%0 Journal Article %T Magnetic Behavior of Sintered NdFeB Magnets on a Long-Term Timescale %A Minna Haavisto %A Sampo Tuominen %A Timo Santa-Nokki %A Harri Kankaanp£¿£¿ %A Martti Paju %A Pekka Ruuskanen %J Advances in Materials Science and Engineering %D 2014 %I Hindawi Publishing Corporation %R 10.1155/2014/760584 %X Stable polarization of permanent magnets over the lifetime of the application is an important aspect in electrical machine design. Specification of the long-term stability of magnet material is difficult, since knowledge of the phenomenon is incomplete. To be able to optimize magnet material selection, the long-term magnetic behavior of the material must also be understood. This study shows that material with a very square JH curve is stable until a certain critical operating temperature is reached. Major losses are detected as the critical temperature is exceeded. Material with a rounder JH curve does not show a well-defined critical temperature, but increasing losses over a large temperature range. The critical temperature of a material is also dependent on the field conditions. Results differ whether the tests are performed in an open or closed magnetic circuit. In open-circuit tests, the opposing field is not homogeneously distributed throughout the volume of the magnet and thus the long-term behavior is different than that in closed-circuit conditions. Open-circuit tests seem to give bigger losses than closed-circuit tests in cases where the permeance coefficient of the open-circuit sample is considered to be the average permeance coefficient, calculated according to the dimensions of the magnet. 1. Introduction During the last decade, the utilization of sintered NdFeB magnets in large motor and generator applications has become more common. The remanence of NdFeB material is superior in comparison to other types of magnet materials. The challenge is coercivity, which decreases rapidly as the temperature rises. Coercivity at elevated temperatures can be increased by partial substitution of Nd with Dy. Increasing Dy content, however, decreases the remanence and is therefore an unfavorable way of improving stability at elevated temperatures. In addition, dysprosium is not as abundant as neodymium in ores and thus it is much more expensive than Nd. A lot of effort has recently been put into development work for lower Dy content magnets with higher coercivities [1¨C3]. One way to avoid excess Dy additions in magnets is the optimization of the application by means of appropriate material selection. This requires, however, precise knowledge of the magnetic behavior of the materials concerned. FE-modeling is an efficient way of designing the application. The optimization of the magnetic circuit is thus much easier today than a few decades ago. Irreversible polarization losses occurring in magnets during the operation of machines are difficult to estimate, %U http://www.hindawi.com/journals/amse/2014/760584/