%0 Journal Article
%T Performance of Photovoltaic Modules of Different Solar Cells
%A Ankita Gaur
%A G. N. Tiwari
%J Journal of Solar Energy
%D 2013
%I 
%R 10.1155/2013/734581
%X In this paper, an attempt of performance evaluation of semitransparent and opaque photovoltaic (PV) modules of different generation solar cells, having the maximum efficiencies reported in the literature at standard test conditions (STC), has been carried out particularly for the months of January and June. The outdoor performance is also evaluated for the commercially available semitransparent and opaque PV modules. Annual electrical energy, capitalized cost, annualized uniform cost (unacost), and cost per unit electrical energy for both types of solar modules, namely, semitransparent and opaque have also been computed along with their characteristics curves. Semitransparent PV modules have shown higher efficiencies compared to the opaque ones. Calculations show that for the PV modules made in laboratory, CdTe exhibits the maximum annual electrical energy generation resulting into minimum cost per unit electrical energy, whereas a-Si/nc-Si possesses the maximum annual electrical energy generation giving minimum cost per unit electrical energy when commercially available solar modules are concerned. CIGS has shown the lowest capitalized cost over all other PV technologies. 1. Introduction According to the Annual Energy Review of US Energy Information Administration (EIA) in 2011, industrial, residential and commercial, transportation, and electric power generation are the primary sectors of energy consumption that account for, respectively, ~21%, 11%, 28%, and 40% of the total consumption. Petroleum (37%), natural gas (26%), coal (20%), renewable energy (9%), and nuclear electric power (8%) are the main sources being utilized to run the energy consumption sectors. The large percentage of energy is driven from the fossil fuels. In 2011, the US energy consumption accounted for ~2.84 ¡Á 1013£¿kWh, whereas the production was just only ~2.28 ¡Á 1013£¿kWh. And as per the Annual report of European Commission on Energy 2011, transport, industry, household, services, and agriculture account for, respectively, 32%, 25%, 27%, 14%, and 2% of total energy consumption. Petroleum accounts 35.1%, solid fuels account for, and 15.9%, renewable account for, 9.8%, nuclear power and natural gases account for, respectively, the 13.5% and 25.1% for fulfillment of the total energy requirement. Compared to 2009, the gross consumption increased by 3.3% in 2010. In the context of present energy crisis in terms of demand and supply and the bad consequences of fossil fuels on our delicate environment, the development and use of renewable sources of energy has become very important.
%U http://www.hindawi.com/journals/jse/2013/734581/