%0 Journal Article
%T 回转体倾斜入水空泡及弹道特性实验<br>Experiment of cavity and trajectory characteristics of oblique water entry of revolution bodies
%A 宋武超
%A 王聪
%A 魏英杰
%A 许昊
%J 北京航空航天大学学报
%D 2016
%R 10.13700/j.bh.1001-5965.2015.0690
%X 摘要 针对回转体低速倾斜入水过程空泡的生成机理和演化特性开展研究。通过不同入水速度和入水角度回转体倾斜入水对比实验，研究了入水速度和入水角度对入水空泡、回转体速度、俯仰角及阻力系数的影响规律。研究结果表明：空泡深闭合时刻的空泡长度、最大空泡直径和空泡闭合点深度随着回转体入水速度的增加而增大；空泡深闭合发生时间随着入水速度的增加而小幅增大；同一入水时刻回转体俯仰角和俯仰角速度均随入水速度的增加而减小；随着回转体入水角度的增加，同一时刻入水空泡直径和回转体速度逐渐减小，阻力系数逐渐增大。<br>Abstract：Studies of the oblique water entry of revolution bodies are conducted. By the experiment of revolution body velocity water entry with different velocities and angles, cavity evolution on revolution bodies is discussed, including formation, development and pinch-off of oblique entry. The influence of water entry velocity and angle on the cavities, revolution body velocity, pitching angle and drag coefficients was experimentally obtained. The experiments show that at the moment when the cavity is pinched off, the length and largest diameters of the cavity, and the depth of the closure point are larger as the velocity of revolution bodies increases. The cavity closure time increases slightly with the increase of revolution body velocity. When the velocity of revolution bodies is larger, the pitching angle and angle velocity are smaller. With the increase of water-entry angle of revolution bodies, the diameter of the cavity and the velocity of revolution bodies gradually become smaller, but the drag coefficients become larger.
%K 回转体
%K 运动参数
%K 倾斜入水
%K 入水空泡
%K 实验研究&lt
%K br&gt
%K revolution body
%K kinematical parameters
%K oblique water entry
%K water entry cavity
%K experiment study
%U http://bhxb.buaa.edu.cn/CN/abstract/abstract13923.shtml