Based on the method of discrete phase, the law of droplets’ deposition in the last stage stationary blade of a supercritical 600 MW Steam Turbine is simulated in the first place of this paper by using the Wet-steam model in commercial software FLUENT, where the influence of inlet angle of water droplets of the stationary blades is also considered. Through the calculation, the relationship between the deposition and the diameter of water droplets is revealed. Then, the amount of droplets deposition in the suction and pressure surface is derived. The result is compared with experimental data and it proves that the numerical simulation result obtained in this paper is reasonable. Finally, a formula of the relationship between the diameter of water droplets and the inlet angle is fit, which could be used for approximate calculation in the engineering applications.
References
[1]
Z. P. Feng, L. Li and G. J. Li, “The Status and Progress of Numerical Study on Two-Phase Condensate Flows of Steam Turbine,” Shanghai, 2002, pp. 1-10.
[2]
Y. M. Hou, “Optimization Design of New Type Hollow Stationary Dehumidity Blade in the Last Stage of SC Steam Turbine,” Wuhan University, Wuhan, 2010.
[3]
M. J. Moore and C. H. Sieverding, “Low Pressure Turbine and the Condenser Aerothermodynamics,” Z. M. Weng, M. Z. Yu, D. J. Cheng and B. Liu Translate, Xi’an Jiaotong University Press, Xi’an, Vol. 66, 1992.
[4]
S. A. Slater, A. D. Lee Ming and J. B. Young, “Particle Deposition from Two Dimensional Turbulent Gas Flows,” International Journal of Multiphase Flow, Vol. 29, No. 5, 2003, pp. 721-750.
[5]
C. G. Li, X. J. Wang, et al., “Numerical Investigation of Movement and Deposition of Water Droplets on Steam Turbine Stationary Cascade,” Power Engineering, Vol. 42, No. 9, 2008, pp. 22-26.
[6]
Y. F. Zhao, Y. Z. Wang, Y. F. Liu and B. Sun, “Removal Method of Depositional Droplets and Energy Analysis in Hollow Cascade,” Power Engineering, Vol. 24, No. 3, 2004, pp. 515-519.
[7]
L. Li, Z. P. Feng and G. J. Li, “Numerical Simulation of Wet Steam Flow with Spontaneous Condensation in Turbine Cascade,” Journal of Engineering Thermophysics, Vol. 23, No. 3, 2002, pp. 309-311.
[8]
M. Z. Yu and Y. Huang, “Dewetting Method and Deposition Law of Steam Turbine at the Last Stage,” Turbine Technology, Vol. 5, 1988, pp. 44-50.
[9]
X. J. Wang, C. Lu, J. C. Liu, et al. “Slot Location of the Hollow Stationary Blade to Water Performance Test,” Engineering for Thermal Energy and Power, Vol. 22, No. 5, 2007, pp. 12-15.
[10]
S. Cai, D. M. Xie, et al. “Numerical Simulation of Suction Slot Structure on the LP Last Stage Stationary Blades of Steam Turbine,” Asia-Pacific Power and Energy Engineering Conference, Chengdu, 2010.
[11]
J Valha, “Liquid Phase Movement in the Last Stages of Large Condensing Steam Turbines,” Proceedings of the Institution of Mechanical Engineers, Conference Proceedings 1964-1970, Vol. 178-184.
