JCO means that the cross-section of steel pipe forms geometric shapes such as J, C and O in turn. The steel pipe blank directly formed by crimp JCO process has flat area along the edge of the pipe blank seam, which affects the quality of final pipe product. It is necessary to eliminate the flat area along the pipe seam by finishing process. In order to meet requirements of finishing process, it is necessary to optimize the roll surface curvature radius of finishing roll. Aiming at the design requirement of finishing roll for straight seam welded pipe forming, the optimum calculation method and result of roll surface curvature radius of finishing roll were obtained by using the theoretical analysis of metal sheet plastic forming. The result was successfully used in actual production.
Cite this paper
Liu, Q. and Wan, X. (2019). Design of Curvature Radius of Finishing Roll for Crimp JCO Formed Welded Pipe. Open Access Library Journal, 6, e5759. doi: http://dx.doi.org/10.4236/oalib.1105759.
Ying, G., Wang, L.J., Li, Q., et al. (2010) Die Parameter Optimization in JCO Bending Based on FEM, ICCET. 2nd International Conference on Computer Engineering and Technology, Chengdu, China, 16-18 April 2010. https://doi.org/10.1109/ICCET.2010.5485393
Liu, Q.C. and Chen, S.R. (2007) The Method of Deciding Mandril Diameter and Forming Gap for Coiled-Type JCOE Pipe. Forging & Stamping Technology, 32, 45-46.
Song, L., Yang, J. and Huang, T.Z. (1996) Analysis of Springback after Sheet Metal Bending and Summary of Engineering Control. Forging & Stamping Technology, 21, 18-22.
Liu, J.L., Xie, S.Q. and Ruan, F. (2005) Inverse Solution of Springback in Bending and Its Application to Optimal Design for Prebending UOE Pipe. Forging & Stamping Technology, 30, 36-37.
