Grundmeier G, Schmidt W, Stratmann M. Corrosion protection by organic coatings: electrochemical mechanism and novel methods of investigation [J]. Electrochim. Acta, 2000, 45: 2515
[2]
Doblhofer K, Armstrong R. Membrane-type coatings on electrodes [J]. Electrochim. Acta, 1988, 33: 453
[3]
Stratmann M, Streckel H. The Investigation of the corrosion of metal surfaces, covered with thin electrolyte layers--a new experimental technique [J]. Ber. Bunsenges. Phys. Chem., 1988, 92: 1244
[4]
Stratmann M, Leng A, Fürbeth W, et al. The scanning Kelvin probe; a new technique for the in situ analysis of the delamination of organic coatings [J]. Prog. Org. Coatings, 1996, 27: 261
[5]
Fürbeth W, Stratmann M. Scanning Kelvinprobe investigations on the delamination of polymeric coatings from metallic surfaces [J]. Prog. Org. Coatings, 2000, 39: 23
[6]
de la Fuente D, Chico B, Morcillo M. A SEM/XPS/SKP study on the distribution of chlorides in contaminated rusty steel [J]. Corros.Sci., 2006, 48: 2304
[7]
Nazarov A, Thierry D. Scanning Kelvin probe study of metal/polymer interfaces [J]. Electrochim. Acta, 2004, 49: 2955
[8]
Kelvin L. Contact electricity of metals [J]. Philos. Mag., 1898, 46: 82
[9]
Zisman W. A new method of measuring contact potential differences in metals [J]. Rev. Sci. Instr., 1932, 3: 367
[10]
Baikie I, Venderbosch E, Meyer J, et al. Analysis of stray capacitance in the Kelvin method [J]. Rev. Sci. Instr., 1991, 62: 725
[11]
Parsons R. Equilibrium properties of electrified interfaces [J]. Modern Aspects Electrochem., 1954, 1: 169
[12]
Green M. Solid State Surface Science [M]. New York: M. Dekker, 1969
[13]
Babai M, Tshernikovski N, Gileadi E. Double layer capacity measurement in dilute solution: a new technique [J]. J. Electrochem. Soc., 1972, 119: 1018
[14]
Besocke K, Berger S. Piezoelectric driven Kelvin probe for contact potential difference studies [J]. Rev. Sci. Instr., 1976, 47: 840
[15]
Baikie I, Petermann U, L?gel B. UHV-compatible spectroscopic scanning Kelvin probe for surface analysis [J]. Surf. Sci., 1999, 433: 249
[16]
Nonnenmacher M, Oboyle M, Wickramasinghe H. Kelvin probe force microscopy [J]. Appl. Phys. Lett., 1991, 58: 2921
[17]
Yasutake M, Aoki D, Fujihira M. Surface potential measurements using the Kelvin probe force microscope [J]. Thin Solid Films, 1996, 273: 279
[18]
Schmutz P, Frankel G. Characterization of AA2024-T3 by scanning Kelvin probe force microscopy [J]. J. Electrochem. Soc., 1998, 145: 2285
[19]
Bockris J O M, Reddy A K N. Modern electrochemistry [M]. New York: Plenum Publishing Corporation, 2000
[20]
Bockris J O M, Argade S. Work function of metals and the potential at which they have zero charge in contact with solutions [J]. J.Chem. Phys., 1968, 49: 5133
[21]
Hansen W, Kolb D. The work function of emersed electrodes [J]. J. Electroanal. Chem., 1979, 100: 493
[22]
Stratmann M. The investigation of the corrosion properties of metals, covered with adsorbed electrolyte layers-A new experimental technique [J]. Corros. Sci., 1987, 27: 869
[23]
J?nsson M, Thierry D, Lebozec N. The influence of microstructure on the corrosion behaviour of AZ91D studied by scanning Kelvin probe force microscopy and scanning Kelvin probe [J]. Corros. Sci., 2006, 48: 1193
[24]
Tahara A, Kodama T. Potential distribution measurement in galvanic corrosion of Zn/Fe couple by means of Kelvin probe [J]. Corros. Sci., 2000, 42: 655
[25]
Juzeliūnas E, Sudavi?ius A, Jüttner K, et al. Study of initial stages of Al-Mg alloy corrosion in water, chloride and Cu (II) environment by a scanning Kelvin probe and XPS [J]. Electrochem. Commun., 2003, 5: 154
[26]
Stratmann M, Streckel H, Kim K, et al. On the atmospheric corrosion of metals which are covered with thin electrolyte layers-III. The measurement of polarisation curves on metal surfaces which are covered by thin electrolyte layers [J]. Corros. Sci., 1990, 30: 715
