oalib

Publish in OALib Journal

ISSN: 2333-9721

APC: Only $99

Submit

Any time

2019 ( 111 )

2018 ( 696 )

2017 ( 684 )

2016 ( 960 )

Custom range...

Search Results: 1 - 10 of 400729 matches for " M. Duhovic "
All listed articles are free for downloading (OA Articles)
Page 1 /400729
Display every page Item
Out of Plane Thermal Conductivity of Carbon Fiber Reinforced Composite Filled with Diamond Powder  [PDF]
M. Srinivasan, P. Maettig, K. W. Glitza, B. Sanny, A. Schumacher, M. Duhovic, J. Schuster
Open Journal of Composite Materials (OJCM) , 2016, DOI: 10.4236/ojcm.2016.62005
Abstract: Highly conductive fillers have a strong influence on improving the poor out of plane thermal conductivity of carbon fiber reinforced composites. The objective of this study has been to investigate the role of the diamond powder (DP) in enhancing the out-of-plane thermal conductivity of the woven composites. Samples of the standard modulus T300 carbon fiber composite with 44% and 55% fiber volume fraction and the high modulus YS90A carbon fiber composite with 50% volume fraction were fabricated with their matrices comprising of neat epoxy and different loading of diamond powder within epoxy resin. Steady state thermal conductivity measurements were carried out and it was found from the measurements that the out of plane thermal conductivity of the standard modulus composite increased by a factor of 2.3 with 14% volume fraction of diamond powder in the composite while the out of plane thermal conductivity of the high modulus composite increased by a factor of 2.8 with 12% volume fraction of diamond powder in the composite. Finite Element Modeling (FEM) with the incorporation of microstructural characteristics is presented and good consistency between the measurements and FEM results were observed.
Validation of Numerical Modeling for the Prediction of Elastic and Failure Behavior of Diamond Powder Filled Woven Composites  [PDF]
M. Srinivasan, P. Maettig, K. W. Glitza, B. Sanny, A. Schumacher, M. Duhovic
Open Journal of Composite Materials (OJCM) , 2017, DOI: 10.4236/ojcm.2017.72004
Abstract: A numerical investigation was carried out to examine the role of micro-sized diamond powder filler on the on-axis tensile stiffness properties of the standard modulus T300 and the high modulus YS90A woven fabric composite plates by progressive damage modeling. Finite element modeling (FEM) results for the T300 composite with and without diamond powder predicted a specific case of fiber failure in all the plies showing the characteristics of brittle failure. Static tensile tests were carried out on the YS90A composite coupons containing no diamond powder (DP) and filled with 6% and 12% volume fractions of DP. A higher content of diamond powder in the coupons led to agglomeration. This induced stress concentrations and subsequently reduced the mechanical properties. FEM was carried out considering specimens with and without an induced stress concentration geometry in the YS90A coupons filled with DP. The results of the on-axis tensile tests indicated a delamination type of failure in both cases with additional fiber fracture in the Open Hole Tensile (OHT) coupons.
Study of Duct Characteristics Deduced from Low Latitude Ground Observations of Day-Time Whistler at Jammu  [PDF]
M. Altaf, M. M. Ahmad
International Journal of Astronomy and Astrophysics (IJAA) , 2013, DOI: 10.4236/ijaa.2013.33032
Abstract:

Propagation characteristics of low latitude whistler duct characteristics have been investigated based on day-time measurements at Jammu. The morphogical characteristics of low latitude whistlers are discussed and compared with characteristics of middle and high latitude whistlers. The Max. electron density (Nm) at the height of the ionosphere obtained from whistler dispersion comes out to be higher than that of the background which is in accordance with the characteristics of whistler duct. The equivalent width is found to be close to the satellite observations and the characteristics of whistler duct in low latitude ionosphere are similar to those in middle and high latitude ionosphere. The width of ducts estimated from the diffuseness of the whistler track observed during magnetic storm is found to lie in the range of 50 - 200 Km.

Review Article: Immobilized Molecules Using Biomaterials and Nanobiotechnology  [PDF]
Magdy M. M. Elnashar
Journal of Biomaterials and Nanobiotechnology (JBNB) , 2010, DOI: 10.4236/jbnb.2010.11008
Abstract: Immobilized molecules using biomaterials and nanobiotechnology is a very interesting topic that touching almost all aspects of our life. It uses the sciences of biology, chemistry, physics, materials engineering and computer science to develop instruments and products that are at the cutting edge of some of today’s most promising scientific frontiers. In this review article, the author based on his experience in this arena has tried to focus on some of the supports for im-mobilization; the most important molecules to be immobilized such as DNA, cells, enzymes, metals, polysaccharides, etc and their applications in medicine, food, drug, water treatment, energy and even in aerospace. He specified a special section on what is new in the arena of supports and technologies used in enzyme immobilization and finally a recommendation by the author for future work with a special attention to up-to-date references.
Using of the generalized special relativity (GSR) in estimating the neutrino masses to explain the conversion of electron neutrinos  [PDF]
M. H. M. Hilo
Natural Science (NS) , 2011, DOI: 10.4236/ns.2011.34044
Abstract: In this work the Generalized Special Relativity (GSR) is utilized to estimate masses of some elementary particles such as, neutrinos. These results are found to be in conformity with experimental and theoretical data. The results obtained may explain some physical phenomena, such as, conversion of neutrinos from type to type when solar neutrino reaches the Earth.
Postischemic Lower Extremity Wounds Treated with and without Negative Pressure Dressing  [PDF]
Naz?mmü?
Surgical Science (SS) , 2012, DOI: 10.4236/ss.2012.37075
Abstract: Background: Vacuum-assisted dressing is a noninvasive closure system of the wound, which makes localized and controlled negative pressure. Its mechanical tension reduces edema, stimulates granulation tissue formation and angiogenesis, and prepares the wound bed for closure. In this study, a patient has been presented, who suffered from serious lower extremity wounds due to arterial emboli, one of her wounds has been treated with vacuum-assisted dressing and the other with conventional dressing to evaluate the efficacy of vacuum-assisted dressing in acute ischemic wounds. Methods: A 65-year-old female patient was admitted to the emergency clinic, due to complaint of severe pain in her right lower extremity which suggested an acute arterial occlusion. She immediately underwent an embolectomy operation; however, a few days later, severe ischemia on the leg and foot became appearant. All of the necrosis was sharply debrided under sterile conditions in the operating room, and then lower leg wound was covered with vacuum-assisted dressing, also calcaneal wound was dressed with silver sulphadiazine. Results: Eighteen days after the first dressing with negative pressure, distal leg wound became ready for closure, whereas, enough granulation tissue over the calcaneal area developed merely thirty-four days later. Calcaneal wound closed spontaneously within fifty-three days. Conclusions: When dealing with this experience, using the negative pressure dressing in patient with severe lower limb wounds following arterial emboli, accelerates wound healing by means of developing the granulation tissue, and rapidly prepares the wound for closure, so it may reduce the risk of amputation.
Laplace Transform Method for Unsteady Thin Film Flow of a Second Grade Fluid through a Porous Medium  [PDF]
M. Ali, M. Awais
Journal of Modern Physics (JMP) , 2014, DOI: 10.4236/jmp.2014.53017
Abstract:

In this article, we have effectively used the Numerical Inversion of Laplace transform to study the time-dependent thin film flow of a second grade fluid flowing down an inclined plane through a porous medium. The solution to the governing equation is obtained by using the standard Laplace transform. However, to transform the obtained solutions from Laplace space back to the original space, we have used the Numerical Inversion of Laplace transform. Graphical results have been presented to show the effects of different parameters involved and to show how the fluid flow evolves with time.

An Integral Collocation Approach Based on Legendre Polynomials for Solving Riccati, Logistic and Delay Differential Equations  [PDF]
M. M. Khader, A. M. S. Mahdy, M. M. Shehata
Applied Mathematics (AM) , 2014, DOI: 10.4236/am.2014.515228
Abstract:

In this paper, we propose and analyze some schemes of the integral collocation formulation based on Legendre polynomials. We implement these formulae to solve numerically Riccati, Logistic and delay differential equations with variable coefficients. The properties of the Legendre polynomials are used to reduce the proposed problems to the solution of non-linear system of algebraic equations using Newton iteration method. We give numerical results to satisfy the accuracy and the applicability of the proposed schemes.

ДОСЛ ДЖЕННЯ АНАЛ ТИЧНОГО МЕТОДУ ОЦ НЮВАННЯ ЙМОВ РНОСТ ПОТЕНЦ ЙНО КОНФЛ КТНИХ СИТУАЦ Й В ПОВ ТРЯНОМУ РУС The study of the analytical method of evaluating the probability of potential conflict situations in air traffic Исследование аналитического метода оценки вероятности потенциально конфликтных ситуаций в воздушном движении
В.M. Василь?в
Proceedings of National Aviation University , 2007,
Abstract: Розглянуто застосування запропонованого ран ше методу оц нювання ймов рност потенц йних конфл кт в для системи керування пов тряним рухом. Досл джено властивост методу, наведено проанал зовано результати комп’ютерного моделювання. Application of the method of potential conflicts probability evaluation offered before for air traffic control system is considered. The properties of the method are investigated, results of computer modeling are represented and analyzed. Рассмотрено применение предложенного ранее метода оценки вероятности потенциальных конфликтов для системы управления воздушным движением. Исследованы свойства метода, приведены и проанализированы результаты компьютерного моделирования.
МОДЕЛЮВАННЯ ТА УПРАВЛ ННЯ В БРОАКУСТИЧНИМ ВИПРОМ НЮВАННЯМ ОДНОР ДНО ПЛАСТИНИ П Д Д Ю ЗОВН ШН Х КОНЦЕНТРОВАНИХ СИЛ Modeling and management vibroacoustic emission homogeneous plate under the action of external forces concentrated Моделирование и управление виброакустическим излучением однородной пла
В.M. Макаренко
Proceedings of National Aviation University , 2009,
Abstract: Подано модель проведено досл дження акустичного випром нювання та поперечного руху прямокутно пластини. Розв’язок отримано на основ р внянь класично теор коливань пластини. Розглянуто в броакустичне випром нювання пластин з в льно обпертими граничними умовами. Як зовн шн збудження використано концентрован гармон чн сили. Встановлено законом рност зм ни звукового випром нювання залежно в д параметр в зовн шн х збуджень. Для перев рки анал тичого п дходу, використаного для розрахунк в, виконано експеримент. Власн частоти коливань в льно пластини, отриман анал тично, сп вв дносяться з результатами експерименту з малою похибкою. The model of rectangular plate acoustic radiation and transverse motion were presented, and its investigation was performed. The solution is received based on classisal plate theory. Vibration response and sound radiation of plates with simply-supported boundary conditions was discussed. Concentrated harmonic forces are used as an external excitation. The general confirmities to the law have been established for the changes of sound radiation, depending on the parameters of external excitations. An experiment was performed for justification of analytical approach, which is used for computations. Eigenfrequencies of free plate oscillations, which are received analytically, are in good agreement with experimental results. Представлены модель и проведены исследования акустического излучения и поперечного движения прямоугольной пластины. Решен
Page 1 /400729
Display every page Item


Home
Copyright © 2008-2017 Open Access Library. All rights reserved.