Purpose: Of this paper is to realize the casting of the clad strip by only one process. Therefore, the investigation of the ability of the casting of the clad strip by a vertical type twin roll caster was operated. The aim of the use of the twin roll caster to make clad strip was in the reduction of the production-energy of the clad strip.Design/methodology/approach: Used in the present study was a vertical type twin roll caster with the scriber. The scriber was used to prevent the mixture of the two kinds of the melts. The scriber was set at roll-bite, and the scriber contacted to the one of solidification layer. The melt was stopped by the scriber and the only the solidification layer was dragged by the roll.Findings: The clad strip with the clear interface could be by the vertical type twin roll caster with the scriber. The scriber was useful to drag only the solid and semisolid layer. The two kinds of strips were connected strictly at the interface of the clad strip. The clad strip was not broken at the interface by the continuous bending.Research limitations/implications: Are that 100 mm width-strip was cast in the present study. Ability of the clad strip that is wider than 100 mm was not clear. The control of the clad ratio was not investigated.Practical implications: The twin roll caster devised and investigated in this report is useful to cast clad strip like the brazing sheet for the radiator of the automobile.Originality/value: The vertical type twin roll cater to cast clad strip is original process. The scriber was used to prevent the mixture of the two kinds of melts. The scriber was not used in the previous research to cast clad strip at the twin roll caster, and use of the scriber was the first try.