oalib

Publish in OALib Journal

ISSN: 2333-9721

APC: Only $99

Submit

Any time

2019 ( 192 )

2018 ( 274 )

2017 ( 292 )

2016 ( 458 )

Custom range...

Search Results: 1 - 10 of 223792 matches for " R; "
All listed articles are free for downloading (OA Articles)
Page 1 /223792
Display every page Item
Power Aware Routing Protocol (PARP) for Wireless Sensor Networks  [PDF]
R. Prema, R. Rangarajan
Wireless Sensor Network (WSN) , 2012, DOI: 10.4236/wsn.2012.45019
Abstract: Several wireless sensor network applications ought to decide the intrinsic variance between energy efficient communication and the requirement to attain preferred quality of service (QoS) such as packet delivery ratio, delay and to reduce the power consumption of wireless sensor nodes. In order to address this challenge, we propose the Power Aware Routing Protocol (PARP), which attains application-specified communication delays at low energy cost by dynamically adapting transmission power and routing decisions. Extensive simulation results prove that the proposed PARP attains better QoS and reduced power consumption.
An Innovative Low Cost EM Pollution Measurement System  [PDF]
R. Sittalatchoumy, R. Seetharaman
Circuits and Systems (CS) , 2016, DOI: 10.4236/cs.2016.78176
Abstract: Mobile phones and other electronic devices are emitting radiations that will provide harmful effects to the human health. In order to measure the radiation, an innovative low cost measurement system is proposed in this paper. The ideology is to simplify the circuit’s value by converting a voltage detecting circuit to a field detecting circuit by finding an optimum resistance on trial and error basis. The requirement for a trial and error technique is to not allow too high or too low resistance which can be either short or open, resulting provides more damage to the circuit.
Ant Lion Optimization Approach for Load Frequency Control of Multi-Area Interconnected Power Systems  [PDF]
R. Satheeshkumar, R. Shivakumar
Circuits and Systems (CS) , 2016, DOI: 10.4236/cs.2016.79206
Abstract: This work proposes a novel nature-inspired algorithm called Ant Lion Optimizer (ALO). The ALO algorithm mimics the search mechanism of antlions in nature. A time domain based objective function is established to tune the parameters of the PI controller based LFC, which is solved by the proposed ALO algorithm to reach the most convenient solutions. A three-area interconnected power system is investigated as a test system under various loading conditions to confirm the effectiveness of the suggested algorithm. Simulation results are given to show the enhanced performance of the developed ALO algorithm based controllers in comparison with Genetic Algorithm (GA), Particle Swarm Optimization (PSO), Bat Algorithm (BAT) and conventional PI controller. These results represent that the proposed BAT algorithm tuned PI controller offers better performance over other soft computing algorithms in conditions of settling times and several performance indices.
Obtaining Optimal Solution by Using Very Good Non-Basic Feasible Solution of the Transportation and Linear Programming Problem  [PDF]
R. R. K. Sharma
American Journal of Operations Research (AJOR) , 2017, DOI: 10.4236/ajor.2017.75021
Abstract: For the transportation problem, Sharma and Sharma [1] have given a very computationally efficient heuristic (runs in O(c*n2) time) to give very good dual solution to transportation problem. Sharma and Prasad [2] have given an efficient heuristic (complexity O(n3) procedure to give a very good primal solution (that is generally non-basic feasible solution) to transportation problem by using the very good dual solution given by Sharma and Sharma [2]. In this paper we use the solution given by Sharma and Prasad [2] to get a very good Basic Feasible Solution to transportation problem, so that network simplex (worst case complexity (O(n3*(log(n))) can be used to reach the optimal solution to transportation problem. In the second part of this paper, we give a simple heuristic procedure to get a very good BFS to linear programming problem from the solution given by Karmarkar [3] (that generally produces a very good non-basic feasible solution in polynomial time (O(n5.5)). We give a procedure to obtain a good BFS for LP by starting from the solution given by Karmarkar [3]. We note that this procedure (given here) is significantly different from the procedure given in [4].
Power Analysis of Sensor Node Using Simulation Tool  [PDF]
R. Sittalatchoumy, R. Kanthavel, R. Seetharaman
Circuits and Systems (CS) , 2016, DOI: 10.4236/cs.2016.713348
Abstract: Power consumption of sensor node is analyzed in this paper. In order to analyze the energy consumption, the node model is simulated using Proteus Software tool. The proposed sensor nodes power characteristics are measured by using different combinations of microprocessors and sensors. Using this, the energy consumption of the node is calculated. This is a cost-effective method and provides appropriate power model for specific applications.
Studies on Dissolution Behaviour of Nanoparticulate Curcumin Formulation  [PDF]
R. Ravichandran
Advances in Nanoparticles (ANP) , 2013, DOI: 10.4236/anp.2013.21010
Abstract:

Curcumin is the main biologically active phytochemical compound of turmeric that has been widely used by ancient cultures throughout Asia. However the dissolution rate limited absorption and pre-absorption degradation limits its use as a potential therapeutic. In this study an attempt has been made to overcome the above limitations by curcumin delivery through nanotechnology. Nanocurcumin solid dosage formulations were prepared and studied for its dissolution behaviour. Considerable improvement in the dissolution behavior was observed in the drug nanocrystal-loaded solid dosage forms. This is expected to enhance the bioavailability of poorly soluble medicinal herbs such as turmeric in the body.

Pharmacokinetic Study of Nanoparticulate Curcumin: Oral Formulation for Enhanced Bioavailability  [PDF]
R. Ravichandran
Journal of Biomaterials and Nanobiotechnology (JBNB) , 2013, DOI: 10.4236/jbnb.2013.43037
Abstract:

Curcumin, a bioactive component of turmeric, which is a commonly used spice and nutritional supplement, is isolated from the rhizomes of Curcuma longa Linn. (Zingiberaceae). In recent years, the potential pharmacological actions of Curcumin in inflammatory disorders, cardiovascular disease, cancer, Alzheimer’s disease and neurological disorders have been shown. However, the clinical application of Curcumin is severely limited by its main drawbacks such as instability, low solubility, poor bioavailability and rapid metabolism. Multifarious nanotechnology-based drug delivery systems for Curcumin including liposomes, polymeric nanoparticles, solid lipid nanoparticles, micelles, nanogels, nanoemulsions, complexes and dendrimer/dimer, have been attempted to enhance the oral bioavailability, biological activity or tissue-targeting ability of Curcumin. We attempted the nanosuspensions based delivery of curcumin. Nanonisation renders curcumin completely dispersible in aqueous media. To enhance the curcumin absorption by oral administration, nanoparticulate solid oral formulation of curcumin was prepared by us and the resulting capsule was then examined for its efficiency on bioavailability in Male Wistar rats at a dose of 100 mg curcumin/kg body weight and the pharmacokinetic parameters were compared to those of normal curcumin powder and a commercial curcumin capsule CUR-500. The bio-distribution of curcumin in organs of rat was also studied. Nanoparticulation significantly raised the curcumin concentration in selective organs in the body. The results obtained provide promising results for nanoparticulate Curcumin to improve its biological activities. Enhanced bioavailability of curcumin in the form of nanoparticle is likely to bring this promising natural product to the forefront of therapeutic agents for treatment of human disease. The available information also strongly suggests that nano-formulation of ingredients such as curcumin may be used as a novel nutrient delivery system too.

The Arithmetic Mean Standard Deviation Distribution: A Geometrical Framework  [PDF]
R. Caimmi
Applied Mathematics (AM) , 2013, DOI: 10.4236/am.2013.411A4001
Abstract:

The current attempt is aimed to outline the geometrical framework of a well known statistical problem, concerning the explicit expression of the arithmetic mean standard deviation distribution. To this respect, after a short exposition, three steps are performed as 1) formulation of the arithmetic mean standard deviation, \"\", as a function of the errors, \"\", which, by themselves, are statistically independent; 2) formulation of the arithmetic mean standard deviation distribution, \"\", as a function of the errors, \"\"; 3) formulation of the arithmetic mean standard deviation distribution, \"\", as a function of the arithmetic mean standard deviation, \"\", and the arithmetic mean rms error, \"\". The integration domain can be expressed in canonical form after a change of reference frame in the n-space, which is recognized as an infinitely thin n-cylindrical corona where the symmetry axis coincides with a coordinate axis. Finally, the solution is presented and a number of (well known) related parameters are inferred for sake of completeness.

Optimized Parameter Combinations of Hydraulic Damper Modules  [PDF]
R. Sonnenburg
Journal of Transportation Technologies (JTTs) , 2014, DOI: 10.4236/jtts.2014.43025
Abstract:

This paper is devoted to the problem of finding optimized parameter combinations of automotive damper modules. Different cost functions using the amplitude spectrum of the excitation and the frequency response function of the car model will be investigated and it is shown that for three different arbitrary road excitations there exists a parameter combination of top mount stiffness, piston rod mass and damping constant that provides an optimum for the dynamic wheel load fluctuation. The achieved advantage of the optimized damper module regarding the dynamic wheel load fluctuation compared to a simple damper in a two mass vibration system can reach up to 20 percent.

CSA Discounting: Impacts on Pricing and Risk of Commodity Derivatives  [PDF]
R. Abbate
Journal of Financial Risk Management (JFRM) , 2014, DOI: 10.4236/jfrm.2014.33011
Abstract: The global financial crisis of 2007-2008 caused market practitioners to reassess the way in which financial derivative contracts had been priced during the preceding thirty years. The purpose of this paper is to examine the evolving practice of pricing and hedging commodity derivative contracts according to the terms of the Credit Support Annex (CSA). Using a series of case studies, we price crude oil swaps and Asian options in the pre-crisis, peak-crisis, post-crisis and recent market environments under two different frameworks: LIBOR discounting and CSA discounting (also referred to in a less general form as “OIS discounting”, which incorporates nearly risk-free interest rates). We also compute the widely used first-order and second-order Greek sensitivities. In each market environment, we shift the forward prices and implied volatilities crude oil and re-compute the trades’ valuation and Greek sensitivities at each incremental increase or decrease in price or implied volatility. Under each discounting framework, we quantify the change in trade valuation and Greek sensitivities that results from switching from LIBOR discounting to CSA discounting. The impact on the valuation and Greek sensitivities of a swap and an Asian option as the result of adopting CSA discounting can be significant under certain market conditions. There is likely to be larger impact on directional portfolios containing transactions that hedge either consumption or production (e.g. end users). Ceteris paribus, the impact on portfolio valuation and risk is likely to be limited for market participants (e.g. banks) with hedged portfolios that contain a large number of offsetting positions. Even though we focus our analysis on crude oil derivative contracts, the results easily extend to other asset classes such as natural gas, refined products, agriculture, metals, etc.
Page 1 /223792
Display every page Item


Home
Copyright © 2008-2017 Open Access Library. All rights reserved.