%0 Journal Article
%T Characterization of Minimum Impeller Speed for Suspension of Solids in Liquid at High Solid Concentration, Using Gamma-Ray Densitometry
%A Rouzbeh Jafari
%A Philippe A. Tanguy
%A Jamal Chaouki
%J International Journal of Chemical Engineering
%D 2012
%I Hindawi Publishing Corporation
%R 10.1155/2012/945314
%X The successful design and operation of Liquid-Solid (LS) and Gas-Liquid-Solid (GLS) stirred tank reactors requires an accurate determination of the level of solid suspension needed for the process at hand. A poor design of the stirred tank to achieve optimum conditions and maintain the system under these conditions during operation may cause significant drawbacks concerning product quality (selectivity and yield) and cost. In this paper, the limitations of applying conventional measurement techniques for the accurate characterization of critical impeller speed for just off-bottom suspension ( ) at high solid concentrations are described. Subsequently, the Gamma-Ray Densitometry technique for characterizing is introduced, which can overcome the limitations of previous experimental techniques. The theoretical concept of this method is explained, and experimental validation is presented to confirm the accuracy of the Gamma-Ray Densitometry technique. The effects of clearance, scale, and solid loading on for several impellers are discussed. Experimental values are compared with correlations proposed in the literatures, and modifications are made to improve the prediction. Finally, by utilizing the similarity to the incipient movement of solid particles in other systems, a theoretical model for prediction is presented. 1. Introduction Maximum solid-liquid contact is essential for the optimization of many chemical processes. Contact modes include solid dispersion, dissolution, leaching, crystallization, precipitation, adsorption, ion exchange, solid-catalyzed reaction, and suspension polymerization. In many processes (especially dissolution, leaching and solid-catalyzed reactions), the main objective of liquid-solid contacting is to maximize the surface area of the solid particles available for reaction or transport processes (heat and/or mass transfer). This can only be achieved by optimizing hydrodynamic conditions where solid particles move freely and do not accumulate at any point in the vessel. Under these conditions, the system can be described to be under ˇ°just off-bottom suspension or just-suspendedˇ± conditions. Inside a reaction vessel, solid particles in a liquid medium tend to settle towards the bottom as their density is usually higher than that of the liquid. In this scenario, an external force is necessary to lift the solids and retain them in a suspended state. Depending on the unit operation at hand, this force can be provided through various techniques such as agitation in stirred tanks or gas sparging in three-phase fluidized beds. The
%U http://www.hindawi.com/journals/ijce/2012/945314/