Fire resistant geopolymers are developed and the performance under thermal loading is examined and compared in this paper. The geopolymers were prepared by mixing the solid phase, metallurgical slag and metakaolin
with a highly alkaline potassium hydroxide aqueous phase in order to create a
paste that was subsequently cured at 70℃ for a certain period of
time. The developed materials were tested for the mechanical, physical and
thermal properties. The behaviour of the geopolymers upon exposure on fire was studied following the EFNARC guidelines for testing
of passive fire protection for concrete tunnels linings. The geopolymers were subjected to the most
severe fire scenario, the Rijks Water Staat (RWS) temperature-time curve. Both geopolymers
appeared great behaviour after the test reaching temperature lower than the RWS
test requirement, proving the ability of both materials to work successfully as
an efficient thermal barrier. Thus, the concrete slab protected by the
geopolymers did not appear any form of spalling or degradation of its compressive strength.
Cite this paper
Sakkas, K. , Panias, D. , Nomikos, P. and Sofianos, A. (2017). Comparison of Fire Resistant Geopolymers for Passive Fire Protection of Concrete Tunnel Linings. Open Access Library Journal, 4, e3327. doi: http://dx.doi.org/10.4236/oalib.1103327.
Fletcher, I., Welch, S., Torero,
J., Carvel,
R. and
Usman
A. (2007) Behaviour
of Concrete Structures in Fires. Journal
of Thermal Science, 11, 37-52. https://doi.org/10.2298/TSCI0702037F
Sakkas,
K., Nomikos, P., Sofianos, A. and Panias,
D. (2013) Inorganic
Polymeric Materials for Passive Fire Protection of Underground Constructions. Journal of Fire and Materials, 37,
140-150. https://doi.org/10.1002/fam.2119
Edwards, W.T.
and Gamble,
W.L. (1986) Strength
of Grade 60 Reinforcing Bars after Exposure to Fire Temperatures. Journal of Concrete International, 8,
17-19.
National Codes and Standards Council of the Concrete and Masonry
Industries (1994) Assessing
the Condition and Repair Alternatives of fire Exposed Concrete and Masonry
Members. Fire Protection Planning Report, 14.
Van Deventer, J.G.S., Van Deventer, J.S.J. and Lukey, G.C. (2002) The
Effect of Composition and Temperature on the Properties of Fly Ash- and Kaolinite-Based
Geopolymers. Chemical Engineering Journal, 89,
63-73. https://doi.org/10.1016/S1385-8947(02)00025-6
Davidovits,
J. (1988) Geopolymer
Chemistry and Properties. Proceedings
of the 1st International Conference on Geopolymer’88, Compiegne, 1-3 June 1988,
25-48.
Cioffi, R., Maffucci, L. and Santoro,
L. (2003) Optimization
of Geopolymer Synthesis by Calcination and Polycondensation of a Kaolinitic
Residue. Journal Resource, Conservation
and Recycling, 40,
27-38. https://doi.org/10.1016/S0921-3449(03)00023-5
Xu,
H. and Van Deventer, J. S. J. (2000) The
Geopolymerisation of Alumino-Silicate Minerals. International Journal of Mineral Processing, 59, 247-266. https://doi.org/10.1016/S0301-7516(99)00074-5
Wang, H., Li, H. and Yan, F.
(2005) Synthesis
and Mechanical Properties of Metakaolinite-Based Geopolymer. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 268, 1-6. https://doi.org/10.1016/j.colsurfa.2005.01.016
Swanepoel, J.C. and Strydom, C.A.
(2002) Utilisation
of Fly Ash in a Geopolymeric Material. Journal of Applied Geochemistry, 17, 1143-1148. https://doi.org/10.1016/S0883-2927(02)00005-7
Wu, H.C.
and Sun, P.
(2007) New
Construction Material from Fly Ash Based Lightweight Inorganic Polymer. Journal of Construction and Building
Materials, 21, 211-217. https://doi.org/10.1016/j.conbuildmat.2005.06.052
Panias, D., Giannopoulou, I.
and Perraki, T.
(2007) Effect
of Synthesis Parameters on the Mechanical Properties of Fly Ash-Based
Geopolymers. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 301, 246-254. https://doi.org/10.1016/j.colsurfa.2006.12.064
Bakharev, T.
(2005) Geopolymeric Materials Prepared Using Class F Fly Ash and Elevated
Temperature Curing. Cement and Concrete
Research, 35, 1224-1232. https://doi.org/10.1016/j.cemconres.2004.06.031
Maragkos, I., Giannopoulou, I.
and Panias, D.
(2008) Synthesis
of Ferronickel Slag- Based
Geopolymers. Journal of Minerals
Engineering, 22, 196-203. https://doi.org/10.1016/j.mineng.2008.07.003
Giannopoulou, I., Dimas, D., Maragkos, I.
and Panias, D.
(2009) Utilization
of Solid By-Products for the Development of Inorganic Polymeric Construction
Materials. Global NEST Journal, 11, 127-136.