, 75, 412–417.
[14]
Tanga, Q.Y.; Chana, Y.C.; Zhang, K. Fast response resistive humidity sensitivity of polyimide/multiwall carbon nanotube composite films. Sens. Actuators B 2011, 152, 99–106.
[15]
Rubinger, C.P.L.; Martins, C.R.; De Paoli, M.A.; Rubinger, R.M. Sulfonated polystyrene polymer humidity sensor: synthesis and characterization. Sens. Actuators B 2007, 123, 42–49.
[16]
Smitha, B.; Sridhar, S.; Khan, A.A. Synthesis and characterization of proton conducting polymer membranes for fuel cells. J. Membr. Sci. 2003, 225, 63–67.
[17]
Sridhar, S.; Aminabhavi, T.M.; Ramakrishna, M. Separation of binary mixtures of carbon dioxide and methane through sulfonated polycarbonate membranes. J. Appl. Polym. Sci. 2007, 105, 1749–1756.
[18]
Ghosh, A.K.; Ramachandhran, V.; Hanra, M.S. Synthesis, characterization and performance of sulfonated polycarbonate membranes. J. Polym. Mater. 1998, 15, 279–287.
[19]
Lee, W.J.; Kim, Y.J.; Jung, M.O.; Kim, D.H.; Cho, D.L.; Kaang, S. Preparation and properties of conducting polypyrrole sulfonated polycarbonate composites. Synth. Met. 2001, 123, 327–333.
[20]
Lee, W.J.; Kim, Y.J.; Kaang, S. Electrical properties of polyaniline/sulfonated polycarbonate blends. Synth. Met. 2000, 113, 237–243.
[21]
Masuelli, M.; Marchese, J.; Ochoa, N.A. SPC/PVDF membranes for emulsified oily wastewater treatment. J. Membrane Sci. 2009, 326, 688–693.
[22]
Casalbore-Miceli, G.; Camaioni, N.; Li, Y.; Martelli, A.; Yang, M.J.; Zanelli, A. Water sorption in polymer electrolytes: kinetics of the conductance variation. Sens. Actuators B 2005, 105, 351–359.
[23]
Sadaoka, Y.; Matsuguchi, M.; Sakai, Y.; Takahashi, K. Effects of sorbed water on the dielectric-constant of some cellulose thin-films. J. Mater. Sci. Lett. 1988, 7, 121–124.
[24]
Yang, M.J.; Li, Y.; Camaioni, N.; Casalbore-Miceli, G.; Martelli, A.; Ridolfi, G. Polymer electrolytes as humidity sensors: progress in improving an impedance device. Sens. Actuators B 2002, 86, 229–234.
[25]
Yang, M.J.; Sun, H.M.; Casalbore-Miceli, G.; Camaioni, N.; Mari, C.M. Poly(propargyl alcohol) doped with sulfuric acid, a new proton conductor usable for humidity sensor construction. Synth. Met. 1996, 81, 65–69.
[26]
Casalbore-Miceli, G.; Camaioni, N.; Yang, M.J.; Zhen, M.; Zhan, X.W.; D'Aprano, A. Charge transport mechanism in pressed pellets of polymer proton conductors. Solid State Ionics 1997, 100, 217–224.
[27]
Casalbore-Miceli, G.; Yang, M.J.; Camaioni, N.; Mari, C.M.; Li, Y.; Sun, H.; Ling, M. Investigations on the ion transport mechanism in conducting polymer films. Solid State Ionics 2000, 131, 311–321.
[28]
Lv, X.; Hong, L.J.; Li, Y.; Yang, M.J. Synthesis and humidity sensitive properties of pyrrole based polyelectrolytes. J. Appl. Polym. Sci. 2009, 112, 1287–1293.
