%0 Journal Article
%T Processing of Intermetallic Titanium Aluminide Wires
%A Tom Marr
%A Jens Freudenberger
%A Alexander Kauffmann
%A Jan Romberg
%A Ilya Okulov
%A Romy Petters
%A Juliane Scharnweber
%A Andy Eschke
%A Carl-Georg Oertel
%A Uta Kščhn
%A Jščrgen Eckert
%A Werner Skrotzki
%A Ludwig Schultz
%J Metals
%D 2013
%I MDPI AG
%R 10.3390/met3020188
%X This study shows the possibility of processing titanium aluminide wires by cold deformation and annealing. An accumulative swaging and bundling technique is used to co-deform Ti and Al. Subsequently, a two step heat treatment is applied to form the desired intermetallics, which strongly depends on the ratio of Ti and Al in the final composite and therefore on the geometry of the starting composite. In a first step, the whole amount of Al is transformed to TiAl3 by Al diffusion into Ti. This involves the formation of 12% porosity. In a second step, the complete microstructure is transformed into the equilibrium state of -TiAl and TiAl3. Using this approach, it is possible to obtain various kinds of gradient materials, since there is an intrinsic concentration gradient installed due to the swaging and bundling technique, but the processing of pure -TiAl wires is possible as well.
%K Ti
%K Al
%K titanium aluminide
%K wire
%K phase reaction
%U http://www.mdpi.com/2075-4701/3/2/188