%0 Journal Article
%T Characteristics of Centrifugal Pumps Working in Direct or Reverse Mode: Focus on the Unsteady Radial Thrust
%A Anthony Couzinet
%A Laurent Gros
%A Daniel Pierrat
%J International Journal of Rotating Machinery
%D 2013
%I Hindawi Publishing Corporation
%R 10.1155/2013/279049
%X Experimental and numerical investigations have been carried out to study the behaviour of a centrifugal pump operating in direct mode or turbine mode. First of all, the complete characteristics (head, power, and efficiency) were measured experimentally using a specific test loop. The numerical data obtained from a CFD study performed with the ANSYS CFX software and based on steady state and unsteady approaches were compared to the experimental results. The representation in the 4 operating quadrants shows the various operating zones where the head is always positive. Then, the unsteady radial forces were analysed from transient computations. The results obtained for the pump operation are consistent with the literature and extended to the nonnormal operating conditions, namely, for very high flowrate values. The evolution of the radial load during turbine operation is presented for various partial flow operating points. 1. Introduction The hydraulic performances of centrifugal pumps were widely studied experimentally over the last century, for normal operating modes close to the nominal operating point. For specific states of flow, the unsteady behaviour of the flow due to the rotor/stator interactions formed the subject of many studies. The experimental study of these unsteady phenomena requires complex and/or expensive experimental methods [1¨C3] such as the use of dynamic pressure sensors or strain gauges installed on the pump shaft, and, as a result, the numerical approach becomes a real alternative. As a matter of fact, CFD computations have been commonly used for approximately twenty years to predict the hydraulic performance of rotating machines. First of all, CFD computations made it possible to study and improve the design of blades. For that purpose, the use of periodical conditions became a means to reduce the size of the computational domain as well as the CPU time. Furthermore, it was possible to use a steady state approach to study operating points located close to the best efficiency point. Then, to study the rotor/stator interactions, the complete geometry of the pump needs to be integrated into the numerical model; it is also necessary to simulate these flow configurations in a transient manner [1, 4] in order to correctly predict all potential hydrodynamic instabilities. Nevertheless, although many projects focus on rotor/stator interactions, very few of them propose comparisons between numerical and experimental results. The only existing results concern the fluctuating pressure field at impeller outlet [5]. Even if a few studies
%U http://www.hindawi.com/journals/ijrm/2013/279049/