%0 Journal Article
%T Optimization of Fusion Zone Grain Size, Hardness, and Ultimate Tensile Strength of Pulsed Current Microplasma Arc Welded AISI 304L Sheets Using Genetic Algorithm
%A Siva Prasad Kondapalli
%A Srinivasa Rao Chalamalasetti
%A Nageswara Rao Damera
%J International Journal of Manufacturing Engineering
%D 2014
%R 10.1155/2014/943643
%X Austenitic stainless steel sheets have gathered wide acceptance in the fabrication of components, which require high temperature resistance and corrosion resistance, such as metal bellows used in expansion joints in aircraft, aerospace, and petroleum industry. In case of single pass welding of thinner sections of this alloy, Pulsed Current Microplasma Arc Welding (PCMPAW) was found beneficial due to its advantages over the conventional continuous current process. The quality of welded joint depends on the grain size, hardness, and ultimate tensile strength, which have to be properly controlled and optimized to ensure better economy and desirable mechanical characteristics of the weld. This paper highlights the development of empirical mathematical equations using multiple regression analysis, correlating various process parameters to grain size, and ultimate tensile strength in PCMPAW of AISI 304L sheets. The experiments were conducted based on a five-factor, five-level central composite rotatable design matrix. A genetic algorithm (GA) was developed to optimize the process parameters for achieving the desired grain size, hardness, and ultimate tensile strength. 1. Introduction AISI 304L is an austenitic stainless steel with excellent strength and good ductility at high temperature. Typical applications include aeroengine hot section components, miscellaneous hardware, tooling, and liquid rocket components involving cryogenic temperature. AISI 304L can be joined using a variety of welding methods, including Gas Tungsten Arc Welding (GTAW), Plasma Arc Welding (PAW), Laser Beam Welding (LBW), and Electron Beam Welding (EBW). Of these methods, low current PAW (Micro-PAW) has attracted particular attention and has been used extensively for the fabrication of metal bellows, diaphragms which require high strength and toughness. PAW is conveniently carried out using one of two different current modes, namely, a continuous current (CC) mode or a pulsed current (PC) mode. Pulsed current MPAW involves cycling the welding current at selected regular frequency. The maximum current is selected to give adequate penetration and bead contour, while the minimum is set at a level sufficient to maintain a stable arc [1, 2]. This permits arc energy to be used effectively to fuse a spot of controlled dimensions in a short time producing the weld as a series of overlapping nuggets. By contrast, in constant to current welding, the heat required to melt the base material is supplied only during the peak current pulses allowing the heat to dissipate into the base material
%U http://www.hindawi.com/journals/ijme/2014/943643/