In battery applications, particularly in automobiles, submarines and remote communications, the state of charge (SoC) is needed in order to manage batteries efficiently. The most widely used physical parameter for this is electrolyte density. However, there is greater dependency between electrolyte viscosity and SoC than that seen for density and SoC. This paper presents a Quartz Crystal Microbalance (QCM) sensor for electrolyte density-viscosity product measurements in lead acid batteries. The sensor is calibrated in H2SO4 solutions in the battery electrolyte range to obtain sensitivity, noise and resolution. Also, real-time tests of charge and discharge are conducted placing the quartz crystal inside the battery. At the same time, the present theoretical “resolution limit” to measure the square root of the density-viscosity product ( ) of a liquid medium or best resolution achievable with a QCM oscillator is determined. Findings show that the resolution limit only depends on the characteristics of the liquid to be studied and not on frequency. The QCM resolution limit for？measurements worsens when the density-viscosity product of the liquid is increased, but it cannot be improved by elevating the work frequency.
References
[1]
Linden, D.; Reddy, T.B. Handbook of Batteries; McGraw Hill: New York, NY, USA, 2002.
Arnau, A. A review of interface electronic systems for at-cut quartz crystal microbalance applications in liquids. Sensors 2008, 8, 370–411.
[4]
Sauerbrey, K.G. Verwendung von Schwingquarzen zur W？gung dünner Schichten und zur Mikrow？gung. Z. Phys. 1959, 155, 206–222.
[5]
Kanazawa, K.K.; Gordon, J.G. Frequency of a quartz microbalance in contact with liquid. Anal. Chem. 1985, 57, 1770–1771.
[6]
Rodriguez-Pardo, L.; Fari？a, J.; Gabrielli, C.; Perrot, H.; Brendel, R. Design considerations of Miller oscillators for high-sensitivity QCM sensors in damping media. IEEE Trans. Ultrason. Ferroelectr. Freq. Control. 2007, 54, 1965–1976.
[7]
Rodriguez-Pardo, L.; Fari？a, J.; Gabrielli, C.; Perrot, H.; Brendel, R. TSM-AW sensors based on Miller XCOs for microgravimetric measurements in liquid media. IEEE Trans. Instrum. Meas. 2008, 57, 2309–2319.
[8]
Rodriguez-Pardo, L.; Fari？a, J.; Gabrielli, C.; Perrot, H.; Brendel, R. Resolution in quartz crystal oscillator circuits for high sensitivity microbalance sensors in damping media. Sens. Actuators B Chem. 2004, 103, 318–324.
[9]
IEEE Standard Definitions of Physical Quantities for Fundamental Frequency and Time Metrology—Random Instabilities. IEEE Standard 1139–1999. Available online: http://ieeexplore.ieee.org/servlet/opac?punumber=6545 (accessed on 31 July 2012).
[10]
Vig, J.R.; Walls, F.L. A Review of Sensor Sensitivity and Stability. Proceedings of the 2000 IEEE/EIA International Frequency Control Symposium and Exhibition, Kansas City, MO, USA, 9–10 June 2000; pp. 30–33.
[11]
Van Dyke, K.S. The piezo-electric resonator and its equivalent network. Proc. IRE 1928, 16, 742–764.
[12]
Martin, S.J.; Grandstaff, V.E.; Frye, G.C. Characterization of a quartz crystal microbalance with simultaneous mass and liquid loading. Anal. Chem. 1991, 63, 2272–2281.
[13]
Gagnepain, J.J. Nonlinear Properties of Quartz Crystal and Resonators: A Review. Proceedings of 35th Annual Frequency Control Symposium, Philadelphia, PA, USA, 27–29 May 1981; pp. 14–30.
[14]
Frerking, M.E. Crystal Oscillator Design and Temperature Compensation; Van Nostrand-Reinhold: Princeton, NJ, USA, 1978.
[15]
Perry, R.; Green, D.W. Perry's Chemical Engineers' Handbook; McGraw-Hill: New York, NY, USA, 1997.
[16]
Fasullo, O.T. Sulfuric Acid Use and Handling; McGraw-Hill: New York, NY, USA, 1965.
[17]
Bechmann, R. Frequency-Temperature-Angle characteristics of at-type resonators made of natural and synthetic quartz. Proc. IRE 1956, 44, 1600–1607.
[18]
Chi, A.R. Frequency Temperature Behavior of At-Cut Quartz Resonators. Proceedings of 10th Annual Frequency Control Symposium, Asbury Park, NJ, USA, 15–17 May 1956; pp. 46–59.
[19]
Sinha, B.K.; Tiersten, H.F. Temperature derivatives of the fundamental elastic constants of quartz. Appl. Phys. Lett. 1978, 71, 1625–1627.
[20]
Ballato, A.; Vig, J.R. Static and Dynamic Frequency-Temperature Behavior of Singly and Doubly Rotated, Oven-Controlled Quartz Resonators. Proceedings of 32nd Annual Frequency Control Symposium, Atlantic City, NJ, USA, 31 May–2 June 1978; pp. 180–188.
[21]
Frerking, M.E. Methods of Temperature Compensation. Proceedings of 36th Annual Frequency Control Symposium, Philadelphia, PA, USA, 2–4 June 1982; pp. 564–570.
[22]
Cao-Paz, A.M.; Marcos-Acevedo, J.; Del Río-Vázquez, A.; Martínez-Pe？alver, C.; Lago-Ferreiro, A.; Nogueiras-Meléndez, A.A.; Doval-Gandoy, J. A multi-point sensor based on optical fiber for the measurement of electrolyte density in lead-acid batteries. Sensors 2010, 10, 2587–2608.
