%0 Journal Article
%T Sinter-hardening of Ni-Mo pre-alloyed powders with tungsten addition
%A L.A. Dobrza¨½ski
%A J. Otr£¿ba
%A M. Actis Grande
%A M. Rosso
%J Journal of Achievements in Materials and Manufacturing Engineering
%D 2007
%I World Academy of Materials and Manufacturing Engineering
%X Purpose: Purpose of this paper was to present the benefits of powder metallurgy technology and development ofsinter-hardening process. The mechanical properties, focusing in particular on hardness and wear resistance, oftwo different carbon levels pre-alloyed steel powders processed with sinter-hardening method, were described.Microstructure characteristic of produced sinter-hardened Ni-Mo steels with increasing amount of tungsten(from 0 to 0.3% wt.) was taken under consideration.Design/methodology/approach: Different compositions have been tested in order to investigate the influenceof various tungsten additions into low (0.4%) and high (0.6%) carbon content of pre-alloyed steel powders.Powders, with addition of 0.7% lubricant, were pressed in a 2000kN hydraulic press. De-waxing process at550oC for 60 minutes in a fully nitrogen atmosphere was performed before the sintering. Sintering was carriedout in vacuum furnace with argon backfilling. The furnace was equipped with a cooling zone to provideaccelerated cooling from the sintering temperature. Green compacts were sintered at the temperature 1120oC for1 hour and rapidly cooled with a rate 2.5oC/s.Findings: The applied sinter-hardening process resulted with achievement of material characterized by goodwear resistance. The investigation of Ni-Mo and Ni-Mo-W sinter-hardened steels with low and high carboncontent proved that applied process of sintering under vacuum and rapid cooling brought expected outcome.Research limitations/implications: Considering the achieved outcome, it was revealed that chemical compositionand applied process of steels preparation, sinter-hardening with the cooling rate 2.5oC/s, results in achieving materialswith relatively high hardness and significant resistance to abrasion. Anyhow, further research should be performed.Originality/value: Sinter-hardening of Ni-Mo pre-alloyed powders with the addition of different additions oftungsten, especially in terms of hardenability and wear resistance, was investigated.
%K Powder metallurgy
%K Sintering
%K Low alloyed steels
%K Sinter-hardening
%U http://www.journalamme.org/papers_vol20/1388S.pdf