%0 Journal Article %T 铝镇静钢LF低氟精炼渣系的脱硫实验研究
Experiment Study on Desulfurization of Low-Fluoride LF Refining Slag for Aluminum Killed Steel %A 徐昊 %A 王珏 %A 吴六顺 %A 董元篪 %J Metallurgical Engineering %P 42-48 %@ 2373-1486 %D 2015 %I Hans Publishing %R 10.12677/MEng.2015.21007 %X
本文采用CaO-Al2O3-SiO2-MgO-CaF2基础渣系,以Li2O替代CaF2,进行铝镇静钢LF脱硫实验。研究结果表明:渣中CaF2经Li2O替代后,在1500℃时,CaO (55.8%)-Al2O3 (20%)-SiO2 (11.2%)-MgO (10%)-Li2O (3%)渣的粘度低于0.3 Pa?s,渣的流动性能良好;温度1600℃、渣金比1:10时,该渣脱硫率77.14% (脱硫之前采用铝脱氧),钢水硫含量能降到0.008%。随着渣中Li2O含量的增加,脱硫率升高,最高可达80%。<br/>Desulfurization efficiency of CaO-Al2O3-SiO2-MgO-CaF2 slag for Al-killed steel was studied with Li2O replacing CaF2. Experimental results show that at 1500?C, the viscosity of CaO (55.8%)-Al2O3 (20%)-SiO2 (11.2%)-MgO (10%)-Li2O (3%) slag is lower than 0.3 Pa?s, having good flow properties; at 1600?C, under the condition of slag-metal ratio of 1:10, desulfurization rate of the slag can reach 77.14%, and sulfur content in steel decreases to 0.008%. Desulfurization rate can even reach to 80% with Li2O content increasing in slag after composition optimization.
%K LF精炼,脱硫,粘度,铝镇静钢,Li2O
LF Refining %K Desulphurization %K Viscosity %K Aluminum Killed Steel %K Li2O %U http://www.hanspub.org/journal/PaperInformation.aspx?PaperID=15003